Surface-Enhanced Impulsive Coherent Vibrational Spectroscopy

Strong Surface-Enhanced Coherent Phonon Generation in van der Waals Materials

Terahertz (THz) coherent phonons have emerged as promising candidates for the next generation of high-speed, low-energy information carriers in atomically thin phononic or phonon-integrated on-chip devices. However, effectively manipulating THz coherent phonons remains a significant challenge. In this study, we investigated THz coherent phonon generation in exfoliated van der Waals (vdW) flakes of Fe3GeTe2, Fe5GeTe2, and FePS3. We successfully generated the THz A1g coherent phonon mode in these vdW flakes. An innovative approach involved partially exfoliating vdW flakes on a gold substrate and partially on a silicon (Si) substrate to compare the THz coherent phonon generation between both sides. Interestingly, we observed a significantly enhanced THz coherent phonon in the vdW/gold area compared with that in the vdW/Si area. Frequency-domain Raman mapping across the vdW flakes corroborated these findings. Numerical simulations further indicated a stronger enhanced surface field in vdW/gold structures than in vdW/Si structures. Consequently, we attribute the observed enhancement in THz coherent phonon generation to the increased surface field on the gold substrate. This enhancement was consistent across the three different vdW materials studied, suggesting the universality of this strategy. Our results hold promise for advancing the design of THz phononic and phonon-integrated devices.

Advanced time-resolved absorption spectroscopy with an ultrashort visible/near IR laser and a multi-channel lock-in detector

Ultrashort visible-near infrared (NIR) pulse generation and its applications to ultrafast spectroscopy are discussed. Femtosecond pulses of around 800 nm from a Ti:sapphire laser are used as a pump of an optical parametric amplifier (OPA) in a non-collinear configuration to generate ultrashort visible (500-780 nm) pulses and deep-ultraviolet (DUV, 259-282 nm) pulses. The visible-NIR pulses and DUV pulses were compressed to 3.9 fs and 10.4 fs, respectively, and used to elucidate various ultrafast dynamics in condensed matter with a sub-10 fs resolution by pump-probe measurements. We have also developed a 128-channel lock-in amplifier. The combined system of the world-shortest visible pulse from the OPA and the lock-in amplifier with the world-largest channel-number can clarify the sub-10 fs-dynamics in condensed matter. This system clarified structural changes in an excited state, reaction intermediate, and a transition state. This is possible even during molecular vibration and reactions via a real-time-resolved vibronic spectrum, which provides molecular structural change information. Also, ultrafast dynamics in exotic materials like carbon nanotubes, topological insulators, and novel solar battery systems have been clarified. Furthermore, the carrier-envelope phase in the ultrashort pulse has been controlled and measured.

Tip-enhanced Raman spectroscopy for nanoscale probing of dynamic chemical systems

Dynamics are fundamental to all aspects of chemistry and play a central role in the mechanism and product distribution of a chemical reaction. All dynamic processes are influenced by the local environment, so it is of fundamental and practical value to understand the structure of the environment and the dynamics with nanoscale resolution. Most techniques for measuring dynamic processes have microscopic spatial resolution and can only measure the average behavior of a large ensemble of sites within their sampling volumes. Tip-enhanced Raman spectroscopy (TERS) is a powerful tool for overcoming this limitation due to its combination of high chemical specificity and spatial resolution that is on the nanometer scale. Adapting it for the study of dynamic systems remains a work in progress, but the increasing sophistication of TERS is making such studies more routine, and there are now growing efforts to use TERS to examine more complex processes. This Perspective aims to promote development in this area of research by highlighting recent progress in using TERS to understand reacting and dynamic systems, ranging from simple model reactions to complex processes with practical applications. We discuss the unique challenges and opportunities that TERS presents for future studies.

Time-Domain Observation of Surface-Enhanced Coherent Raman Scattering with 105-106 Enhancement

Combining surface-enhanced Raman scattering (SERS) with the coherent nonlinear Raman technique is a promising route for achieving higher sensitivity and time-resolved SERS measurements, yet such attempts have just been started. Here, we report time-domain Raman measurements of trans-1,2-bis(4-pyridyl)ethylene (BPE) adsorbed on gold nanoparticle assemblies (GNAs), which were carried out with impulsive stimulated Raman spectroscopy using sub-8 fs pulses. We observe coherent nuclear wavepacket motion of BPE on GNAs with drastic enhancement through the surface plasmon resonance, which provides information on the Raman-active vibrations in the time domain. Through Fourier transform of the measured time-domain Raman data, we obtained SERS spectra of BPE on GNAs with enhancement factors as high as 10⁵-10⁶. The present study not only demonstrates applicability of time-domain nonlinear Raman techniques in SERS, i.e., surface-enhanced impulsive stimulated Raman spectroscopy (SE-ISRS), but also provides a technical basis for femtosecond time-resolved SE-ISRS experiments to track ultrafast dynamics of the adsorbates.

Nonlinear pulse compression to 22 fs at 15.6 µJ by an all-solid-state multipass approach

We demonstrate nonlinear compression of pulses at 1.03 µm and repetition rate of 200 kHz generated by a ytterbium fiber laser using two cascaded all-solid-state multipass cells. The pulse duration has been compressed from 460 to 22 fs, corresponding to a compression factor of ∼21. The compressed pulse energy is 15.6 µJ, corresponding to an average power of 3.1 W, and the overall transmission of the two compression stages is 76%. The output beam quality factor is M² ∼1.2 and the excess intensity noise introduced by nonlinear broadening is below 0.05%. These results show that nonlinear pulse compression down to ultrashort durations can be achieved with an all-solid-state approach, at pulse energies much higher than previously reported, while preserving the spatial characteristics of the laser.

Amplitude-phase cross talk as a deterioration factor of signal-to-noise ratio in phase-detection noise-cancellation technique for spectral pump/probe measurements and compensation of the amplitude-phase cross talk

Noise cancellation of the light source is an important method to enhance the signal-to-noise ratio (SNR) and facilitate high-speed detection in pump/probe measurements. We developed a method to eliminate the noise for the multichannel spectral pump/probe measurements with a spectral dispersion of a white probe pulse light. In this method, the sample-induced intensity modulation is converted to the phase modulation of the pulse repetition irrespective of the intensity noise of the light source. The SNR is enhanced through the phase detection of the observed signal with the signal synchronized to the pulse repetition serving as the phase reference (synchronized signal). However, the shot-noise limited performance is not achieved with an intense probe light. In this work, we demonstrate that the performance limitation below the shot noise limit is caused by the amplitude-phase cross talk. It converts the amplitude noise into the phase noise and is caused by the space-charge effect in the photodetector, the reverse bias voltage drop across the load impedance, and the phase detection circuit. The phase delay occurs with an intense light at a PIN photodiode, whereas the phase is advanced in an avalanche photodiode. Although the amplitude distortion characteristics also reduce the performance, the distortion effect is equivalent to the amplitude-phase cross talk. We also propose possible ways to compensate the cross talk effect by using the phase modulation of the synchronized signal for the phase detection based on the instantaneous amplitude.

Universal route to optimal few- to single-cycle pulse generation in hollow-core fiber compressors

Gas-filled hollow-core fiber (HCF) pulse post-compressors generating few- to single-cycle pulses are a key enabling tool for attosecond science and ultrafast spectroscopy. Achieving optimum performance in this regime can be extremely challenging due to the ultra-broad bandwidth of the pulses and the need of an adequate temporal diagnostic. These difficulties have hindered the full exploitation of HCF post-compressors, namely the generation of stable and high-quality near-Fourier-transform-limited pulses. Here we show that, independently of conditions such as the type of gas or the laser system used, there is a universal route to obtain the shortest stable output pulse down to the single-cycle regime. Numerical simulations and experimental measurements performed with the dispersion-scan technique reveal that, in quite general conditions, post-compressed pulses exhibit a residual third-order dispersion intrinsic to optimum nonlinear propagation within the fiber, in agreement with measurements independently performed in several laboratories around the world. The understanding of this effect and its adequate correction, e.g. using simple transparent optical media, enables achieving high-quality post-compressed pulses with only minor changes in existing setups. These optimized sources have impact in many fields of science and technology and should enable new and exciting applications in the few- to single-cycle pulse regime.