Operando Identification of the Reversible Skin Layer on Co3O4 as a Three-Dimensional Reaction Zone for Oxygen Evolution

Co oxides and oxyhydroxides have been studied extensively in the past as promising electrocatalysts for the oxygen evolution reaction (OER) in neutral to alkaline media. Earlier studies showed the formation of an ultrathin CoO_x(OH)_y skin layer on Co₃O₄ at potentials above 1.15 V vs reversible hydrogen electrode (RHE), but the precise influence of this skin layer on the OER reactivity is still under debate. We present here a systematic study of epitaxial spinel-type Co₃O₄ films with defined (111) orientation, prepared on different substrates by electrodeposition or physical vapor deposition. The OER overpotential of these samples may vary up to 120 mV, corresponding to two orders of magnitude differences in current density, which cannot be accounted for by differences in the electrochemically active surface area. We demonstrate by a careful analysis of operando surface X-ray diffraction measurements that these differences are clearly correlated with the average thickness of the skin layer. The OER reactivity increases with the amount of formed skin layer, indicating that the entire three-dimensional skin layer is an OER-active interphase. Furthermore, a scaling relationship between the reaction centers in the skin layer and the OER activity is established. It suggests that two lattice sites are involved in the OER mechanism.

Integrated Bifunctional Electrodes Based on Amorphous Co-Ni-S Nanoflake Arrays with Atomic Dispersity of Active Sites for Overall Water Splitting

Fabrication of amorphous electrocatalysts without noble metals for cost-effective full water splitting is highly desired but remains a substantial challenge. In the present work, we report a facile strategy for exploring integrated bifunctional electrocatalysts based on amorphous cobalt/nickel sulfide nanoflake arrays self-supported on carbon cloth, by tailoring competitive coordination of metal ions between glucose and 2-aminoterephthalic acid. Ultrahigh dispersion of binary metal active sites with balanced atomic distribution enables the optimization of catalytic properties for both the oxygen evolution reaction (OER) and the hydrogen evolution reaction (HER) in an alkaline solution. The obtained catalyst exhibits remarkably enhanced OER and HER activities as compared with its oxide counterpart and analogues with different Co/Ni ratios. It requires overpotentials of 296 and 192 mV to deliver a current density of 10 mA cm^-2 for the OER and HER, respectively; it retains 96.6 and 96.9% activity after 32 h of OER and 36 h of HER tests at 10 mA cm^-2, respectively. As directly used an anode and a cathode in an alkaline electrolyzer, a low cell voltage of 1.60 V could endow a water splitting current of 10 mA cm^-2, outperforming the benchmark RuO₂ and Pt/C-based electrolyzer at 1.72 V@10 mA cm^-2. The current synthetic strategy may provide more opportunities for the design and direct synthesis of amorphous catalysts for overall water splitting and beyond.

Amorphous nickel tungstate films prepared by SILAR method for electrocatalytic oxygen evolution reaction

Development of electrocatalyst using facile way from non-noble metal compounds with high efficiency for effective water electrolysis is highly demanding for production of hydrogen energy. Nickel based electrocatalysts were currently developed for electrochemical water oxidation in alkaline pH. Herein, amorphous nickel tungstate (NiWO₄) was synthesized using the facile successive ionic layer adsorption and reaction method. The films were characterized by X-ray diffraction, Raman spectroscopy, Fourier transfer infrared spectroscopy, scanning electron microscopy, X-ray photoelectron spectroscopy, and transmission electron microscopy techniques. The electrochemical analysis showed 315 mV of overpotential at 100 mA cm^-2 with lowest Tafel slope of 32 mV dec^-1 for oxygen evolution reaction (OER) making films of NiWO₄ compatible towards electrocatalysis of water in alkaline media. The chronopotentiometry measurements at 100 mA cm^-2 over 24 h showed 97% retention of OER activity. The electrochemical active surface area (ECSA) of NW120 film was 25.5 cm^-2.

Amorphous cobalt–iron hydroxides as high-efficiency oxygen-evolution catalysts based on a facile electrospinning process

The first example of amorphous CoFe hydroxide based on the electrospinning process was developed, which was used as an efficient OER catalyst.

An Ultrasonication-Assisted Cobalt Hydroxide Composite with Enhanced Electrocatalytic Activity toward Oxygen Evolution Reaction

A catalyst toward oxygen evolution reaction (OER) was synthesized by depositing cobalt hydroxide on carbon black. Ultrasonication was applied during precipitation to improve the performance of the catalyst. The ultrasonic-assisted process resulted in the refinement of the cobalt hydroxide particles from 400 nm to 50 nm, and the thorough incorporation of these particles with carbon black substrate. The resulting product exhibited enhanced OER catalytic activity with an onset potential of 1.54 V (vs. reversible hydrogen electrode), a Tafel slope of 18.18 mV/dec, and a stable OER potential at a current density of 10 mA cm⁻², because of the reduced resistance of the catalyst and the electron transfer resistance.

Binary Transition-Metal Oxide Hollow Nanoparticles for Oxygen Evolution Reaction

Low-cost transition metal oxides are actively explored as alternative materials to precious metal-based electrocatalysts for the challenging multistep oxygen evolution reaction (OER). We utilized the Kirkendall effect allowing the formation of hollow polycrystalline, highly disordered nanoparticles (NPs) to synthesize highly active binary metal oxide OER electrocatalysts in alkali media. Two synthetic strategies were applied to achieve compositional control in binary transition metal oxide hollow NPs. The first strategy is capitalized on the oxidation of transition-metal NP seeds in the presence of other transition-metal cations. Oxidation of Fe NPs treated with Ni (+2) cations allowed the synthesis of hollow oxide NPs with a 1-4.7 Ni-to-Fe ratio via an oxidation-induced doping mechanism. Hollow Fe-Ni oxide NPs also reached a current density of 10 mA/cm² at 0.30 V overpotential. The second strategy is based on the direct oxidation of iron-cobalt alloy NPs which allows the synthesis of hollow Fe _xCo_{100- x}-oxide NPs where x can be tuned in the range between 36 and 100. Hollow Fe₃₆Co₆₄-oxide NPs also revealed the current density of 10 mA/cm² at 0.30 V overpotential in 0.1 M KOH.

Monitoring surface transformations of metal carbodiimide water oxidation catalysts by operando XAS and Raman spectroscopy

Chemical and structural transformations at the electrode surface of metal carbodiimides MNCN (M = Co, Ni, Mn, Cu), were studied by operando Raman and XAS spectroscopy during electrocatalytic water oxidation

Novel Co3O4 Nanoparticles/Nitrogen-Doped Carbon Composites with Extraordinary Catalytic Activity for Oxygen Evolution Reaction (OER)

Herein, Co₃O₄ nanoparticles/nitrogen-doped carbon (Co₃O₄/NPC) composites with different structures were prepared via a facile method. Structure control was achieved by the rational morphology design of ZIF-67 precursors, which were then pyrolyzed in air to obtain Co₃O₄/NPC composites. When applied as catalysts for the oxygen evolution reaction (OER), the M-Co₃O₄/NPC composites derived from the flower-like ZIF-67 showed superior catalytic activities than those derived from the rhombic dodecahedron and hollow spherical ZIF-67. The former M-Co₃O₄/NPC composite displayed a small over-potential of 0.3 V, low onset potential of 1.41 V, small Tafel slope of 83 mV dec^-1, and a desirable stability. (94.7% OER activity was retained after 10 h.) The excellent performance of the flower-like M-Co₃O₄/NPC composite in the OER was attributed to its favorable structure.

In situ evolution of highly dispersed amorphous CoOx clusters for oxygen evolution reaction

Electrocatalytic water splitting is a key technique to produce hydrogen fuels, which can be considered as an efficient strategy to store renewable energy. Oxygen evolution reaction (OER) that occurs at the anode side requires a four-electron transfer under highly oxidizing conditions. OER has a large overpotential and therefore determines the overall efficiency. Certain electrocatalysts can efficiently help to improve the reaction kinetics. Owing to the high cost of precious metals such as Pt, Ru, and Ir, non-precious metal oxide catalysts have been vigorously investigated under alkaline conditions. Herein, we synthesized novel highly dispersed amorphous CoO_xfor the first time in the form of a cluster favorable to enhance the OER activity using a facile method via the air dielectric barrier discharge (DBD) plasma. Compared with the pristine biopolymer-cobalt complex, the amorphous CoO_x cluster exhibits a much higher current density and a lower overpotential for OER, e.g., the overpotential of 290 mV at 10 mA cm^-2 and the overpotential of only 350 mV at 300 mA cm^-1. The excellent electrocatalytic OER activity was attributed to the unsaturated catalytic sites on the amorphous CoO_x cluster. In addition, we studied the reaction mechanism, and it was observed that pure O₂ DBD plasma could lead to the evolution of crystalline CoO_x; however, the presence of N₂ and O₂ in DBD plasma could ensure the facile evolution of amorphous CoO_x clusters. This study provides a new strategy to design amorphous materials for electrocatalysis and beyond.

Recent Advances in Ultrathin Two-Dimensional Nanomaterials

Since the discovery of mechanically exfoliated graphene in 2004, research on ultrathin two-dimensional (2D) nanomaterials has grown exponentially in the fields of condensed matter physics, material science, chemistry, and nanotechnology. Highlighting their compelling physical, chemical, electronic, and optical properties, as well as their various potential applications, in this Review, we summarize the state-of-art progress on the ultrathin 2D nanomaterials with a particular emphasis on their recent advances. First, we introduce the unique advances on ultrathin 2D nanomaterials, followed by the description of their composition and crystal structures. The assortments of their synthetic methods are then summarized, including insights on their advantages and limitations, alongside some recommendations on suitable characterization techniques. We also discuss in detail the utilization of these ultrathin 2D nanomaterials for wide ranges of potential applications among the electronics/optoelectronics, electrocatalysis, batteries, supercapacitors, solar cells, photocatalysis, and sensing platforms. Finally, the challenges and outlooks in this promising field are featured on the basis of its current development.

Transition-Metal (Co, Ni, and Fe)-Based Electrocatalysts for the Water Oxidation Reaction

Increasing energy demands and environment awareness have promoted extensive research on the development of alternative energy conversion and storage technologies with high efficiency and environmental friendliness. Among them, water splitting is very appealing, and is receiving more and more attention. The critical challenge of this renewable-energy technology is to expedite the oxygen evolution reaction (OER) because of its slow kinetics and large overpotential. Therefore, developing efficient electrocatalysts with high catalytic activities is of great importance for high-performance water splitting. In the past few years, much effort has been devoted to the development of alternative OER electrocatalysts based on transition-metal elements that are low-cost, highly efficient, and have excellent stability. Here, recent progress on the design, synthesis, and application of OER electrocatalysts based on transition-metal elements, including Co, Ni, and Fe, is summarized, and some invigorating perspectives on the future developments are provided.