Photovoltaic Small Molecules of TPA(FxBT-T-Cz)3: Tuning Open-Circuit Voltage over 1.0 V for Their Organic Solar Cells by Increasing Fluorine Substitution

Synthesis and the spectral, electrochemical, and nonlinear optical properties of β-dicyanovinyl-appended 'push-pull' porphyrins

A series of "push-pull" porphyrins, MTPP(MN)(TPA)₂ (M = 2H, Cu^II, Ni^II, and Zn^II), having triphenylamine (TPA) and dicyanovinyl (DCN) groups at antipodal positions were synthesized and characterised by UV-Vis, fluorescence and NMR spectroscopic techniques, MALDI-TOF mass spectrometry, cyclic voltammetry, DFT, and elemental analysis, which were then further utilized for third-order nonlinear optical measurements under mild conditions using femtosecond laser pulses. Remarkably, MTPP(MN)(TPA)₂ (M = 2H, Cu^II, Ni^II, and Zn^II) exhibited 21-48 nm and 38-80 nm bathochromic shifts in B and Q_x(0,0) bands as compared to the corresponding MTPPs (M = 2H, Cu^II, Ni^II, and Zn^II); the results are consistent with the effect of enhanced resonance due to TPA and -I effect of DCN moieties. In cyclic voltammetry, the push-pull porphyrins exhibited a cathodic shift (0.13-0.51 V) in their first oxidation potential as compared to the precursor owing to the presence of electron-donating TPA groups. The third-order nonlinear optical responses were recorded using a single-beam femtosecond Z-scan technique to retrieve information about the nonlinear absorption and nonlinear refraction of the samples. The two-photon absorption coefficients (β) are in the range of 0.87 × 10^-13 to 4.28 × 10^-13 m W^-1 and the nonlinear refractive index (n₂) in the range of 1.21 × 10^-19 to 7.36 × 10^-19 m² W^-1. The ultrafast absorption dynamics of the ground-state bleaching (GSB) and photo-induced absorption (PIA) are monitored by femtosecond broadband transient absorption studies. The strong nonlinearity of these push-pull porphyrins makes them potential candidates for nonlinear optical and photonic device applications.

PDI-Based Hexapod-Shaped Nonfullerene Acceptors for the High-Performance As-Cast Organic Solar Cells

Three hexapod-shaped PDI-hexamers (PSM1, PSM2, and PSM3) with a diphenylmethylene-bridged triphenylamine (TPA) core and six peripheral PDI subunits have been designed and synthesized. The influence of different peripheral PDI subunits on the morphology and crystallinity of acceptors is investigated. Distinctly different from the previously reported PDI trimers with a TPA core, which exhibit amorphous morphologies, these hexapod-shaped acceptors display improved crystallinities and photophysical properties. Our studies have shown that PSM3 with six peripheral thiophene-fused PDI subunits gives the best result. The as-cast blend films of PBDB-T and PSM3, which possess appropriate phase separation and higher crystallinity, show high and balanced charge mobilities. As expected, OSCs with PBDB-T:PSM3 as the active layer achieve the highest power conversion efficiency of 6.71% among these three acceptors, which is the highest one in TPA-based acceptors and one of the best for the as-cast OSCs based on PDI derivatives.

High performance p-channel and ambipolar OFETs based on imidazo[4,5-f]-1,10-phenanthroline-triarylamines

A series of phenanthroline functionalized triarylamines (TAA) has been designed and synthesised to evaluate their OFET characteristics. Solution processed OFET devices have exhibited p-channel/ambipolar behaviour with respect to the substituents, in particular methoxyphenyl substitution resulted with highest mobility (μ h) up to 1.1 cm2 V-1 s-1 with good I on/off (106) ratio. These compounds can be potentially utilized for the fabrication of electronic devices.