Cadmium-Free Kesterite Thin-Film Solar Cells with High Efficiency Approaching 12

Cadmium sulfide (CdS) buffer layer is commonly used in Kesterite Cu2 ZnSn(S,Se)4 (CZTSSe) thin film solar cells. However, the toxicity of Cadmium (Cd) and perilous waste, which is generated during the deposition process (chemical bath deposition), and the narrow bandgap (≈2.4 eV) of CdS restrict its large-scale future application. Herein, the atomic layer deposition (ALD) method is proposed to deposit zinc-tin-oxide (ZTO) as a buffer layer in Ag-doped CZTSSe solar cells. It is found that the ZTO buffer layer improves the band alignment at the Ag-CZTSSe/ZTO heterojunction interface. The smaller contact potential difference of the ZTO facilitates the extraction of charge carriers and promotes carrier transport. The better p-n junction quality helps to improve the open-circuit voltage (VOC ) and fill factor (FF). Meanwhile, the wider bandgap of ZTO assists to transfer more photons to the CZTSSe absorber, and more photocarriers are generated thus improving short-circuit current density (Jsc). Ultimately, Ag-CZTSSe/ZTO device with 10 nm thick ZTO layer and 5:1 (Zn:Sn) ratio, Sn/(Sn + Zn): 0.28 deliver a superior power conversion efficiency (PCE) of 11.8%. As far as it is known that 11.8% is the highest efficiency among Cd-free kesterite thin film solar cells.

Cation Substitution in Earth-Abundant Kesterite Photovoltaic Materials

As a promising candidate for low-cost and environmentally friendly thin-film photovoltaics, the emerging kesterite-based Cu2ZnSn(S,Se)4 (CZTSSe) solar cells have experienced rapid advances over the past decade. However, the record efficiency of CZTSSe solar cells (12.6%) is still significantly lower than those of its predecessors Cu(In,Ga)Se2 (CIGS) and CdTe thin-film solar cells. This record has remained for several years. The main obstacle for this stagnation is unanimously attributed to the large open-circuit voltage (VOC) deficit. In addition to cation disordering and the associated band tailing, unpassivated interface defects and undesirable energy band alignment are two other culprits that account for the large VOC deficit in kesterite solar cells. To capture the great potential of kesterite solar cells as prospective earth-abundant photovoltaic technology, current research focuses on cation substitution for CZTSSe-based materials. The aim here is to examine recent efforts to overcome the VOC limit of kesterite solar cells by cation substitution and to further illuminate several emerging prospective strategies, including: i) suppressing the cation disordering by distant isoelectronic cation substitution, ii) optimizing the junction band alignment and constructing a graded bandgap in absorber, and iii) engineering the interface defects and enhancing the junction band bending.

Raman scattering quantitative assessment of the anion composition ratio in Zn(O,S) layers for Cd-free chalcogenide-based solar cells

This work reports the use of Raman scattering for the chemical characterization of Zn(O,S) layers that are being developed as a Cd-free alternative for the buffer layer in advanced chalcogenide solar cells.