Comparison of Thermal Annealing versus Hydrothermal Treatment Effects on the Detection Performances of ZnO Nanowires

Surface Conversion of ZnO Tetrapods Produces Pinhole-Free ZIF-8 Layers for Selective and Sensitive H2 Sensing Even in Pure Methane

As the necessary transition to a supply of renewable energy moves forward rapidly, hydrogen (H2) becomes increasingly important as a green chemical energy carrier. The manifold applications associated with the use of hydrogen in the energy sector require sensor materials that can efficiently detect H2 in small quantities and in gas mixtures. As a possible candidate, we here present a metal-organic framework (MOF, namely ZIF-8) functionalized metal-oxide gas sensor (MOS, namely ZnO). The gas sensor is based on single-crystalline tetrapodal ZnO (t-ZnO) microparticles, which are coated with a thin layer of ZIF-8 ([Zn(C4H5N2)2]) by a ZnO conversion reaction to obtain t-ZnO@ZIF-8 (core@shell) composites. The vapor-phase synthesis enables ZIF-8 thickness control as shown by powder X-ray diffraction, thermogravimetric analysis, and N2 sorption measurements. Gas-sensing measurements of a single microrod of t-ZnO@ZIF-8 composite demonstrate the synergistic benefits of both MOS sensors and MOFs, resulting in an outstanding high selectivity, sensitivity (S ≅ 546), and response times (1-2 s) to 100 ppm H2 in the air at a low operation temperature of 100 °C. Under these conditions, no response to acetone, n-butanol, methane, ethanol, ammonia, 2-propanol, and carbon dioxide was observed. Thereby, the sensor is able to reliably detect H2 in mixtures with air and even methane, with the latter being highly important for determining the H2 dilution level in natural gas pipelines, which is of great importance to the energy sector.

Nanosensors Based on a Single ZnO:Eu Nanowire for Hydrogen Gas Sensing

Fast detection of hydrogen gas leakage or its release in different environments, especially in large electric vehicle batteries, is a major challenge for sensing applications. In this study, the morphological, structural, chemical, optical, and electronic characterizations of ZnO:Eu nanowire arrays are reported and discussed in detail. In particular, the influence of different Eu concentrations during electrochemical deposition was investigated together with the sensing properties and mechanism. Surprisingly, by using only 10 μM Eu ions during deposition, the value of the gas response increased by a factor of nearly 130 compared to an undoped ZnO nanowire and we found an H2 gas response of ∼7860 for a single ZnO:Eu nanowire device. Further, the synthesized nanowire sensors were tested with ultraviolet (UV) light and a range of test gases, showing a UV responsiveness of ∼12.8 and a good selectivity to 100 ppm H2 gas. A dual-mode nanosensor is shown to detect UV/H2 gas simultaneously for selective detection of H2 during UV irradiation and its effect on the sensing mechanism. The nanowire sensing approach here demonstrates the feasibility of using such small devices to detect hydrogen leaks in harsh, small-scale environments, for example, stacked battery packs in mobile applications. In addition, the results obtained are supported through density functional theory-based simulations, which highlight the importance of rare earth nanoparticles on the oxide surface for improved sensitivity and selectivity of gas sensors, even at room temperature, thereby allowing, for instance, lower power consumption and denser deployment.

Ultraviolet Photodetector Based on Poly(3,4-Ethylenedioxyselenophene)/ZnO Core-Shell Nanorods p-n Heterojunction

In this work, we successfully assembled an organic-inorganic core-shell hybrid p-n heterojunction ultraviolet photodetector by the electropolymerization deposition of poly(3,4-ethylenedioxyselenophene) (PEDOS) on the surface of zinc oxide nanoarrays (ZnO NRs). The structures of composite were confirmed by FTIR, UV-Vis, XRD and XPS. Mott-Schottky analysis was used to study the p-n heterojunction structure. The photodetection properties of ZnO NRs/PEDOS heterojunction ultraviolet photodetector were systematically investigated current-voltage (I-V) and current-time (I-t) analysis under different bias voltages. The results showed that PEDOS films uniformly grew on ZnO NRs surface and core-shell structure was formed. The p-n heterojunction structure was formed with strong built-in electric field between ZnO NRs and PEDOS. Under the irradiation of UV light, the device showed a good rectification behavior. The responsivity, detection rate and the external quantum efficiency of the ultraviolet photodetector reached to 247.7 A/W, 3.41 × 10¹² Jones and 84,000% at 2 V bias, respectively. The rise time (τ_r) and fall time (τ_f) of ZnO NRs/PEDOS UV photodetector were obviously shortened compared to ZnO UV photodetector. The results show that the introduction of PEDOS effectively improves the performance of the UV photodetector.

Al2O3/ZnO Heterostructure-Based Sensors for Volatile Organic Compounds in Safety Applications

Monitoring volatile organic compounds (VOCs) in harsh environments, especially for safety applications, is a growing field that requires specialized sensor structures. In this work, we demonstrate the sensing properties toward the most common VOCs of columnar Al₂O₃/ZnO heterolayer-based sensors. We have also developed an approach to tune the sensor selectivity by changing the thickness of the exposed amorphous Al₂O₃ layer from 5 to 18 nm. Columnar ZnO films are prepared by a chemical solution method, where the exposed surface is decorated with an Al₂O₃ nanolayer via thermal atomic layer deposition at 75 °C. We have investigated the structure and morphology as well as the vibrational, chemical, electronic, and sensor properties of the Al₂O₃/ZnO heterostructures. Transmission electron microscopy (TEM) studies show that the upper layers consist of amorphous Al₂O₃ films. The heterostructures showed selectivity to 2-propanol vapors only within the range of 12-15 nm thicknesses of Al₂O₃, with the highest response value of ∼2000% reported for a thickness of 15 nm at the optimal working temperature of 350 °C. Density functional theory (DFT) calculations of the Al₂O₃/ZnO(1010) interface and its interaction with 2-propanol (2-C₃H₇OH), n-butanol (n-C₄H₉OH), ethanol (C₂H₅OH), acetone (CH₃COCH₃), hydrogen (H₂), and ammonia (NH₃) show that the molecular affinity for the Al₂O₃/ZnO(1010) interface decreases from 2-propanol (2-C₃H₇OH) ≈ n-butanol (n-C₄H₉OH) > ethanol (C₂H₅OH) > acetone (CH₃COCH₃) > hydrogen (H₂), which is consistent with our gas response experiments for the VOCs. Charge transfers between the surface and the adsorbates, and local densities of states of the interacting atoms, support the calculated strength of the molecular preferences. Our findings are highly important for the development of 2-propanol sensors and to our understanding of the effect of the heterojunction and the thickness of the top nanolayer on the gas response, which thus far have not been reported in the literature.

Moderate molecular recognitions on ZnO m-plane and their selective capture/release of bio-related phosphoric acids

Herein, we explore the hidden molecular recognition abilities of ZnO nanowires uniformly grown on the inner surface of an open tubular fused silica capillary via liquid chromatography. Chromatographic evaluation revealed that ZnO nanowires showed a stronger intermolecular interaction with phenylphosphoric acid than any other monosubstituted benzene. Furthermore, ZnO nanowires specifically recognized the phosphate groups present in nucleotides even in the aqueous mobile phase, and the intermolecular interaction increased with the number of phosphate groups. This discrimination of phosphate groups in nucleotides was unique to the rich (101̄0) m-plane of ZnO nanowires with a moderate hydrophilicity and negative charge. The discrimination could be evidenced by the changes in the infrared bands of the phosphate groups on nucleotides on ZnO nanowires. Finally, as an application of the molecular recognition, nucleotides were separated by the number of phosphate groups, utilizing optimized gradient elution on ZnO nanowire column. Thus, the present results elucidate the unique and versatile molecular selectivity of well-known ZnO nanostructures for the capture and separation of biomolecules.

Economic Friendly ZnO-Based UV Sensors Using Hydrothermal Growth: A Review

Ultraviolet (UV) sensors offer significant advantages in human health protection and environmental pollution monitoring. Amongst various materials for UV sensors, the zinc oxide (ZnO) nanostructure is considered as one of the most promising candidates due to its incredible electrical, optical, biomedical, energetic and preparing properties. Compared to other fabricating techniques, hydrothermal synthesis has been proven to show special advantages such as economic cost, low-temperature process and excellent and high-yield production. Here, we summarize the latest progress in research about the hydrothermal synthesis of ZnO nanostructures for UV sensing. We particularly focus on the selective hydrothermal processes and reveal the effect of key factors/parameters on ZnO architectures, such as the laser power source, temperature, growth time, precursor, seeding solution and bases. Furthermore, ZnO hydrothermal nanostructures for UV applications as well as their mechanisms are also summarized. This review will therefore enlighten future ideas of low-temperature and low-cost ZnO-based UV sensors.