Hydrophilic–lipophilic balanced magnetic nanoparticles: Preparation and application in magnetic solid-phase extraction of organochlorine pesticides and triazine herbicides in environmental water samples

Preparation of magnetic amphiphilic resin microspheres via the one-step polymerization method and extraction of four glucocorticoids for HPLC-MS analysis

Amphiphilic materials can be used for sample preparation of chromatography or mass spectrometry. Amphiphilic materials with magnetic properties in combination with magnetic suction devices allow for automated sample preparation. However, conventional synthesis methods are cumbersome and not suitable for the mass production of the material. In this study, a micro-suspension polymerization method was developed to synthesize magnetic amphiphilic resin microspheres (MARMs), providing new ideas for the preparation of amphiphilic microspheres. MARMs with particle sizes ranging from 3 to 6 μm were successfully prepared, with BET surface area up to 653.2 m2/g. A magnetic solid-phase extraction method based on MARM-5 was developed for the extraction of four glucocorticoids including Cortisone, Hydrocortisone, Cortodoxone, and Corticosterone. This method had a very short adsorption time of 0.5 min and a total extraction time of only 13 min. The limit of detection for the four glucocorticoids ranged from 0.22 to 0.82 ng/L. There was a good linear relationship between sample concentration and peak area in the range of 25∼500 ng/L. Relative recovery of 98 %∼108 % and internal standard normalized matrix effect factors of 95∼114 % were obtained, and the relative standard deviation was between 2.3 % and 6.3 %. The MARMs would be used as excellent solid extraction material for glucocorticoids.

Using Magnetic Micelles Combined with Carbon Fiber Ionization Mass Spectrometry for the Screening of Trace Triazine Herbicides from Aqueous Samples

Triazine herbicides are commonly used in agriculture to eliminate weeds. However, they can persist in the environment. In this study, we explored a new method for detecting triazine herbicides in aqueous samples. We selected two triazine herbicides, namely, prometryn and ametryn, as model herbicides. To generate magnetic probes, we mixed aqueous Gd3+ with aqueous sodium dodecyl sulfate (SDS), which created magnetic probes made of Gd3+-SDS micelles. These probes showed a trapping capacity for the model herbicides. Results indicated that the trapping capacities of our magnetic probes for ametryn and prometryn were approximately 466 and 468 nmol mg-1, respectively. The dissociation constants of our probes toward ametryn and prometryn were 2.92 × 10-5 and 1.27 × 10-5, respectively. This is the first report that the developed magnetic probes can be used to trap triazine herbicides. For detection, we used carbon fiber ionization mass spectrometry (CFI-MS), which can be used to directly detect semi-volatiles from the samples in the condensed phase. Because of the semi-volatility of triazine herbicides, the herbicides trapped by the magnetic probes can be directly analyzed by CFI-MS without any elution steps. In addition, we also demonstrated the feasibility of using our approach for detecting triazine herbicides in lake water and drinking water.

Point-of-care applicable metabotyping using biofluid-specific electrospun MetaSAMPs directly amenable to ambient LA-REIMS

In recent years, ambient ionization mass spectrometry (AIMS) including laser ablation rapid evaporation IMS, has enabled direct biofluid metabolome analysis. AIMS procedures are, however, still hampered by both analytical, i.e., matrix effects, and practical, i.e., sample transport stability, drawbacks that impede metabolome coverage. In this study, we aimed at developing biofluid-specific metabolome sampling membranes (MetaSAMPs) that offer a directly applicable and stabilizing substrate for AIMS. Customized rectal, salivary, and urinary MetaSAMPs consisting of electrospun (nano)fibrous membranes of blended hydrophilic (polyvinylpyrrolidone and polyacrylonitrile) and lipophilic (polystyrene) polymers supported metabolite absorption, adsorption, and desorption. Moreover, MetaSAMP demonstrated superior metabolome coverage and transport stability compared to crude biofluid analysis and was successfully validated in two pediatric cohorts (MetaBEAse, n = 234 and OPERA, n = 101). By integrating anthropometric and (patho)physiological with MetaSAMP-AIMS metabolome data, we obtained substantial weight-driven predictions and clinical correlations. In conclusion, MetaSAMP holds great clinical application potential for on-the-spot metabolic health stratification.

Magnetic polymer particles as a highly efficient and facile cleanup adsorbent for multi-pesticide residues analysis in aquatic products

A novel and efficient sample pretreatment procedure using magnetic particles was exploited for the determination of multi-pesticide residues in aquatic products. The magnetic adsorbent was prepared using divinyl benzene and N-vinyl pyrrolidone as functional monomers modified on the Fe₃O₄ @SiO₂. The obtained magnetic adsorbent, octadecylsilane sorbents, and graphitized carbon black were employed as effective adsorbents to remove matrix interferences in aquatic products, and their dosages were optimized. Satisfactory levels of accuracy and precision were procured under optimum conditions. The method limits of quantification ranged from 0.1 to 2.0 μg/kg. The analytical accuracy of the developed method for the analysis of multi-pesticide residues in freshwater and seafood products was validated. It was found to be suitable for the analysis of multi-pesticide residues in different types of aquatic products. Additionally, the method was successfully applied for the analysis of pesticide residues in fish samples obtained from aquaculture plants located in Zhejiang Province, China. The detected concentrations of pesticides ranged from 0.14 to 0.95 μg/kg. In general, this method shows promising application prospects for the rapid determination of multi-pesticide residues in aquatic products.

Magnetic dispersive solid-phase extraction of triazole and triazine pesticides from vegetable samples using a hydrophilic-lipophilic sorbent based on maltodextrin- and β-cyclodextrin-functionalized graphene oxide

Maltodextrin- and β-cyclodextrin-functionalized magnetic graphene oxide (mGO/β-CD/MD), a novel hydrophilic-lipophilic composite, was successfully fabricated and used for the co-extraction of triazines and triazoles from vegetable samples before HPLC-UV analysis. mGO/β-CD/MD was synthesized by chemical bonding of β-CD and MD to the surface of mGO, using epichlorohydrin (ECH) as a linker. The successful synthesis of mGO/β-CD/MD was confirmed by characterization tests, including attenuated total reflection-Fourier transform infrared spectroscopy (ATR-FTIR), X-ray diffraction (XRD), field emission scanning electron microscopy (FESEM), vibrating sample magnetometry (VSM), thermogravimetric analysis (TGA), energy-dispersive X-ray spectroscopy (EDX), Brunauer-Emmett-Teller (BET), and Barrett-Joyner-Halenda (BJH) analyses. The hydrophobic cavity of β-CD and a large number of hydroxyl groups on the MD structure contributed to the co-extraction of mentioned pesticides with a wide range of polarity. Under the optimized condition (sorbent amount, 30 mg; desorption time, 10 min; desorption solvent volume, 300 μL; desorption solvent, methanol/acetonitrile (1:1) containing 5% (v/v) acetic acid; extraction time, 20 min; and pH of sample solution, 7.0), good linearity within the range 1.0-1000 μg L^-1 (r² ≥ 0.992) was achieved. Extraction efficiencies were in the range 66.4-95.3%, and the limits of detection were 0.01-0.08 μg L^-1. Relative recoveries for spiked samples were obtained in the range 88.4-112.0%, indicating that the matrix effect was insignificant, and good precisions (intra- and inter-day) were also achieved (RSDs < 9.0%, n = 3). The results confirmed that the developed method was efficient for the determination  of trace amounts of pesticides in potato, tomato, and corn samples.

Recent advances in the extraction of triazine herbicides from water samples

Pesticides are excessively used in agriculture to improve the quality of crops by eliminating the negative effects of pests. Among the different groups of pesticides, triazine pesticides are a group of compounds that contain a substituted C₃ H₃ N₃ heterocyclic ring, and they are widely used. Triazine pesticides can be dangerous for humans as well as for the aquatic environment because of their high toxicity and endocrine disrupting effect. However, the concentration of these chemical compounds in water samples is low. Moreover, other compounds that may exist in the water samples can interfere with the determination of triazine pesticides. As a result, it is important to develop sample preparation methods that provide preconcentration of the target analyte and sufficient clean-up of the samples. Recently, a wide variety of novel microextraction and miniaturized extraction techniques (e.g., solid-phase microextraction and liquid-phase microextraction, stir bar sorptive extraction, fabric phase sorptive extraction, dispersive solid-phase extraction, and magnetic solid-phase extraction) have been developed. In this review, we aim to discuss the recent advances regarding the extraction of triazine pesticides from environmental water samples. Emphasis will be given to novel sample preparation methods and novel sorbents developed for sorbent-based extraction techniques.

Performance indicators for a holistic evaluation of catalyst-based degradation-A case study of selected pharmaceuticals and personal care products (PPCPs)

Considerable efforts have been made to develop effective and sustainable catalysts, e.g., carbon-/biochar-based catalyst, for the decontamination of organic pollutants in water/wastewater. Most of the published studies evaluated the catalytic performance mainly upon degradation efficiency of parent compounds; however, comprehensive and field-relevant performance assessment is still in need. This review critically analysed the performance indicators for carbon-/biochar-based catalytic degradation from the perspectives of: (1) degradation of parent compounds, i.e., concentrations, kinetics, reactive oxidative species (ROS) analysis, and residual oxidant concentration; (2) formation of intermediates and by-products, i.e., intermediates analysis, evolution of inorganic ions, and total organic carbon (TOC); and (3) impact assessment of treated samples, i.e., toxicity evolution, disinfection effect, and biodegradability test. Five most frequently detected pharmaceuticals and personal care products (PPCPs) (sulfamethoxazole, carbamazepine, ibuprofen, diclofenac, and acetaminophen) were selected as a case study to articulate the performance indicators for a holistic evaluation of carbon-/biochar-based catalytic degradation. This review also encourages the development of alternative performance indicators to facilitate the rational design of catalysts in future studies.

Development, validation, comparison, and implementation of a highly efficient and effective method using magnetic solid-phase extraction with hydrophilic-lipophilic-balanced materials for LC-MS/MS analysis of pesticides in seawater

To achieve multi-pesticides residue analysis in seawater, hydrophilic-lipophilic-balanced magnetic particles were designed and fabricated by swelling polymerization of divinyl benzene (DVB) and N-vinyl pyrrolidone (NVP) on the surface of Fe₃O₄@SiO₂ magnetic particles. The ratio of DVB to NVP was adjusted to achieve a proper balance in hydrophilicity and lipophilicity. The obtained magnetic particles were systematically characterized by TEM, SEM, FT-IR and vibrating sample magnetization. Based on the optimized magnetic nanoparticles, a sensitive magnetic solid-phase extraction method was developed for the simultaneous pre-concentration and determination of 96-pesticide residues from large-volume seawater samples prior to being detected by liquid chromatography-tandem mass spectrometry. Recoveries of pesticides in spiked seawater samples (0.001, 0.01, 0.1, 1.0 μg L^-1) ranged from 62% to 112% with RSDs less than 21%. The method limits of detection of 96 pesticides ranged from 0.13 to 0.42 ng L^-1, the method limits of quantification of 96 pesticides ranged from 1.0 to 10 ng L^-1. The method was successfully applied to pesticide residue analysis in water samples from Jiulong River Estuary of China, demonstrating the prospects of this technique as a potential method for the rapid determination of trace levels of multi-pesticide residues in seawater.

Rapid Monitoring of Organochlorine Pesticide Residues in Various Fruit Juices and Water Samples Using Fabric Phase Sorptive Extraction and Gas Chromatography-Mass Spectrometry

Fabric phase sorptive extraction, an innovative integration of solid phase extraction and solid phase microextraction principles, has been combined with gas chromatography-mass spectrometry for the rapid extraction and determination of nineteen organochlorine pesticides in various fruit juices and water samples. FPSE consolidates the advanced features of sol-gel derived extraction sorbents with the rich surface chemistry of cellulose fabric substrate, which could extract the target analytes directly from the complex sample matrices, substantially simplifying the sample preparation operation. Important FPSE parameters, including sorbent chemistry, extraction time, stirring speed, type and volume of back-extraction solvent, and back-extraction time have been optimized. Calibration curves were obtained in a concentration range of 0.1–500 ng/mL. Under optimum conditions, limits of detection were obtained in a range of 0.007–0.032 ng/mL with satisfactory precision (RSD < 6%). The relative recoveries obtained by spiking organochlorine pesticides in water and selected juice samples were in the range of 91.56–99.83%. The sorbent sol-gel poly(ethylene glycol)-poly(propylene glycol)-poly(ethylene glycol) was applied for the extraction and preconcentration of organochlorine pesticides in aqueous and fruit juice samples prior to analysis with gas chromatography-mass spectrometry. The results demonstrated that the present method is simple, rapid, and precise for the determination of organochlorine pesticides in aqueous samples.

Versatile magnetic carbon nanotubes for sampling and pre concentration of pesticides in environmental water

This article describes a simple, efficient, and versatile magnetic carbon nanotubes (MCNT) method for sampling and pre-concentration of pesticides in environmental water samples. The multi-walled magnetic carbon nanotubes were obtained by chemical deposition vapor (CVD) process. The MCNTs structures are formed of hydrophobic and hydrophilic fractions that provide great dispersion at any water matrix allowing simultaneously a high efficiency of pesticides sorption. Following the extraction, analytes were desorbed with minor amounts of solvent and analyzed by gas chromatography coupled mass spectrometry (GC/MS). The parameters amount of MCNTs used to extraction, desorption time, and desorption temperature were optimized. The method showed good linearity with determination coefficients between 0.9040 and 0.9733. The limits of detection and quantification were ranged between 0.51 and 2.29µgL^-1 and between 1.19 and 5.35µgL^-1 respectively. The recovery ranged from 79.9% to 111.6%. The method was applied to the determination of fifteen multiclass pesticides in real samples of environmental water collected in Minas Gerais, Brazil.

Preparation of porous aromatic framework/ionic liquid hybrid composite coated solid-phase microextraction fibers and their application in the determination of organochlorine pesticides combined with GC-ECD detection

Novel porous aromatic framework/ionic liquid hybrid composite coated SPME fibers were prepared for the preconcentration of OCPs coupled with GC-ECD.