Determination of Catecholamines by Capillary Electrophoresis and Reversed-Phase High-Performance Liquid Chromatography

Amperometric Biosensor Based on Laccase Enzyme, Gold Nanoparticles, and Glutaraldehyde for the Determination of Dopamine in Biological and Environmental Samples

The present work reports the development and application of an amperometric biosensor based on carbon paste electrode modified with laccase enzyme, glutaraldehyde, and gold nanoparticles (Lac-Glu-AuNPs/CPE) for the determination of the neurotransmitter dopamine (DA). The materials were characterized morphologically and chemically using scanning electron microscopy (SEM), transmission electron microscopy (TEM), and cyclic voltammetry. Optimization studies were performed in order to determine the optimal amount of enzyme and pH level that can yield the best conditions of analysis. The application of the biosensor in optimal conditions using the amperometric technique yielded a linear concentration range of 8.0 × 10−7–6.2 × 10−5 mol L−1 with a limit of detection of 6.0 × 10−8 mol L−1. The proposed biosensor was successfully applied for the determination of DA in biological and environmental samples. In addition, the application of the biosensor for the conduct of electrochemical measurements showed that the sensing device has good repeatability and stability, and it does not suffer from matrix interference effects. The proposed biosensor exhibited an analytical signal of 85% after 10 days of consecutive use.

Differential pulse voltammetry and chronoamperometry as analytical tools for epinephrine detection using a tyrosinase-based electrochemical biosensor

The main goal of the presented study was to design a biosensor-based system for epinephrine (EP) detection using a poly-thiophene derivative and tyrosinase as a biorecognition element. We compared two different electroanalytical techniques to select the most prominent technique for analyzing the neurotransmitter. The prepared biosensor system exhibited good parameters; the differential pulse (DPV) technique presented a wide linear range (1–20 μM and 30–200 μM), with a low detection limit (0.18 nM and 1.03 nM). In the case of chronoamperometry (CA), a high signal-to-noise ratio and lower reproducibility were observed, causing a less broad linear range (10–200 μM) and a higher detection limit (125 nM). Therefore, the DPV technique was used for the calculation of sensitivity (0.0011 μA mM⁻¹ cm⁻²), stability (49 days), and total surface coverage (4.18 × 10⁻¹² mol cm⁻²). The biosensor also showed very high selectivity in the presence of common interfering species (i.e. ascorbic acid, uric acid, norepinephrine, dopamine) and was successfully applied for EP determination in a pharmaceutical sample.

GCE/poly-4,4′-bBT/tyrosinase biosensor for epinephrine was constructed. Comparison of differential pulse voltammetry (DPV) and chronoamperometry was performed. DPV showed more reproducible results giving high selectivity, sensitivity, stability.

Carbon-Based Quantum Dots for Electrochemical Detection of Monoamine Neurotransmitters-Review

Imbalance in the levels of monoamine neurotransmitters have manifested in severe health issues. Electrochemical sensors have been designed for their determination, with good sensitivity recorded. Carbon-based quantum dots have proven to be an important component of electrochemical sensors due to their high conductivity, low cytotoxicity and opto-electronic properties. The quest for more sensitive electrodes with cheaper materials led to the development of electrochemical sensors based on carbon-based quantum dots for the detection of neurotransmitters. The importance of monoamine neurotransmitters (NTs) and the good electrocatalytic activity of carbon and graphene quantum dots (CQDs and GQDs) make the review of the efforts made in the design of such sensors for monoamine NTs of huge necessity. The differences and the similarities between these two quantum dots are highlighted prior to a discussion of their application in electrochemical sensors over the last ten years. Compared to other monoamine NTs, dopamine (DA) was the most studied with GQDs and CQD-based electrochemical sensors.

Ultrasensitive detection of hydrogen peroxide and dopamine using copolymer-grafted metal-organic framework based electrochemical sensor

We reported the synthesis of a copolymer- and metal-organic framework-based electrochemical sensor, UiO-66-NH₂@P(ANI-co-ANA) using the polymerization method for the highly sensitive and selective detection of hydrogen peroxide (H₂O₂) and dopamine (DA). The as-synthesized material was characterized via Fourier transform infrared spectroscopy, X-ray diffraction analysis, scanning electron microscopy, transmission electron microscopy, X-ray photoelectron spectroscopy, and thermogravimetric analysis. The electrochemical characteristics of the proposed sensor were evaluated via impedance spectroscopy and cyclic voltammetry (CV). The electrochemical oxidation of DA and the reduction of H₂O₂ were determined via CV, square-wave voltammetry, and chronoamperometric techniques. The fabricated sensor exhibited a wide linear range of 25-500 μM, with a sensitivity of 1396.1 μAμM^-1cm^-2 and a limit of detection of 0.6 μM, for the electrochemical reduction of H₂O₂. Additionally, it exhibited a wide linear range of 10-110 μM, with a sensitivity of 1110.2 μAμM^-1cm^-2 and a limit of detection of 0.3 μM, for the electrochemical detection of DA. The practical utility of the fabricated sensor was evaluated via the detection of H₂O₂ in milk samples and DA in human urine samples.

Fluorescence Sensing Platforms for Epinephrine Detection Based on Low Temperature Cofired Ceramics

A novel fluorescence-sensing pathway for epinephrine (EP) detection was investigated. The ceramic-based miniature biosensor was developed through the immobilization of an enzyme (laccase, tyrosinase) on a polymer—poly-(2,6-di([2,2′-bithiophen]-5-yl)-4-(5-hexylthiophen-2-yl)pyridine), based on low temperature cofired ceramics technology (LTCC). The detection procedure was based on the oxidation of the substrate, i.e., in the presence of the enzyme. An alternative enzyme-free system utilized the formation of a colorful complex between Fe²⁺ ions and epinephrine molecules. With the optimized conditions, the analytical performance illustrated high sensitivity and selectivity in a broad linear range with a detection limit of 0.14–2.10 nM. Moreover, the strategy was successfully used for an EP injection test with labeled pharmacological samples.

Enzymatic Platforms for Sensitive Neurotransmitter Detection

A convenient electrochemical sensing pathway was investigated for neurotransmitter detection based on newly synthesized silole derivatives and laccase/horseradish-peroxidase-modified platinum (Pt)/gold (Au) electrodes. The miniature neurotransmitter's biosensors were designed and constructed via the immobilization of laccase in an electroactive layer of the Pt electrode coated with poly(2,6-bis(3,4-ethylenedioxythiophene)-4-methyl-4-octyl-dithienosilole) and laccase for serotonin (5-HT) detection, and a Au electrode modified with the electroconducting polymer poly(2,6-bis(selenophen-2-yl)-4-methyl-4-octyl-dithienosilole), along with horseradish peroxidase (HRP), for dopamine (DA) monitoring. These sensing arrangements utilized the catalytic oxidation of neurotransmitters to reactive quinone derivatives (the oxidation process was provided in the enzymes' presence). Under the optimized conditions, the analytical performance demonstrated a convenient degree of sensitivity: 0.0369 and 0.0256 μA mM-1 cm-2, selectivity in a broad linear range (0.1-200) × 10-6 M) with detection limits of ≈48 and ≈73 nM (for the serotonin and dopamine biosensors, respectively). Moreover, the method was successfully applied for neurotransmitter determination in the presence of interfering compounds (ascorbic acid, L-cysteine, and uric acid).

Selective extraction and determination of catecholamines in urine samples by using a dopamine magnetic molecularly imprinted polymer and capillary electrophoresis

A rapid and selective method for the extraction and determination of catecholamines (CLs) from urine samples has been successfully developed using a magnetic molecularly imprinted polymer (MMIP) as a sorbent material. The MMIP has been prepared using dopamine hydrochloride (DA) as template molecule, methacrylic acid (MAA) as functional monomer, ethylene glycol dimethacrylate (EDMA) as cross-linking agent and Fe(3)O(4) magnetite as magnetic component. The extraction was carried out by stirring urine samples with the magnetic polymer. When the extraction was completed, the MMIP, together with the captured analytes, was easily separated from the sample matrix by an adscititious magnet. The analytes desorbed from the MMIP were determined by capillary electrophoresis (CE). It was shown that the MMIP had high affinity and selectivity toward DA and other structurally related CLs such as 3-methoxytyramine hydrochloride (MT), DL-normetanephrine hydrochloride (NME), DL-norephinephrine hydrochloride (NE) and (±) epinephrine (E). Different parameters affecting the extraction efficiency were evaluated in order to achieve the optimal pre-concentration of the analytes and to reduce non-specific interactions. Under the optimal conditions, the CL limits of detection were at the 0.04-0.06 μM range. The relative standard deviations of migration time and response ranged from 0.7% to 1.4% and from 2.9% to 5.5%, respectively. The proposed method was successfully applied to determine CLs, including MT, NME, DA, NE and E in human urine samples.

Analysis of biologically active amines by CE

This paper provides an overview on the current status of the analysis of biogenic amines by CE. The basic CE separation and detection strategies for the analysis of biogenic amines are briefly described. CZE and MEKC that provide highly efficient and reproducible analysis of biogenic amines are particularly surveyed. With respect to the detection of biogenic amines, we focus on LIF, UV-visible absorption, electrochemiluminescence, and MS. Derivatization strategies, indirect methods, and on-line concentration techniques such as field-amplified sample stacking, sweeping, and use of polymer solution are described. To show the practicality of CE, we highlight currently developed techniques for the determinations of biogenic amines in biological samples, including foods, beverages, cerebrospinal fluids, urine, and single cells.

Strategies for enantioseparations of catecholamines and structurally related compounds by capillary zone electrophoresis using sulfated β-cyclodextrins as chiral selectors

Strategies for simultaneous enantioseparations of three catecholamines (DL-norepinephrine, DL-epinephrine, and DL-isoproterenol) and three structurally related compounds (DL-octopamine, DL-synephrine, and DL-norephedrine) by CZE using sulfated beta-CDs as chiral selectors were investigated. Four different separation modes were attempted: (I) using randomly sulfate-substituted beta-CD (MI-S-beta-CD) at relatively low concentrations in a high-concentration phosphate buffer at low pH in the normal polarity mode, (II) using MI-S-beta-CD at high concentrations at low pH in the reversed polarity mode, (III) using MI-S-beta-CD at moderately high concentrations in a phosphate buffer at neutral pH in the normal polarity mode, and (IV) using the single isomer heptakis(2,3-dihydroxy-6-O-sulfo)-beta-CD (SI-S-beta-CD) at low to moderately high concentrations in a high-concentration BGE at low pH in the normal polarity mode. Among them, enantioseparation of these cationic solutes was best achieved under the conditions of mode (II). In mode (II) and mode (III), temperature is an important factor affecting the enantioresolution of norepinephrine. In mode (I) and mode (IV), the use of a high-concentration BGE (150-200 mM) is crucial for effective enantioseparation of these cationic solutes with sulfated beta-CDs. Comparative studies of enantioseparations of these cationic solutes with MI-S-beta-CD and SI-S-beta-CD reveal that the sulfate substituents of MI-S-beta-CD located at the C(2)- position interact strongly with the diol moiety of catecholamines.

Enzymatic sensitivity enhancement of biogenic monoamines on a chip

Detection of biogenic monoamines in nanomolar concentrations is of great importance for probing the brain chemistry and for their analytics in biological fluids. The sensitivity enhancement of amperometric detection of neurotransmitters (NTs) and their metabolites after their electrophoretic separation on a microchip is presented and is based on coupled enzymatic reactions. The current response of the analyte is amplified by cyclic oxidation on a gold electrode mediated by reduced nicotinamide dinucleotide coenzyme and glucose oxidase enzyme present in the electrophoresis buffer. Using this approach, detection limits of about 10 nM for NTs and their metabolites can be reached.