Identification of isocyclosporins by collision-induced dissociation of doubly protonated species

Quantitative Analysis of Drugs in a Mimetic Tissue Model Using Nano-DESI on a Triple Quadrupole Mass Spectrometer

Mass spectrometry is a powerful analytical technique used at every stage of the pharmaceutical research process. A specialized branch of this method, mass spectrometry imaging (MSI), has emerged as an important tool for determining the spatial distribution of drugs in biological samples. Despite the importance of MSI, its quantitative capabilities are still limited due to the complexity of biological samples and the lack of separation prior to analysis. This makes the simultaneous quantification and visualization of analytes challenging. Several techniques have been developed to address this challenge and enable quantitative MSI. One such approach is the mimetic tissue model, which involves the incorporation of an analyte of interest into tissue homogenates at several concentrations. A calibration curve that accounts for signal suppression by the complex biological matrix is then created by measuring the signal of the analyte in the series of tissue homogenates. Herein, we use the mimetic tissue model on a triple quadrupole mass spectrometer (QqQ) in multiple reaction monitoring mode to demonstrate the quantitative abilities of nanospray desorption electrospray ionization (nano-DESI) and compare these results with those obtained using atmospheric pressure matrix-assisted laser desorption/ionization (AP-MALDI). For the tested compounds, our findings indicate that nano-DESI achieves lower standard deviations than AP-MALDI, resulting in superior limits of detection for the studied analytes. Additionally, we discuss the limitations of the mimetic tissue model in the quantification of certain analytes and the challenges involved with the implementation of the model.

Exploring the Effects of Cyclosporin A to Isocyclosporin A Rearrangement on Ion Mobility Separation

Cyclosporin A (CycA) is a peptide secondary metabolite derived from fungi that plays a crucial role in transplantation surgery. Cyclic traveling wave ion mobility mass spectrometry (IM-MS) revealed an N → O peptidyl shift in singly protonated CycA to isocyclosporin A (isoA), whereas no such isomerization was observed for doubly protonated and sodiated molecules. CycA and isoA were able to be separated by considering doubly protonated precursors using a specific ion fragment. In parallel, sodium ion stabilization facilitated the simultaneous separation and quantitation of singly charged cyclosporin isomers with the limit of detection and coefficient of determination of 1.3% and 0.9908 for CycA in isoA and 1.0% and 0.9830 for isoA in CycA, respectively. Finally, 1H-13C gHSQC NMR experiments permitted parallel recording of up to 11 cyclosporin conformers. The ratios were determined by integrating the volume of cross-peaks of the upfield resonating hydrogen in the diastereotopic methylene group of sarcosine-3.

Valorization of Cheese Whey as a Feedstock for Production of Cyclosporin A by Tolypocladium inflatum

Food waste-based biorefineries are considered an essential concept for the implementation of a sustainable circular economy. In this study, cheese whey powder (CWP), a dairy industry waste, was utilized to produce cyclosporin A (CsA). As it is difficult to valorize CWP because its components vary depending on the origin, a process for sugar conversion via acid hydrolysis was designed to obtain reproducible results using refined whey powder (WP) of a consistent quality. Acid hydrolysis was carried out using 2% (w/w) HCl and biomass loading of 50 g/L at 121 °C for 20 min. CWP hydrolysates were utilized to ferment Tolypocladium inflatum ATCC 34921. CsA production was found to be 51.3 mg/L at 12 days, a 1.4-fold increase compared to the control (commercial glucose, 36.3 mg/L). Our results showed that 100 g CWP can be converted to 81.8 mg of CsA. This finding demonstrated that CWP can be used as a sustainable feedstock for biorefineries.