A Radiation Force Balance Target Material for Applications below 0.5 MHz

Measurement of the temperature-dependent output of lead zirconate titanate transducers

The effect of temperature and electrical drive conditions on the output of lead zirconate titanate (PZT) transducers is of particular interest in ultrasound metrology and medical ultrasound applications. In this work, the temperature-dependent output of two single-element PZT transducers was measured between 22 °C and 46 °C. Two independent measurement methods were used, namely radiation force balance measurements and laser vibrometry. When driven at constant voltage using a 50 Ω matched signal generator and amplifier using continuous wave (CW) or quasi-CW excitation, the output of the two transducers increased on average by 0.6 % per degree, largely due to an increase in transducer efficiency with temperature. The two measurement methods showed close agreement. Similar trends were observed when using single cycle excitation with the same signal chain. However, when driven using a pulser (which is not electrically matched), the two transducers exhibited different behaviour depending on their electrical impedance. Accounting for the temperature-dependent output of PZT transducers could have implications for many areas of ultrasound metrology, for example, in therapeutic ultrasound where a coupling fluid at an increased or decreased temperature is often used.

Sonochemical activity in ultrasonic reactors under heterogeneous conditions

Due to its physical and chemical effects, ultrasound is widely used for industrial purposes, especially in heterogeneous medium. Nevertheless, this heterogeneity can influence the ultrasonic activity. In this study, the effect of the addition of inert glass beads on the sonochemical activity inside an ultrasonic reactor is investigated by monitoring the formation rate of triiodide, and the ultrasonic power is measured by calorimetry and by acoustic radiation. It was found that the sonochemical activity strongly depends on the surface area of the glass beads in the medium: it decreases above a critical area value (around 10^-2 m²), partly due to wave scattering and attenuation. This result is confirmed for a large range of frequencies (from 20 to 1135 kHz) and glass beads diameters (from 8-12 µm to 6 mm). It was also demonstrated that above a given threshold of the surface area, only part of the supplied ultrasonic power is devoted to chemical effects of ultrasound. Finally, the acoustic radiation power appears to describe the influence of solids on sonochemical activity, contrary to the calorimetric power.