Multivariate optimization of an ultrasound-assisted extraction procedure for the determination of Cu, Fe, Mn, and Zn in plant samples by flame atomic absorption spectrometry

Managing faba bean wilt disease through intercropping with wheat and reasonable nitrogen application: enhancing nutrient absorption and biochemical resistance in faba beans

Faba bean wilt disease is a key factor limiting its production. Intercropping of faba bean with wheat has been adopted as a prevalent strategy to mitigate this disease. Nitrogen fertilizer improves faba bean yield, yet wilt disease imposes limitations. However, faba bean-wheat intercropping is effective in controlling wilt disease. To investigate the effect of intercropping under varying nitrogen levels on the incidence of faba bean wilt disease, nutrient uptake, and biochemical resistance in faba bean. Field and pot experiments were conducted in two cropping systems: faba bean monocropping (M) and faba bean-wheat intercropping (I). At four nitrogen levels, we assessed the incidence rate of wilt disease, quantified nutrient uptake, and evaluated biochemical resistance indices of plants. The application of N decreased the incidence rate of wilt disease, with the lowest reduction observed in intercropping at the N2 level. N application at levels N1, N2, and N3 enhanced the content of N, P, K, Fe, and Mn as well as superoxide dismutase (SOD), phenylalanine ammonia lyase (PAL), and polyphenol oxidase (PPO) activities and defense gene expression in monocultured plants. Additionally, these levels increased the contents of total phenols, flavonoids, soluble sugars, and soluble proteins, and all reached their maximum in intercropping at the N2 level. The application of intercropping and N effectively controlled the occurrence of faba bean wilt disease by promoting nutrient absorption, alleviating peroxidation stress, and enhancing resistance in plants.

Supplementary Information

The online version contains supplementary material available at 10.1007/s12298-024-01466-1.

Microwave-assisted extraction based on emulsion breaking with natural deep eutectic solvent for vegetable oil sample preparation prior to elemental determination by ICP OES

This study presents a novel and efficient method for the extraction of Al, Ca, Cr, Cu, K, Mg, Mn, and Zn in vegetable oil samples using a Natural Deep Eutectic Solvent (NADES) as an extractor combined with microwave radiation (MW) in an emulsion system. The NADES prepared with choline chloride:oxalic acid:water (1:1:4 molar ratio) provided a high extraction rate using 5.0 mL of the sample, 1.7 mL of NADES, and 1.3 mL of Triton X-100. The optimum conditions were obtained with 36 s of vortexing, 5 min of extraction, and 10 s for emulsion-breaking in MW. Under these conditions, recoveries ranged from 91% to 110% and relative standard deviations <9.0% were obtained. The limit of quantification (mg kg-1) was: 0.018 (Al), 0.032 (Ca), 0.007 (Cr), 0.006 (Cu), 0.013 (K), 0.027 (Mg), 0.002 (Mn), and 0.019 (Zn). The proposed method showed comparable results to reference methods and advantages, such as speed, low cost, and simplicity. The combination of NADES and MW represents a sustainable and innovative approach to the elemental determination composition of vegetable oils and contributes to advances in sample preparation methods.

Individual and combined association between nutritional trace metals and the risk of preterm birth in a recurrent pregnancy loss cohort

Background

Recurrent pregnancy loss (RPL) was associated with an elevated risk of pregnancy complications, particularly preterm birth (PTB). However, the risk factors associated with PTB in RPL remained unclear. Emerging evidence indicated that maternal exposure to metals played a crucial role in the development of PTB. The objective of our study was to investigate the individual and combined associations of nutritional trace metals (NTMs) during pregnancy with PTB in RPL.

Methods

Using data from a recurrent pregnancy loss cohort (n = 459), propensity score matching (1:3) was performed to control for covariates. Multiple logistic regression and multiple linear regression were employed to identify the individual effects, while elastic-net regularization (ENET) and Bayesian kernel machine regression (BKMR) were used to examine the combined effects on PTB in RPL.

Results

The logistic regression model found that maternal exposure to copper (Cu) (quantile 4 [Q4] vs. quantile 1 [Q1], odds ratio [OR]: 0.21, 95% confidence interval [CI]: 0.05, 0.74) and zinc (Zn) (Q4 vs. Q1, OR: 0.19, 95%CI: 0.04, 0.77) was inversely associated with total PTB risk. We further constructed environmental risk scores (ERSs) using principal components and interaction terms derived from the ENET model to predict PTB accurately (p < 0.001). In the BKMR model, we confirmed that Cu was the most significant component (PIP = 0.85). When other metals were fixed at the 25th and 50th percentiles, Cu was inversely associated with PTB. In addition, we demonstrated the non-linear relationships of Zn with PTB and the potential interaction between Cu and other metals, including Zn, Ca, and Fe.

Conclusion

In conclusion, our study highlighted the significance of maternal exposure to NTMs in RPL and its association with PTB risk. Cu and Zn were inversely associated with PTB risk, with Cu identified as a crucial factor. Potential interactions between Cu and other metals (Zn, Ca, and Fe) further contributed to the understanding of PTB etiology in RPL. These findings suggest opportunities for personalized care and preventive interventions to optimize maternal and infant health outcomes.

Assessment of potentially toxic metal(loid)s contamination in soil near the industrial landfill and impact on human health: an evaluation of risk

The generation of solid waste is increasing with each passing day due to rapid urbanization and industrialization and has become a matter of concern for the international community. Leachate leakages from landfills pollute the soil and can potentially harm the human health. In this paper, inductively coupled plasma-optical emission spectrometric studies were employed to assess and analyze the composition of metals (Ba, Cd, Pb, Hg, Cu, Cr and Mn) and metalloid (As) in soil samples. Results of Cr, Mn, Cu, As, Ba, Cd, Pb and Hg from CRM (certified reference material, SRM 2709a) of San Joaquin soil were evaluated and reported in terms of percent recoveries which were in the range of 97.6-102.9% and show outstanding extraction efficiency. Other than copper, where the permitted limit set by the EU is specified as 50-140 mg/kg in soil, the average amount of all the metals in soil was found within the permissible limits provided by WHO, the European Community (EU) and US EPA. Soil contaminated with Hg (PERI = 100) and Cd (PERI = 145.50) posed an ecological risk significantly. Pollution load index (PLI) value is greater than 1, while degree of contamination (Cdeg) value is less than 32 which indicated that the soil is polluted and considerably contaminated with metals and metalloid, respectively. In terms of the average daily dosage (ADD) of soil, children received the highest doses of all metals (ADDing = 1.315 × 10-7 - 2.470 × 10-3 and ADDderm = 9.939 × 10-7 - 5.292 × 10-11), whereas ADDing (1.409 × 10-8 - 2.646 × 10-4) was found greater in adults. For all metals except for Ba, the hazard quotient (HQ) trend in both children and adults was observed to be HQing > HQderm > HQinh of soil. Children who are at the lower edge of cancer risk had a lifetime cancer risk (LCR) of 2.039 × 10-4 for Cr from various paths of soil exposure.

Accumulation of essential (copper, iron, zinc) and non-essential (lead, cadmium) heavy metals in Caulerpa racemosa, sea water, and marine sediments of Bintan Island, Indonesia

Background: Heavy metals are materials naturally occurring in nature and increase with a rise in human activity. Ex-mining areas and domestic waste from human settlements are sources of heavy metal contamination that enter and pollute water, which then accumulates in various organisms including the  Caulerpa racemosa community. The accumulation of heavy metals in  C. racemosa has a wide impact on the food chain in aquatic ecosystems and humans because this alga is a consumptive commodity.  

Methods: Sampling of  C. racemosa was carried out at seven sites on Bintan Island, Indonesia covering the eastern (Teluk Bakau, Beralas Pasir, Malang Rapat), northern (Berakit and Pengudang), western (Sakera), and southern parts (Tg. Siambang). Sampling was carried out during different monsoons, and heavy metals in water and sediment samples were measured to determine the heavy metal concentration. Heavy metals were analyzed by a spectrophotometric method using Atomic Absorption Spectrophotometry.  

Results: The results showed that heavy metal concentrations fluctuate according to changes in the wind season, which carry currents and spread pollutants into the water. The concentration of metal in the water is also from anthropogenic activities. The heavy metal content of cadmium (Cd), lead (Pb), copper (Cu), iron (Fe), and zinc (Zn) in  C. racemosa is high in locations close to settlements. Meanwhile, in seawater samples, Fe and Zn metals have the highest concentrations compared to others. 

Conclusions: Ex-bauxite mines are a source of Fe and Zn metal contamination in the environment, especially at Tg. Siambang. The levels of these heavy metals in the sediment are also high, as surface particle deposits accumulate at the bottom of the sediment. In general, the levels of heavy metals Cd, Pb, Cu, Fe, and Zn increase in the northern monsoon because the dynamics of the water transport greater heavy metal pollution.

Ultrasound-Assisted Extraction of Micro- and Macroelements in Fruit Peel Powder Mineral Supplement for Osteoporosis Patients and Their Determination by Flame Atomic Absorption Spectrometry

Osteoporosis is a worldwide disease depicted by the reduced bone mass, an adequate supply of minerals is needed to support bone remodeling, and their deficiency causes bone-related diseases, osteoporosis in particular, and has osteoprotective effects. The aim of this recent research was to quantify the micro- (Mn, Fe, Cu, and Zn) and macroelements (Mg, K, and Ca) in the peel powder of some common fruits (pomegranate, orange, lemon, mango, and grapefruit) by flame atomic absorption spectrometer (FAAS). The extraction of micro- and macroelements in peel powder was done by using dilute acids in an ultrasonic bath. Apple leaves were used as standard reference material (SRM, NIST 1515) to optimize the ultrasound-assisted extraction (UAE) method at varied operating parameters. Maximum response was obtained for extracting of minerals in 500 mg SRM at 60°C temperature, setting a vortexing time of 5 min while using 5.0 mL extracting agent HNO3 (0.5 M)-H2O2 (10%) at 90% sonication amplitude of ultrasound bath for 6 min. While analyzing the SRM, the percentage recovery was obtained in a range between 96.8 and 102.7% to assure the accuracy whereas repeatability (n = 10) study in terms of % RSD yielding ≤2.29 supports well the precision of the proposed method, and limits of quantitation (μg/g) were 0.034, 0.061, 0.065, 0.057, 0.017, 0.175, and 0.053 for Mn, Fe, Cu, Zn, Mg, K, and Ca, respectively. The proposed UAE method was reliable, efficient, and advantageous over the conventionally employed acid digestion method with regard to less consumption of reagents and short analysis time for the determination of micro- and macroelements in fruit peel powder.

The use of ultrasound in the South Cone region. Advances in organic and inorganic synthesis and in analytical methods

In organic and inorganic synthesis and in analytical methods, an external conventional heat source is usually applied to carry out a chemical reaction at a high temperature, or an extraction procedure. In the last decades, the use of ultrasound as an alternative energy source has become an interesting field of research in these topics in the South Cone region (Argentina, Chile, Uruguay, Southern Brazil and Paraguay). For this reason, the present review, covering the period 2009 to mid-2021, is a compilation of ultrasound-assisted synthetic and analytical methodologies.

Toxic and heavy metals contamination assessment in soil and water to evaluate human health risk

Due to urbanization and industrialization, there has been an increase in solid waste generation and has become a global concern and leakage of leachate from landfills contaminate the soil and groundwater and hence can have a severe impact on human health. The present study aimed to determine the composition of toxic metals (Cr, Mn, Cu, As) and heavy metals (Cd, Ba, Hg, Pb) in soil and water by an inductively coupled plasma optical emission spectrometer (ICP-OES). To ensure accuracy during the analysis of Cr, Mn, Cu, As, Cd, Ba, Hg, and Pb in real samples, certified reference material (CRM, SRM 2709a) of San Joaquin soil and water (SRM 1640a) were analyzed and results were presented in terms of % recovery studies. The mean concentration of all the metals in soil and water did not exceed the limit set by the European Community (EU), WHO, and US EPA except Cu where the permissible limit defined by the EU is 50-140 mg/kg in soil. The soil is uncontaminated to moderately contaminated with respect to all metals except the Cu and Pb. Among the average daily dose (ADD) of soil, ADDing and ADDinh for children had the maximum dose for all metals than adults while ADDderm was higher in adults. Hazard quotient (HQ) trend in both adults and children was found in order HQing > HQderm > HQinh of soil for all metals except Ba which followed HQing > HQinh > HQderm. Hazard index (HI) values of soil for Cr and Pb in children were 7 and 7.5 times higher than adults respectively. Lifetime cancer risk (LCR) value for Cr by different exposure pathways of soil was 5.361 × 10-4 for children which are at the lower borderline of risk for cancer.

Multivariate optimization of ultrasound-assisted liquid-liquid microextraction based on two solvents for cadmium preconcentration prior to determination by flame atomic absorption spectrometry

A method based on ultrasound-assisted emulsification liquid-liquid microextraction (USAEME) for cadmium determination by flame atomic absorption spectrometry (FAAS) was developed in this work. USAEME is based on the use of the mixture of 1,2-dichloroethane and trichloroethylene as an acceptor phase, 2-(2-bromo-5-pyridylazo)-5(diethylamino)phenol (Br-PADAP) as a chelating reagent, and ethanol as a dispersive solvent. The composition of the extraction and dispersive solvents, the volume of the extraction solvent, pH, and the sonication time were optimized using the multivariate strategy. The limits of detection and quantification calculated under optimum conditions were, respectively, 0.39 and 1.33 μg L-1, and the obtained enrichment factor was 21. The accuracy was tested by the analysis of certified reference materials. The method was applied to cadmium determination in bivalve mollusks, water, and urban wastewater from Pontal Bay, Bahia, Brazil. The proposed method is simple, fast, and efficient, and uses small amounts of organic solvents for the determination of cadmium.