Preparation of BiOI-Functionalized ZnO Nanorods for Ppb-Level NO2 Detection at Room Temperature

Heatwave enhance the adaptability of Chlorella pyrenoidosa to zinc oxide nanoparticles: Regulation of interfacial interactions and metabolic mechanisms

Wide application of zinc oxide nanoparticles (ZnO NPs) and increasing frequency of heatwaves (HWs) have posed a great threat to freshwater ecosystems, while phytotoxicity of ZnO NPs mediated by HWs remains unclear. This study aims to link the physiological responses, bio-nano interactions, and metabolic mechanisms of Chlorella pyrenoidosa with ZnO NPs under heat stress. Results demonstrated a temperature-dependent growth inhibition against ZnO NPs, with a higher reduction of growth rate at 24 °C than 28 °C. Accompanied with lower reactive oxidative stress and cell damage at 28 °C, our results indicated that HW could enhance the adaptability of C. pyrenoidosa to ZnO NPs stress. Furthermore, HW induced the variation of algal surface properties, altered interfacial interactions in the bio-nano system, and decreased cellular Zn uptake. Metabolomics analysis supported the temperature-dependent influences of ZnO NPs on C. pyrenoidosa. The phytotoxicity of ZnO NPs was associated with the disturbance of amino acids, fatty acids, and energy metabolic processes, which were mitigated under HW condition, enhancing the responsiveness of algae to the adverse effects. These results emphasize the importance of taking the impacts of HWs into account when evaluating the environmental risks of ZnO NPs.

Far-field femtosecond laser-driven λ/73 super-resolution fabrication of 2D van der Waals NbOI2 nanostructures in ambient air

The design and fabrication of ultrafine nanostructures in two-dimensional (2D) van der Waals materials are crucial for the functionalization of electronic devices. Here, we report the utilization of far-field femtosecond laser patterning to fabricate super-resolution nano-groove array (NGA) structures in 2D multilayer NbOI2 in ambient air, achieving groove widths as low as ~14.5 nm (~λ/73). The NGA structures maintain a well-defined single-crystal NbOI2 with amorphous Nb2O5 edges as narrow as 3.2 nm. The formation mechanism of NGA structure is confirmed to be associated with the coupled field of surface plasmon polariton periodic field and nano-groove-induced local near-field induced by femtosecond laser irradiation. Furthermore, the NGA-NbOI2 gas sensor exhibits NO2 sensing performance, with a rapid response time (5.1 s), which is attributed to the existence of abundant NbOI2-Nb2O5 heterojunctions. This approach will propel the further development of nano-lithography techniques for functional device applications of 2D materials.

Uniform Nanocrystal Spatial Distribution-Enhanced SnO2-based Sensor for High-Sensitivity Hydrogen Detection

Hydrogen (H2) is colorless, odorless, and has a wide explosive concentration range (4-75 vol %), making rapid and accurate detection of hydrogen leaks essential. This paper demonstrates a method to modify the spatial distribution of nanocrystals (NCs) by adding surfactants to improve the sensing performance. In order to explore its potential for H2 gas-sensing applications, SnO2, containing different mass percentages of PdCu NCs, was dispersed. The results show that the 0.1 wt % PdCu-SnO2 sensor based on surfactant dispersion performs well, with a response to 0.1 vol % H2 that is 18 times higher than that of the undispersed 0.1 wt % PdCu-SnO2 sensor. The enhanced gas-sensing ability after dispersion can be attributed to the fact that the uniform distribution of NCs generates higher quantum efficiency and exposes more active sites on the carrier surface compared to nonuniform distribution. This study provides a simple, novel, and effective method to improve the sensor response.

Ppb-level unsymmetrical dimethylhydrazine detection based on In2O3 hollow microspheres with Nd doping

As one of main high-energy fuels for rocket launching, unsymmetrical dimethylhydrazine (UDMH) and its decomposition products do harm to environment and human health. It is significant to develop a device to monitor its leakage. In this work, a UDMH gas sensor based on In2O3 hollow microspheres with Nd dopant was fabricated. The pure, 1.0 mol%, 3.0 mol% and 5.0 mol% Nd doped In2O3 were synthesized via one-step solvothermal method. Among them, 3.0% Nd-In2O3 based sensor exhibits the highest response toward UDMH vapor. Its response value to 100 ppm UDMH is 183.3 at optimal working temperature of 250 °C, 6.8 times higher than that of pure In2O3 (26.8). Besides high response to UDMH, the 3% Nd-In2O3 based sensor represents excellent selectivity, rapid response speed (2 s) and ultra-low theoretical LOD to UDMH (0.28 ppb). The improved gas sensing performance via Nd doping could be attributed to the enhanced specific surface area, increased concentration of adsorbed oxygen and improved adsorption capacity for UDMH molecular on the surface. The excellent sensing performance of Nd doped In2O3 hollow microspheres makes it a promising candidate for real-time UDMH detection.

Construction of a CoNiHHTP MOF/PHI Z-Scheme Heterojunction for ppb Level NO2 Photoelectric Sensing with 405 nm Irradiation at RT

Ultrasensitive photoelectric detection of nitrogen dioxide (NO2) with PHI under visible light irradiation at room temperature (RT) remains an ongoing challenge due to the low charge separation and scarce adsorption sites. In this work, a dimensionally matched ultrathin CoNiHHTP MOF/PHI Z-scheme heterojunction is successfully constructed by taking advantage of the π-π interactions existing between the CoNiHHTP MOF and PHI. The amount-optimized heterojunction possesses a record detection limit of 1 ppb (response = 15.6%) for NO2 under 405 nm irradiation at RT, with reduced responsive (3.6 min) and recovery (2.7 min) times, good selectivity and reversibility, and long-time stability (150 days) compared with PHI, even superior to others reported at RT. Based on the time-resolved photoluminescence spectra, in situ X-ray photoelectron spectra, and diffuse reflectance infrared Fourier transform spectroscopy results, the resulting sensing performance is attributed to the favorable Z-scheme charge transfer and separation. Moreover, the Ni nodes favorably present in adjacent metal sites between the lamellae contribute to charge transfer and redistribution, whereas Co nodes could act as selective centers for promoted adsorption of NO2. Interestingly, it is confirmed that the CoNiHHTP MOF/PHI heterojunction could effectively reduce the influence of O2 in the gas-sensitive reaction due to their unique bimetallic (Co and Ni) nodes, which is also favorable for the improved sensing performances for NO2. This work provides a feasible strategy to develop promising PHI-based optoelectronic gas sensors at RT.

Mesoporous and Encapsulated In2O3/Ti3C2Tx Schottky Heterojunctions for Rapid and ppb-Level NO2 Detection at Room Temperature

Rapid and ultrasensitive detection of toxic gases at room temperature is highly desired in health protection but presents grand challenges in the sensing materials reported so far. Here, we present a gas sensor based on novel zero dimensional (0D)/two dimensional (2D) indium oxide (In2O3)/titanium carbide (Ti3C2Tx) Schottky heterostructures with a high surface area and rich oxygen vacancies for parts per billion (ppb) level nitrogen dioxide (NO2) detection at room temperature. The In2O3/Ti3C2Tx gas sensor exhibits a fast response time (4 s), good response (193.45% to 250 ppb NO2), high selectivity, and excellent cycling stability. The rich surface oxygen vacancies play the role of active sites for the adsorption of NO2 molecules, and the Schottky junctions effectively adjust the charge-transfer behavior through the conduction tunnel in the sensing material. Furthermore, In2O3 nanoparticles almost fully cover the Ti3C2Tx nanosheets which can avoid the oxidation of Ti3C2Tx, thus contributing to the good cycling stability of the sensing materials. This work sheds light on the sensing mechanism of heterojunction nanostructures and provides an efficient pathway to construct high-performance gas sensors through the rational design of active sites.

Pd@Pt Core-Shell Nanocrystal-Decorated ZnO Nanosheets for ppt-Level NO2 Detection

Bimetallic nanocrystals (NCs) have obtained significant attention due to their unique advantages of the intrinsic properties of individual metals and synergistic enhancements resulting from the electronic coupling between two constituent metals. In this work, Pd@Pt core-shell NCs were prepared through a facile one-pot solution-phase method, which had excellent dispersion and uniform size. Concurrently, ZnO nanosheets were prepared via a hydrothermal method. To explore their potential in nitrogen dioxide (NO2) gas sensing applications, sensitive materials based on ZnO nanosheets with varying mass percentages of Pd@Pt NCs were generated through an impregnation process. The sensor based on 0.3 wt % Pd@Pt-ZnO exhibited remarkable performance, demonstrating a substantial response (Rg/Ra = 60.3) to 50 ppb of NO2 at a low operating temperature of 80 °C. Notably, this sensor reached an outstanding low detection limit of 300 ppt. The enhancement in gas sensing capabilities can be attributed to the sensitization and synergistic effects imparted by the exceptional catalytic activity of Pd@Pt NCs, which significantly promoted the reaction. This research introduces a novel approach for the utilization of core-shell structured bimetallic nanocrystals as modifiers in metal-oxide-semiconductor (MOS) materials for NO2 detection.

Potential application of bismuth oxyiodide (BiOI) when it meets light

Bismuth oxyiodide (BiOI) is a kind of typical two-dimensional (2D) material that has been increasingly developed alongside other 2D materials such as graphene, MXenes, and transition-metal dichalcogenide. However, its potential applications have not been widely whispered compared to those of other 2D materials. Using its distinctive properties, BiOI can be used for various applications, especially when it meets sunlight and other light-related electromagnetic waves. In this present review, we discuss the developments of BiOI and challenges in the applications for photodetector and light-assisted sensors, photovoltaic devices, optoelectronic logic devices, as well as photocatalysts. We start the discussion with a basic understanding and development of BiOI, crystal structure, and its properties. The synthesis and further development, such as green synthesis and its challenges in the synthesis-suited industry, as well as device integration, are also explained together with a plausible strategy to enhance the feasibility of BiOI for those various applications. We believe that the provided discussion and perspectives will not only promote BiOI to be one of the highly considered 2D materials but can also assist recent graduates in any materials science discipline and inform the senior scientists and industrial-based stakeholders of the latest advances in bismuth oxide and mixed-anion compounds.

Adsorption of NO2, NO, NH3, and CO on Noble Metal (Rh, Pd, Ag, Ir, Pt, Au)-Modified Hexagonal Boron Nitride Monolayers: A First-Principles Study

To investigate the application of modified hexagonal boron nitride (h-BN) in the detection and monitoring of harmful gases (NO2, NO, NH3, and CO), first-principles calculations are applied to study the geometric structure and electronic behavior of the adsorption system. In this paper, the four adsorption sites, namely, B, N, bridge, and hollow sites, are considered to explore the stable adsorption structure of metals (M = Rh, Pd, Ag, Ir, Pt, and Au) on the BN surface. The calculation results demonstrate that the geometric structures of metal at the N-site are relatively stable. Subsequently, the different adsorption structures of NO2, NO, NH3, and CO on M-BN are researched. The electron transfer, charge difference density, and work function of the stable adsorption structure are calculated. The results show that NO2, NO, and CO have the strongest adsorption capacity in the Ir-BN system, with adsorption energies of -2.705, -5.064, and -3.757 eV, respectively. The Pt-BN system has an excellent adsorption performance (-2.251 eV) for NH3. Compared with the M-BN system, the work function of the adsorption system increases after adsorbing NO2, while it decreases after adsorbing NH3. This work shows that h-BN with metal modification is a potential material for online monitoring of harmful gases.