How Do Amides Affect the Electronic Properties of Pyrene?

Carbon nanotube heterogenization improves cobalt pyridyldiimine complex CO2 reduction activity in aqueous carbonate buffer

We present two novel cobalt pyridyldiimine complexes functionalized with pyrene. Initially modest in homogeneous acetonitrile solution, their electrocatalytic CO2 reduction performance significantly improves upon immobilization on MWCNTs in an aqueous carbonate buffer. The complexes exhibit outstanding stability, with CO selectivity exceeding 97%, and TON and TOF values reaching up to 104 and above 1.2 s-1, respectively.

Photochemical Action Plots Reveal Red-shifted Wavelength-dependent Photoproduct Distributions

Photochemical action plots are a powerful tool for mapping photochemical reaction outcomes wavelength-by-wavelength. Typically, they map either the depletion of a reactant or the formation of a specific product as a function of wavelength. Herein, we exploit action plots to simultaneously map the formation of several photochemical products from a single chromophore. We demonstrate that the wavelength-resolved mapping of two reaction products formed during the irradiation of a chalcone species not only shows wavelength dependence - exhibiting the typical strong red-shift of the photochemical reactivity compared to the absorbance spectrum of the chromophore - but also a strong wavelength selectivity with remarkably different product distributions resulting from different irradiation wavelengths.

How Permanent Are the Permanent Macrodipoles of Anthranilamide Bioinspired Molecular Electrets?

Dipoles are ubiquitous, and their impacts on materials and interfaces affect many aspects of daily life. Despite their importance, dipoles remain underutilized, often because of insufficient knowledge about the structures producing them. As electrostatic analogues of magnets, electrets possess ordered electric dipoles. Here, we characterize the structural dynamics of bioinspired electret oligomers based on anthranilamide motifs. We report dynamics simulations, employing a force field that allows dynamic polarization, in a variety of solvents. The results show a linear increase in macrodipoles with oligomer length that strongly depends on solvent polarity and hydrogen-bonding (HB) propensity, as well as on the anthranilamide side chains. An increase in solvent polarity increases the dipole moments of the electret structures while decreasing the dipole effects on the moieties outside the solvation cavities. The former is due to enhancement of the Onsager reaction field and the latter to screening of the dipole-generated fields. Solvent dynamics hugely contributes to the fluctuations and magnitude of the electret dipoles. HB with the solvent weakens electret macrodipoles without breaking the intramolecular HB that maintains their extended conformation. This study provides design principles for developing a new class of organic materials with controllable electronic properties. An animated version of the TOC graphic showing a sequence of the MD trajectories of short and long molecular electrets in three solvents with different polarities is available in the HTML version of this paper.

The magic of biaryl linkers: the electronic coupling through them defines the propensity for excited-state symmetry breaking in quadrupolar acceptor-donor-acceptor fluorophores

Charge transfer (CT) is key for molecular photonics, governing the optical properties of chromophores comprising electron-rich and electron-deficient components. In photoexcited dyes with an acceptor-donor-acceptor or donor-acceptor-donor architecture, CT breaks their quadrupolar symmetry and yields dipolar structures manifesting pronounced solvatochromism. Herein, we explore the effects of electronic coupling through biaryl linkers on the excited-state symmetry breaking of such hybrid dyes composed of an electron-rich core, i.e., 1,4-dihydropyrrolo[3,2-b]pyrrole (DHPP), and pyrene substituents that can act as electron acceptors. Experimental and theoretical studies reveal that strengthening the donor-acceptor electronic coupling decreases the CT rates and the propensity for symmetry breaking. We ascribe this unexpected result to effects of electronic coupling on the CT thermodynamics, which in its turn affects the CT kinetics. In cases of intermediate electronic coupling, the pyrene-DHPP conjugates produce fluorescence spectra, spreading over the whole visible range, that in addition to the broad CT emission, show bands from the radiative deactivation of the locally excited states of the donor and the acceptors. Because the radiative deactivation of the low-lying CT states is distinctly slow, fluorescence from upper locally excited states emerge leading to the observed anti-Kasha behaviour. As a result, these dyes exhibit white fluorescence. In addition to demonstrating the multifaceted nature of the effects of electronic coupling on CT dynamics, these chromophores can act as broad-band light sources with practical importance for imaging and photonics.

Challenges in the Direct Detection of Chirality-induced Spin Selectivity: Investigation of Foldamer-based Donor-acceptor Dyads

Over the past two decades, the chirality-induced spin selectivity (CISS) effect was reported in several experiments disclosing a unique connection between chirality and electron spin. Recent theoretical works highlighted time-resolved Electron Paramagnetic Resonance (trEPR) as a powerful tool to directly detect the spin polarization resulting from CISS. Here, we report a first attempt to detect CISS at the molecular level by linking the pyrene electron donor to the fullerene acceptor with chiral peptide bridges of different length and electric dipole moment. The dyads are investigated by an array of techniques, including cyclic voltammetry, steady-state and transient optical spectroscopies, and trEPR. Despite the promising energy alignment of the electronic levels, our multi-technique analysis reveals no evidence of electron transfer (ET), highlighting the challenges of spectroscopic detection of CISS. However, the analysis allows the formulation of guidelines for the design of chiral organic model systems suitable to directly probe CISS-polarized ET.

Ultrafast sorting: Excimeric π-π stacking distinguishes pyrene-N-methylacetamide isomers on the ultrafast time scale

Pyrene based molecules are inclined to form excimers through self-association upon photoexcitation. In this work, the pyrene core is functionalized with the N-methylacetamide group at the position 1 or 2 to develop pyren-1-methylacetamide (PyMA1) and pyren-2-methylacetamide (PyMA2), respectively. Upon photoexcitation with 345 nm, a portion of molecules in PyMA1 and PyMA2 solutions at ≥1.0 mM have formed static excimers. The steady state spectroscopic measurements suggest that, whether it is the dimerization of molecules in the ground state (GS) or in excimer formation, characteristic signs are more pronounced in PyMA1 than its isomeric counterpart, PyMA2. The shift of the excimer band in their respective emission spectra suggests that the extent of overlap in π-π stacking is greater for PyMA1 than for PyMA2 in the excited state. The optimized geometry of dimers in toluene shows that the overlapping area between the pyrene moieties in π-π stacking between the dimers is greater for PyMA1 than for PyMA2 in GS. The natural bond orbital analysis with the optimized GS geometries shows that the stabilization/interaction energy between the dimers in π-π stacking is higher in PyMA1 compared to PyMA2 in toluene. The transient absorption (TA) measurements in toluene over the fs-ps regime (fs-TA) showed that the formation of static excimers with pre-associated dimers in PyMA1 happens in ∼700 fs whereas the excimers for the pre-associated dimers in PyMA2 have formed in slightly slower time scale (∼1.95 ps). Contrary to what was observed in solution, the extent of overlap in π-π stacking is lower for PyMA1 dimers (∼17%) than for PyMA2 dimers (∼37%) in single crystals.

Development of dipodal fluorescence sensor of iron for real samples based on pyrene modified anthracene

A novel pyrene modified anthracene dipodal sensor was prepared by a simple synthetic method for the sensitive determination of iron ions in real samples. The chemical characterization analyses including nuclear magnetic resonance spectroscopy, Fourier transform infrared spectroscopy, and matrix-assisted laser desorption/ionization time-of-flight mass spectrometry were carried out to characterize the target fluorescent sensor. Photophysical and electrochemical behaviors of the sensor were studied by the absorption, excitation-emission matrix analysis, steady-state fluorescence, three-dimensional fluorescence, and cyclic and square wave voltammetry, respectively. The fluorescent sensor properties were evaluated via Ultraviolet-visible and fluorescence spectroscopies. According to obtained results, the fluorescence signal of the sensor was selectively quenched with interaction with Fe³⁺ ions. The spectrofluorimetric determination of iron, in real water and medicine samples were successfully carried out under optimized experimental conditions. A detection limit and linear working range were calculated as 0.265 μM and 0.275-55.000 μM, respectively which demonstrated the ability of the simple and sensitive sensor for slight amounts of iron. The obtained detection limit for iron determination with the presented novel fluorescent sensor was less than nearly 20 times the tolerance limit (5.40 µM) in drinking water that was determined by the United States Environmental Protection Agency. The accuracy of the newly developed method was evaluated by Inductively coupled plasma optical emission spectroscopy and spike/recovery test which demonstrated that the developed fluorescent sensor has high accuracy for fast, easy and accessible determination of iron at 95% confidence level.

Making Nitronaphthalene Fluoresce

Nitroaromatic compounds are inherently nonfluorescent, and the subpicosecond lifetimes of the singlet excited states of many small nitrated polycyclic aromatic hydrocarbons, such as nitronaphthalenes, render them unfeasible for photosensitizers and photo-oxidants, despite their immensely beneficial reduction potentials. This article reports up to a 7000-fold increase in the singlet-excited-state lifetime of 1-nitronaphthalene upon attaching an amine or an N-amide to the ring lacking the nitro group. Varying the charge-transfer (CT) character of the excited states and the medium polarity balances the decay rates along the radiative and the two nonradiative pathways and can make these nitronaphthalene derivatives fluoresce. The strong electron-donating amine suppresses intersystem crossing (ISC) but accommodates CT pathways of nonradiate deactivation. Conversely, the N-amide does not induce a pronounced CT character but slows down ISC enough to achieve relatively long lifetimes of the singlet excited state. These paradigms are key for the pursuit of electron-deficient (n-type) organic conjugates with promising optical characteristics.

How does tautomerization affect the excited-state dynamics of an amino acid-derivatized corrole?

In the first two decades of the XXI century, corroles have emerged as an important class of porphyrinoids for photonics and biomedical photonics. In comparison with porphyrins, corroles have lower molecular symmetry and higher electron density, which leads to uniquely complementary properties. In macrocycles of free-base corroles, for example, three protons are distributed among four pyrrole nitrogens. It results in distinct tautomers that have different thermodynamic energies. Herein, we focus on the excited-state dynamics of a corrole modified with L-phenylalanine. The tautomerization in the singlet-excited state occurs in the timescales of about 10-100 picoseconds and exhibits substantial kinetic isotope effects. It, however, does not discernably affect nanosecond deactivation of the photoexcited corrole and its basic photophysics. Nevertheless, this excited-state tautomerization dynamics can strongly affect photoinduced processes with comparable or shorter timescales, considering the 100-meV energy differences between the tautomers in the excited state. The effects on the kinetics of charge transfer and energy transfer, initiated prior to reaching the equilibrium thermalization of the excited-state tautomer population, can be indeed substantial. Such considerations are crucially important in the design of systems for artificial photosynthesis and other forms of energy conversion and charge transduction.

Structural design of pyrene-functionalized TEMPO-containing polymers for enhanced electrochemical storage performance

We demonstrate the importance of rational structural design of pyrene-functionalized radical (i.e. 2,2,6,6-tetramethyl-1-piperidinyloxy, TEMPO) copolymers for enhanced electrochemical performance by providing insightful guidance for designing high-performance polymer-based electrodes for energy storage applications.

Multifaceted aspects of charge transfer

Charge transfer and charge transport are by far among the most important processes for sustaining life on Earth and for making our modern ways of living possible. Involving multiple electron-transfer steps, photosynthesis and cellular respiration have been principally responsible for managing the energy flow in the biosphere of our planet since the Great Oxygen Event. It is impossible to imagine living organisms without charge transport mediated by ion channels, or electron and proton transfer mediated by redox enzymes. Concurrently, transfer and transport of electrons and holes drive the functionalities of electronic and photonic devices that are intricate for our lives. While fueling advances in engineering, charge-transfer science has established itself as an important independent field, originating from physical chemistry and chemical physics, focusing on paradigms from biology, and gaining momentum from solar-energy research. Here, we review the fundamental concepts of charge transfer, and outline its core role in a broad range of unrelated fields, such as medicine, environmental science, catalysis, electronics and photonics. The ubiquitous nature of dipoles, for example, sets demands on deepening the understanding of how localized electric fields affect charge transfer. Charge-transfer electrets, thus, prove important for advancing the field and for interfacing fundamental science with engineering. Synergy between the vastly different aspects of charge-transfer science sets the stage for the broad global impacts that the advances in this field have.

Biomimetic and bioinspired molecular electrets. How to make them and why does the established peptide chemistry not always work?

“Biomimetic” and “bioinspired” define different aspects of the impacts that biology exerts on science and engineering. Biomimicking improves the understanding of how living systems work, and builds tools for bioinspired endeavors. Biological inspiration takes ideas from biology and implements them in unorthodox manners, exceeding what nature offers. Molecular electrets, i.e. systems with ordered electric dipoles, are key for advancing charge-transfer (CT) science and engineering. Protein helices and their biomimetic analogues, based on synthetic polypeptides, are the best-known molecular electrets. The inability of native polypeptide backbones to efficiently mediate long-range CT, however, limits their utility. Bioinspired molecular electrets based on anthranilamides can overcome the limitations of their biological and biomimetic counterparts. Polypeptide helices are easy to synthesize using established automated protocols. These protocols, however, fail to produce even short anthranilamide oligomers. For making anthranilamides, the residues are introduced as their nitrobenzoic-acid derivatives, and the oligomers are built from their C- to their N-termini via amide-coupling and nitro-reduction steps. The stringent requirements for these reduction and coupling steps pose non-trivial challenges, such as high selectivity, quantitative yields, and fast completion under mild conditions. Addressing these challenges will provide access to bioinspired molecular electrets essential for organic electronics and energy conversion.