Selectivity improvement of positive photoionization ion mobility spectrometry for rapid detection of organophosphorus pesticides by switching dopant concentration

Time-Resolved Ion Mobility Spectrometry with a Stop Flow Confined Volume Reaction Region

An ion source concept is described where the sample flow is stopped in a confined volume of an ion mobility spectrometer creating time-dependent patterns of ion patterns of signal intensities for ions from mixtures of volatile organic compounds and improved signal-to-noise rate compared to conventional unidirectional drift gas flow. Hydrated protons from a corona discharge were introduced continuously into the confined volume with the sample in air at ambient pressure, and product ions were extracted continuously using an electric field for subsequent mobility analysis. Ion signal intensities for protonated monomers and proton bound dimers were measured and computationally extracted using mobilities from mobility spectra and exhibited distinct times of appearance over 30 s or more after sample injection. Models, and experimental findings with a ternary mixture, suggest that the separation of vapors as ions over time was consistent with differences in the reaction rate for reactions between primary ions from hydrated protons and constituents and from cross-reactions that follow the initial step of ionization. The findings suggest that the concept of stopped flow, introduced here for the first time, may provide a method for the temporal separation of atmospheric pressure ions. This separation relies on ion kinetics and does not require chromatographic technology.

Improving the Sensitivity and Linear Range of Photoionization Ion Mobility Spectrometry via Confining the Ion Recombination and Space Charge Effects Assisted by Theoretical Modeling

Photoionization (PI) is an efficient ionization source for ion mobility spectrometry (IMS) and mass spectrometry. Its hyphenation with IMS (PI-IMS) has been employed in various on-site analysis scenarios targeting a wide range of compounds. However, the signal intensity and linear dynamic range of PI-IMS at ambient pressure usually do not follow the Beer-Lambert law predictions, and the factors causing that negative deviation remain unclear. In this work, a variable pressure PI-IMS system was developed to examine the ion loss effects from factors like ion recombination and space charge by varying its working pressure from 1 to 0.1 bar. Assisted by theoretical modeling, it was found that ion recombination could contribute up to 90% of signal intensity loss for ambient pressure PI-IMS setups. Lowering the pressure and increasing the electric field in PI-IMS helped suppress the ion recombination process and thus an optimal pressure Poptimal appeared for best signal intensity, despite the decreased net ion number density and the increased space charge effect. A simplified theoretical equation taking ion recombination as the primary ion loss factor was derived to link Poptimal with analyte concentration and electric field in PI-IMS, enabling a swift optimization of the PI-IMS performance. For example, compared to ambient pressure, PI-IMS at a Poptimal of 0.4 bar provided a signal intensity increment of more than 400% for 0.716 ppmv toluene and also expanded the linear dynamic range by more than two times. Revealing factors influencing the PI-IMS response would also benefit the applications of other chemical ionization sources in IMS or mass spectrometry (MS).

Investigation of low-temperature partitioning with dispersive solid-phase extraction for quantification of pesticides in apples followed by electrospray-ionization mobility spectrometry: Comparison with conventional procedure

Ion mobility spectrometry (IMS) has a promising application prospect in food surveillance. However, due to the complexity of food matrix and trace levels of pesticide residues, the effective and rapid detection of pesticides by IMS has been a challenge, especially when using electrospray ionization (ESI) as an ion source. In this study, low-temperature partitioning with dispersive solid-phase extraction (LTP-dSPE) was explored and compared with conventional procedures. Both methods were validated for the quantification of eight pesticides in apples, obtaining a limit of detection (LOD) of 0.02-0.12 mg/kg for LTP-dSPE and 0.02-0.09 mg/kg for conventional solid-phase extraction (SPE), lower than those usually stipulated by government legislation in food matrices. For LTP-dSPE, the matrx effect (ME) ranged from -16.3 to -68.6 %, lower than that for the SPE method, ranging from -70.0 to -92.9 %. The results showed satisfactory efficiency and precision, with recovery values ranging from 67.9 to 115.4 % for LTP-dSPE and from 62.0 to 114.8 % for conventional SPE, with relative standard deviations below 13.0 %. Notably, the proposed LTP-dSPE/ESI-IMS has been shown to be more cost-effective, easier to use, more environment-friendly, more accessible, and, most importantly, less matrix effect than the conventional method, thereby being suitably applicable to a wide range of food safety applications.

Effect of resolution enhancement using metal ion assisted strategy based on electrospray ionization-ion mobility spectrometry: A case study of carbendazim and thiabendazole in fruits

A method for the rapid and simultaneous determination of carbendazim and thiabendazole residues by electrospray ionization-ion mobility spectrometry (ESI-IMS) combined with a metal ion-assisted technique was developed and validated in different fruit matrices. The metal ion assisted strategy was performed instead of tedious pre-separation procedures to overcome the limitation of low resolution of IMS. Four transition metal cations, Co(II), Ni(II), Cu(II), and Zn(II), were screened and their interactions with carbendazim and thiabendazole were investigated. The injection flow rate and metal ion concentration were optimized. The Cu(II) assisted approach helped to achieve well-separated peaks with a peak-to-peak resolution of 3.61. This method was then applied to detect carbendazim and thiabendazole simultaneously in apples, pears, bananas, and mangoes. The limit of detection (LOD) were 0.03 mg kg-1 and 0.13 mg kg-1 for carbendazim and thiabendazole, respectively, while spiked recoveries were 61.5-122.0% and 83.5-119.8%, respectively, with RSDs less than 13.9%. These satisfactory evaluation parameters indicated that the approach was capable of performing quantitative analysis of multi-pesticide residues. In addition, the feasibility of using metal ion assisted-ESI-IMS for the simultaneous detection also was theoretically demonstrated through molecular electrostatic potential analysis and binding energy calculation based on density functional theory (DFT). Both experimental and theoretical results revealed the effectiveness of the metal ion assisted strategy in improving the resolution of ESI-IMS.

Development of membrane inlet photoionization ion trap mass spectrometer for trace VOCs analysis

With the development of instrumental miniaturization, the portable mass spectrometer is becoming a new tool for on-site rapid analysis of environmental samples. Membrane inlet (MI) and photoionization (PI) are two commonly used sampling and ionization techniques, respectively, as they both exhibit detection selectivity for volatile organic compounds (VOCs). In this paper, a membrane inlet photoionization ion trap mass spectrometer was developed for the direct analysis of VOCs in gaseous samples. With the new structure and timing design, various operation modes were proposed and tested. In particular, the use of pulse carrier gas can integrate the appropriate pressure conditions required by each module, thus improving the efficiency of analyte transport, ionization, and mass analysis. The detection limit of sub-ppb was obtained, and the response time can be greatly reduced by increasing the sample flow rate. Furthermore, the capability of selective enrichment for organic analytes was also realized by using a special accumulation mode with a modified sequence, which is easy to operate because no additional devices are needed.

Implementation and study of dopant-assisted photoionization with a miniature capillary inlet ion trap mass spectrometer

RATIONALE

Dopant-assisted photoionization (PI) has been widely used in the mass spectrometric analysis of volatile compounds. Exploring simple doping methods will benefit parameter optimization and promote the application of this technique.

METHODS

A previously built miniature ion trap mass spectrometer was used to study dopant-assisted vacuum PI. The sampling system of this device was modified to provide three inlets for the simultaneous introduction of analytes, dopants, and auxiliary air. Then, dopant solution was directly injected into the ion trap chamber through a self-aspirating capillary inlet and rapidly evaporated without heating. Various dopant solutions were prepared and switched during the experiments.

RESULTS

When analyzing some aniline compounds, the signals of all analytes were improved by more than 10 times after the injection of 2% anisole solution as a dopant. In addition, anisole can provide analyte signals more than three times stronger than those provided by the other dopants. On the basis of the ionization energy selectivity of dopant-assisted PI, some isomers in the mass spectrometric analysis were distinguished using different additives.

CONCLUSIONS

In general, liquid doping is as feasible and as effective as other traditional methods, and using appropriate dopants with high PI efficiency or feeding more dopants contributes to the ionization of analytes. The proposed method also offers several unique merits, such as simple operation, low consumption, and smooth switching with minimal residue.

Structurally Informative Isotopic Shifts in Ion Mobility Spectra for Heavier Species

The isotopic molecular envelopes due to stable isotopes for most elements were a staple of mass spectrometry since its origins, often leveraged to identify and quantify compounds. However, all isomers share one MS envelope. As the molecular motion in media also depends on the isotopic composition, separations such as liquid chromatography (LC) and ion mobility spectrometry (IMS) must also feature isotopic envelopes. These were largely not observed because of limited resolution, except for the (structurally uninformative) shifts in LC upon H/D exchange. We recently found the isotopic shifts in FAIMS for small haloanilines (∼130-170 Da) to hinge on the halogen position, opening a novel route to isomer characterization. Here, we extend the capability to heavier species: dibromoanilines (DBAs, ∼250 Da) and tribromoanilines (TBAs, ∼330 Da). The ¹³C shifts for DBAs and TBAs vary across isomers, some changing sign. While ⁸¹Br shifts are less specific, the 2-D ¹³C/⁸¹Br shifts unequivocally differentiate all isomers. The trends for DBAs track those for dichloroanilines, with the ¹³C shift order preserved for most isomers. The peak broadening due to merged isotopomers is also isomer-specific. The absolute shifts for TBAs are smaller than those for lighter haloanilines, but differentiate isomers as well because of compressed uncertainties. These results showcase the feasibility of broadly distinguishing isomers in the more topical ∼200-300 Da range using the isotopic shifts in IMS spectra.

A Potassium Ion-Exchanged Glass Optical Waveguide Sensor Locally Coated with a Crystal Violet-SiO2 Gel Film for Real-Time Detection of Organophosphorus Pesticides Simulant

An optical waveguide (OWG) sensor was developed for real-time detection of diethyl chlorophosphate (DCP) vapor, which is a typical simulant for organophosphorus pesticides and chemical weapon agents. Silica gel, crystal violet (CV), and potassium ion-exchange (PIE) OWG were used to fabricate the sensor's device. In the real-time detection of the DCP vapor, the volume fraction of DCP vapor was recorded to be as low as 1.68 × 10^-9. Moreover, the detection mechanism of CV-SiO₂ gel film coated the PIE OWG sensor for DCP, which was evaluated by absorption spectra. These results demonstrated that the change of output light intensity of the OWG sensor significantly increased with the augment of the DCP concentration. Repeatability as well as selectivity of the sensors were tested using 0.042 × 10^-6 and 26.32 × 10^-6 volume fraction of the DCP vapor. No clear interference with the DCP detection was observed in the presence of other common solvents (e.g., acetone, methanol, dichloromethane, dimethylsulfoxide, and tetrahydrofuran), benzene series (e.g., benzene, toluene, chlorobenzene, and aniline), phosphorus-containing reagents (e.g., dimethyl methylphosphonate and trimethyl phosphate), acid, and basic gas (e.g., acetic acid and 25% ammonium hydroxide), which demonstrates that the OWG sensor could provide real-time, fast, and accurate measurement results for the detection of DCP.

Improved analytical performance of photoionization ion mobility spectrometry for the rapid detection of organophosphorus pesticides using K0 patterns with multiple reactant ions

Ion mobility spectrometry (IMS) has become a potential technique for the rapid detection of organophosphorus pesticides (OPPs). However, using only the commonly-used reactant ion (Ac)₂H⁺(H₂O)_n, some OPPs are difficult to distinguish due to their severely overlapping ion peaks. In this study, the switching of reactant ions ((Ac)₂H⁺(H₂O)_n, O₂⁻(H₂O)_n and Cl⁻(H₂O)_n) in a stand-alone photoionization ion mobility spectrometer was realized by on-line switching the polarity of high voltage and dopant species. Multiple reactant ions were employed to establish the characteristic K₀ patterns for the tested OPPs, including fenthion, dursban, dimethoate, malathion, fenitrothion, imidan and isocarbophos. The tested OPPs were represented on a heat map and a three-dimensional coordinate system based on the K₀ patterns, from which they could be readily identified. Under optimal conditions, the limits of detection (LODs) of the tested OPPs were evaluated to be 0.3–2.7 ng, and satisfactory repeatability was demonstrated by the obtained relative standard deviations (RSDs) of 4.8% to 14.7%. Finally, Chinese cabbage extract spiked with dursban and malathion was detected by the proposed ion mobility spectrometer, demonstrating its applicability for the simultaneous identification of coexisting OPPs in real samples.

The identification of organophosphorus pesticides using ion mobility spectrometry was improved using K₀ patterns with multiple reactant ions.