Graphene platelet reinforced copper composites for improved tribological and thermal properties

The Effect of Copper-Graphene Composite Architecture on Thermal Transport Efficiency

This paper presents the results of molecular dynamic modeling, revealing that inserting confined graphene layers into copper crystal reduces the thermal conductivity of the whole composite, and the coefficient of thermal conductivity κ decreases upon an increase in the number of graphene layers. The injection of one, two, and three layers of 15 nm graphene leads to a change in the coefficient of thermal conductivity from 380 W/(m·K) down to 205.9, 179.1, and 163.6 W/(m·K), respectively. Decreasing the length of graphene layers leads to a decrease in the density of defects on which heat is dissipated. With one, two, and three layers of 8 nm graphene, the coefficient of thermal conductivity of the composite is equal to 272.6, 246.8, and 240.8 W/(m·K), appropriately. Meanwhile the introduction of an infinite graphene layer results in the growth of κ to 414.2-803.3 W/(m·K).

Evaluation of MWCNT Particles-Reinforced Magnesium Composite for Mechanical and Catalytic Applications

Aluminum, magnesium, and copper materials must have increased mechanical strength with enhanced wear and corrosion resistance. Substantial research focused on reinforcing hard particles into low-strength materials using stir casting or powder metallurgy. This work is intended to develop the magnesium hybrid matrix with the dispersion of boron carbide (B4C) and multiwall carbon nanotubes (MWCNTs). Hybrid magnesium composites are prepared, although the powder metallurgy route considers different process parameters. Statistical analysis such as Taguchi L16 orthogonal array is involved in this work. It is used to find the magnesium hybrid samples' minimum and maximum wear, corrosion, and microhardness levels. Powder metallurgy parameters are B4C (3%, 6%, 9%, and 12%), MWCNT (0.2%, 0.4%, 0.6%, and 0.8%), ball milling (1, 2, 3, and 4 h), and sintering (3, 4, 5, and 6 h). The ball milling parameters are extremely influenced in the wear test analysis. Minimum wear losses are obtained as 0.008 g by influencing the 4 h ball milling process. Similarly, 3 h of sintering time offered a minimum corrosion rate of 0.00078 mm/yr. In microhardness analysis, the percentage of MWCNTs is highly implicated in narrow hardness resulting in the hardness value of 181. The hardness value is recorded using 0.2% MWCNTs in the magnesium alloy AZ80.