Detection of Bacillus anthracis spores in soil by PCR

Caenorhabditis elegans Predation on Bacillus anthracis: Decontamination of Spore Contaminated Soil with Germinants and Nematodes

Remediation of Bacillus anthracis-contaminated soil is challenging and approaches to reduce overall spore levels in environmentally contaminated soil or after intentional release of the infectious disease agent in a safe, low-cost manner are needed. B. anthracis spores are highly resistant to biocides, but once germinated they become susceptible to traditional biocides or potentially even natural predators such as nematodes in the soil environment. Here, we describe a two-step approach to reducing B. anthracis spore load in soil during laboratory trials, whereby germinants and Caenorhabditis elegans nematodes are applied concurrently. While the application of germinants reduced B. anthracis spore load by up to four logs depending on soil type, the addition of nematodes achieved a further log reduction in spore count. These laboratory based results suggest that the combined use of nematodes and germinants could represent a promising approach for the remediation of B. anthracis spore contaminated soil.

Originality-Significance Statement: This study demonstrates for the first time the successful use of environmentally friendly decontamination methods to inactivate Bacillus anthracis spores in soil using natural predators of the bacterium, nematode worms.

Optimization of a sample processing protocol for recovery of Bacillus anthracis spores from soil

Following a release of Bacillus anthracis spores into the environment, there is a potential for lasting environmental contamination in soils. There is a need for detection protocols for B. anthracis in environmental matrices. However, identification of B. anthracis within a soil is a difficult task. Processing soil samples helps to remove debris, chemical components, and biological impurities that can interfere with microbiological detection. This study aimed to optimize a previously used indirect processing protocol, which included a series of washing and centrifugation steps. Optimization of the protocol included: identifying an ideal extraction diluent, variation in the number of wash steps, variation in the initial centrifugation speed, sonication and shaking mechanisms. The optimized protocol was demonstrated at two laboratories in order to evaluate the recovery of spores from loamy and sandy soils. The new protocol demonstrated an improved limit of detection for loamy and sandy soils over the non-optimized protocol with an approximate matrix limit of detection at 14spores/g of soil. There were no significant differences overall between the two laboratories for either soil type, suggesting that the processing protocol will be robust enough to use at multiple laboratories while achieving comparable recoveries.

Femtomolar detection of the anthrax edema factor in human and animal plasma

Edema factor (EF), a calmodulin-activated adenylyl cyclase, is a toxin which contributes to cutaneous and systemic anthrax. As a novel strategy to detect anthrax toxins in humans or animals infected by Bacillus anthracis, we have developed a sensitive enzymatic assay to be able to monitor functional EF in human and animal plasma. Samples containing EF are incubated in the presence of calmodulin and ATP, which is converted to cAMP. After oxidation and derivatization, cAMP is monitored by competitive enzyme immunoassay. Because of the high turnover of EF and the sensitivity of cAMP detection, EF can be detected at concentrations of 1 pg/mL (10 fM) in 4 h in plasma from humans or at 10 pg/mL in the plasma of various animal species using only a blood volume of 5 microL. The assay has good reproducibility with intra- and interday coefficients of variation in the range of 20% and is not subject to significant interindividual matrix effects. In an experimental study performed in mice infected with the Berne strain, we were able to detect EF in serum and ear tissues. This simple and robust combination of enzymatic reaction and enzyme immunoassay for the diagnosis of anthrax toxemia could prove useful in biological threat detection as well in research and clinical practice.

Implications of limits of detection of various methods for Bacillus anthracis in computing risks to human health

Used for decades for biological warfare, Bacillus anthracis (category A agent) has proven to be highly stable and lethal. Quantitative risk assessment modeling requires descriptive statistics of the limit of detection to assist in defining the exposure. Furthermore, the sensitivities of various detection methods in environmental matrices are vital information for first responders. A literature review of peer-reviewed journal articles related to methods for detection of B. anthracis was undertaken. Articles focused on the development or evaluation of various detection approaches, such as PCR, real-time PCR, immunoassay, etc. Real-time PCR and PCR were the most sensitive methods for the detection of B. anthracis, with median instrument limits of detection of 430 and 440 cells/ml, respectively. There were very few peer-reviewed articles on the detection methods for B. anthracis in the environment. The most sensitive limits of detection for the environmental samples were 0.1 CFU/g for soil using PCR-enzyme-linked immunosorbent assay (ELISA), 17 CFU/liter for air using an ELISA-biochip system, 1 CFU/liter for water using cultivation, and 1 CFU/cm(2) for stainless steel fomites using cultivation. An exponential dose-response model for the inhalation of B. anthracis estimates of risk at concentrations equal to the environmental limit of detection determined the probability of death if untreated to be as high as 0.520. Though more data on the environmental limit of detection would improve the assumptions made for the risk assessment, this study's quantification of the risk posed by current limitations in the knowledge of detection methods should be considered when employing those methods in environmental monitoring and cleanup strategies.

Piezoelectric-excited millimeter-sized cantilever (PEMC) sensors detect Bacillus anthracis at 300spores/mL

Piezoelectric-excited millimeter-sized cantilever (PEMC) sensors consisting of a piezoelectric and a borosilicate glass layer with a sensing area of 2.48 mm2 were fabricated. Antibody specific to Bacillus anthracis (BA, Sterne strain 7702) spores was immobilized on PEMC sensors, and exposed to spores (300 to 3x10(6) spores/mL). The resonant frequency decreased at a rate proportional to the spore concentration and reached a steady state frequency change of 5+/-5 Hz (n=3), 92+/-7 Hz (n=3), 500+/-10 Hz (n=3), 1030+/-10 Hz (n=2), and 2696+/-6 Hz (n=2) corresponding to 0, 3x10(2), 3x10(3), 3x10(4), and 3x10(6) spores/mL, respectively. The reduction in resonant frequency is proportional to the change in cantilever mass, and thus the observed changes are due to the attachment of spores on the sensor surface. Selectivity of the antibody-functionalized sensor was determined with samples of BA (3x10(6)/mL) mixed with Bacillus thuringiensis (BT; 1.5x10(9)/mL) in various volume ratios that yielded BA:BT ratios of 1:0, 1:125, 1:250, 1:500 and 0:1. The corresponding resonance frequency decreases were, respectively, 2345, 1980, 1310, 704 and 10 Hz. Sample containing 100% BT spores (1.5x10(9)/mL and no BA) gave a steady state frequency decrease of 10 Hz, which is within noise level of the sensor, indicating excellent selectivity. The observed binding rate constant for the pure BA and BT-containing samples ranged from 0.105 to 0.043 min-1 in the spore concentration range 300 to 3x10(6)/mL. These results show that detection of B. anthracis spore at a very low concentration (300 spores/mL) and with high selectivity in presence of another Bacillus spore (BT) can be accomplished using piezoelectric-excited millimeter-sized cantilever sensors.

Pyrosequencing Bacillus anthracis

Pyrosequencing technology was used to rapidly and specifically identify Bacillus anthracis.

Pyrosequencing technology is a sequencing method that screens DNA nucleotide incorporation in real time. A set of coupled enzymatic reactions, together with bioluminescence, detects incorporated nucleotides in the form of light pulses, which produces a profile of characteristic peaks in a pyrogram. We used this technology to identify the warfare agent Bacillus anthracis by sequencing 4 single nucleotide polymorphisms (SNPs) in the rpoB gene as chromosomal markers for B. anthracis. In addition, 1 segment in each of the B. anthracis plasmids pXO1 and pXO2 was analyzed to determine the virulence status of the bacterial strains. Pyrosequencing technology is a powerful method to identify B. anthracis.

Bacillus anthracis: toxicology, epidemiology and current rapid-detection methods

B. anthracis, the causative agent for anthrax, has been well studied for over 150 years. Due to the genetic similarities among various Bacillus species, as well as its existence in both a spore form and a vegetative state, the detection and specific identification of B. anthracis have been proven to require complex techniques and/or laborious methods. With the heightened interest in the organism as a potential biological threat agent, a large number of interesting detection technologies have recently been developed, including methods involving immunological and nucleic acid-based assay formats. The technologies range from culture-based methods to portable Total Analysis Systems based on real-time PCR. This review with 170 references provides a brief background on the toxicology and epidemiology of B. anthracis, discusses challenges associated with its detection related to genetic similarities to other species, and reviews immunological and, with greater emphasis, nucleic acid-based detection systems.

A review of molecular recognition technologies for detection of biological threat agents

The present review summarizes the state of the art in molecular recognition of biowarfare agents and other pathogens and emphasizes the advantages of using particular types of reagents for a given target (e.g. detection of bacteria using antibodies versus nucleic acid probes). It is difficult to draw firm conclusions as to type of biorecognition molecule to use for a given analyte. However, the detection method and reagents are generally target-driven and the user must decide on what level (genetic versus phenotypic) the detection should be performed. In general, nucleic acid-based detection is more specific and sensitive than immunological-based detection, while the latter is faster and more robust. This review also points out the challenges faced by military and civilian defense components in the rapid and accurate detection and identification of harmful agents in the field. Although new and improved sensors will continue to be developed, the more crucial need in any biosensor may be the molecular recognition component (e.g. antibody, aptamer, enzyme, nucleic acid, receptor, etc.). Improvements in the affinity, specificity and mass production of the molecular recognition components may ultimately dictate the success or failure of detection technologies in both a technical and commercial sense. Achieving the ultimate goal of giving the individual soldier on the battlefield or civilian responders to an urban biological attack or epidemic, a miniature, sensitive and accurate biosensor may depend as much on molecular biology and molecular engineering as on hardware engineering. Fortunately, as this review illustrates, a great deal of scientific attention has and is currently being given to the area of molecular recognition components. Highly sensitive and specific detection of pathogenic bacteria and viruses has increased with the proliferation of nucleic acid and immuno-based detection technologies. If recent scientific progress is a fair indicator, the future promises remarkable new developments in molecular recognition elements for use in biosensors with a vast array of applications.

Polymerase chain reaction-ELISA to detect Bacillus anthracis from soil samples-limitations of present published primers

A polymerase chain reaction (PCR)-ELISA technique to detect Bacillus anthracis from soil samples has been developed. The application of streptavidine-coated microtitre plates as well as plates covered with covalently linked oligonucleotides as catching probes led to a test sensitivity of about 100 fg pure genomic DNA or of less than 10 spores seeded into 100 g soil material. Some non-suspicious soil samples collected from different locations yielded positive results with presently published primers or probes targeting the B or C gene of pX02 and with primers targeting the chromosomal sequence B813. The former PCR products were sequenced. The number and mode of base exchanges led to the assumption that there will exist at least one unknown soil organism with high similarity within highly conserved capsule-encoding genes.