Selective sensing of picric acid using a Zn(II)-metallacycle: experimental and theoretical validation of the sensing mechanism and quantitative analysis of sensitivity in contact mode detection

A combination of N,N',N''-tris(3-pyridyl)-1,3,5-benzenetricarboxamide (L1) and p-chlorobenzoic acid (HL2) with Zn(NO3)2·6H2O resulted in the formation of a dinuclear metallacycle [ZnL1(L2)2(DMF)2]2 (1(DMF)4). In 1(DMF)4, the Zn(II) centre adopts a square pyramidal geometry, while one of the pyridyl N out of the three pyridyl groups in L1 remained uncoordinated. Solvated DMF molecules are present in 1(DMF)4. The structural and chemical nature of 1(DMF)4 is effective for it to act as a potential fluorescent probe for the detection of nitroaromatic compounds. It is observed that the probe, 1(DMF)4, could selectively detect picric acid (PA) among various aromatic compounds in solution (DMSO), while the solid state (contact mode) detection showed a positive sensing response for the nitrophenols (PA: 87% quenching efficiency, 2,4-dinitrophenol (2,4-DNP): 57% quenching efficiency and 4-nitrophenol (4-NP): 40% quenching efficiency). The limit of detection (LOD) of PA by the probe in DMSO was found to be 6.8 × 10-11 M while the LOD in contact mode detection was estimated to be 0.49 ng cm-2. The mechanism of selective detection of PA by 1(DMF)4 in DMSO was analyzed through photophysical studies, 1H-NMR experiments and also by density functional theory (DFT) calculations. The effective overlap of the absorption spectrum of 1(DMF)4 and emission spectrum of PA in DMSO suggests that the Förster resonance energy transfer (FRET) is responsible for quenching phenomena in DMSO. The DFT calculations and molecular docking studies showed the adduct formation due to the favorable interactions between 1(DMF)4 and PA in DMSO, while negligible interactions were observed between 1(DMF)4 with other aromatic compounds. The experimental and DFT studies showed that the efficient sensing ability of PA by 1(DMF)4 in the solid-state was due to photoelectron transfer (PET) and FRET phenomena described herein.

Malonyl-based Chemosensors: Selective Detection of Fe3+ Ion in Aqueous Medium

Two novel malonyl-based chemosensors, N,N'-bis(ethyl-4'-benzoate)-1,3-propanediamide (1) and N,N'-bis(ethyl-3'-benzoate)-1,3-propanediamide (2), have been synthesized and screened towards various biologically important metal ions such as Na⁺, Mg²⁺, K⁺, Ca²⁺, Al³⁺, Cr³⁺, Mn²⁺, Fe²⁺, Fe³⁺, Co²⁺, Ni²⁺, Cu²⁺, Zn²⁺, Ag⁺, Cd²⁺, Hg²⁺, Ti³⁺, and Pb²⁺. The emission spectral studies of both 1 and 2 displayed 84 - 91% turn-off emission responses selectively with Fe³⁺ ion in aqueous buffer (MeCN/H₂O, 1:4, v/v, pH = 7.4) solution. Chemosensors 1 and 2 exhibited remarkable sensing ability towards Fe³⁺ ion over other metal ions with limit of detection (LOD) of 4.28 and 4.33 μM, respectively. The binding stoichiometry of 1 and 2 with Fe³⁺ ion was studied by Benesi-Hildebrand fitting, Stern-Volmer plot and Job's plots, revealing that both chemosensors (1 - 2) bind with Fe³⁺ metal ion in 1:1 stoichiometric ratio with the apparent association constant (K_a) 8.90 × 10³ and 11.16 × 10³ M^-1, respectively. Furthermore, the interactions of chemosensors (1 - 2) with metal ion were also investigated by using density functional theory (DFT) at B3LYP hybrid functional using 6-31G and LanL2DZ basis sets.

Development of a fused imidazo[1,2-a]pyridine based fluorescent probe for Fe3+ and Hg2+ in aqueous media and HeLa cells

A new fluorescent sensor 5 having fused imidazopyridine scaffold has been synthesized via cascade cyclization. It exhibits highly sensitive and selective detection of Fe³⁺ (‘turn-on’) and Hg²⁺ (‘turn-off’) in vitro and in HeLa cells.