Chiral high-performance liquid chromatography of N-octyl bicycloheptene dicarboximide and confirmatory studies using liquid chromatography-tandem mass spectrometry and two-dimensional nuclear magnetic resonance spectroscopy

Evaluation of low-cost disposable polymeric materials for sorptive extraction of organic pollutants in water samples

The capabilities of four commercially available and low cost polymeric materials for the extraction of polar and non-polar contaminants (logK(ow)=-0.07-6.88, from caffeine to octocrylene, respectively) from water samples was compared. Tested sorbents were polyethersulphone, polypropylene and Kevlar, compared to polydimethylsiloxane as reference material. Parameters that affect the extraction process such as pH and ionic strength of the sample, extraction time and desorption conditions were thoroughly investigated. A set of experimental partition coefficients (K(pw)), at two different experimental conditions, was estimated for the best suited materials and compared with the theoretical octanol-water (K(ow)) partition coefficients of the analytes. Polyethersulphone displayed the largest extraction yields for both polar and non-polar analytes, with higher K(pw) and lower matrix effects than polydimethylsiloxane and polypropylene. Thus, a sorptive microextraction method, followed by large volume injection (LVI) gas chromatography-tandem mass spectrometry (GC-MS/MS), was proposed using the former sorbent (2 mg) for the simultaneous determination of model compounds in water samples. Good linearity (>0.99) was obtained for most of the analytes, except in the case of 4-nonylphenol (0.9466). Precision (n=4) at 50 and 500 ng L(-1) levels was in the 2-24% and limits of detection (LODs) were in the 0.6-25 ng L(-1) range for all the analytes studied.

Diastereomeric differentiation of norbornene amino acid peptides by electrospray ionization tandem mass spectrometry

A new class of diastereomeric pairs of non-natural amino acid peptides derived from butyloxycarbonyl (Boc-)protected cis-(2S,3R)- and trans-(2S,3S)-beta-norbornene amino acids including a monomeric pair have been investigated by electrospray ionization (ESI) tandem mass spectrometry using quadrupole time-of-flight (Q-TOF) and ion-trap mass spectrometers. The protonated cis-BocN-beta-nbaa (2S,3R) (1) (betanbaa = beta-norbornene amino acid) eliminates the Boc group to form [M+H-Boc+H](+), whereas an additional ion [M+H-C(4)H(8)](+) is formed from trans-BocN-beta-nbaa (2S,3S) (2). Similarly, it is observed that the peptide diastereomers (di-, tri- and tetra-), with cis-BocN-beta-nbaa (2S,3R)- at the N-terminus, initially eliminate the Boc group to form [M+H-Boc+H](+) which undergo further fragmentation to give a set of product ions that are different for the peptides with trans-BocN-beta-nbaa (2S,3S)- at the N-terminus. Thus the Boc group fragments differently depending on the configuration of the amino acid present at the N-terminus. It is also observed that the peptide bond cleavage in these peptides is less favoured and most of the product ions are formed due to retro-Diels-Alder fragmentation. Interestingly, sodium-cationized peptide diastereomers mainly yield a series of retro-Diels-Alder fragment ions which are different for each diastereomer as they are formed starting from [M+Na-Boc+H](+) in peptides with cis-BocN-beta-nbaa (2S,3R)- at the N-terminus, and [M+Na-C(4)H(8)](+) in peptides with trans-BocN-beta-nbaa (2S,3S)- at the N-terminus. All these results clearly indicate that these diastereomeric pairs of peptides yield characteristic product ions which help distinguish the isomers.

Isocratic reversed-phase liquid chromatographic method for the simultaneous determination of (S)-methoprene, MGK264, piperonyl butoxide, sumithrin and permethrin in pesticide formulation

An isocratic reversed-phase high-performance liquid chromatographic (RP-HPLC) method development for the simultaneous determination of five active ingredients (S)-methoprene, MGK264, PBO, sumithrin and permethrin in a new complex pesticide formulation is described. These active ingredients have similar polarities and contain isomers. The RP-HPLC method development approach began with the selection of a column based on the component structure information, bonded phase, and particle physical characteristics. Second, the mobile phase composition was changed to improve peak resolution and peak sensitivity, especially with analytes containing isomers. Choosing the match between the stationary phase and mobile phase composition, the developed RP-HPLC method not only can simplify the procedure appreciably but also significantly decrease total analysis time and increase peak height. The developed isocratic RP-HPLC method for the analysis of this new formulation was then validated for specificity, linearity, precision, and accuracy. The chromatographic peak identification was identified by LC-MS using the electrospray ionisation in the positive-ion mode.

Case of enantiomer impurity identification by normal-phase chiral high-performance liquid chromatography with optical rotation and mass spectrometric detection

An impurity produced in the synthesis of compound I is separated and identified as its enantiomer II using normal-phase chiral high-performance liquid chromatography (HPLC) with UV absorbance, optical rotation (OR) and mass spectrometric (MS) detection. The results show that the impurity II and compound I have equal and opposite specific rotations, identical MS spectra and the same MS-MS fragmentation pattern, as required for enantiomers. The procedures presented demonstrate a novel combination of methods for enantiomer identification and characterization that do not require the preparation of individual enantiomer markers or even the racemic mixture, thus reducing the need for additional synthetic work.