Locomotion behavior of air bubbles on solid surfaces

Air bubbles are a common occurrence in both natural and industrial settings and are a significant topic in the fields of physics, chemistry, engineering, and medicine. The physical phenomena of the contact between bubbles and submerged solid surfaces, as well as the locomotion behavior of bubbles, are worth exploring. Bubbles are generated in an unbounded liquid environment and rise due to unbalanced external forces. Bubbles of different diameters follow different ascending paths, after which they approach, touch, collide, bounce, and finally adsorb to the solid surface, forming a stable three-phase contact line (TPCL). The bubbles are in an unstable state due to the unbalanced external forces on the solid surface and the effects generated by the two-phase contact surface, resulting in different locomotion behaviors on the solid surface. Studying the formation, transport, aggregation, and rupture behaviors of bubbles on solid surfaces can enable the controllable operation of bubbles. This, in turn, can effectively reduce the loss of mechanical apparatus in agro-industrial production activities and improve corresponding production efficiency. Recent research has shown that the degree of bubble wetting on a solid surface is a crucial factor in the locomotion behavior of bubbles on that surface. This has led to significant progress in the study of bubble wetting, which has in turn greatly advanced our understanding of bubble behavior. Based on this, exploring the manipulation process of the directional motion of bubbles is a promising research direction. The locomotion behavior of bubbles on solid surfaces can be controlled by changing external conditions, leading to the integration of bubble behavior in various scientific and technological fields. Studying the dynamics of bubbles in liquids with infinite boundaries is worthwhile. Additionally, the manipulation process and mode of these bubbles is a popular research direction.

An Automated Computer-Vision "Bubble-Counting" Technique to Characterise CO2 Dissolution into an Acetonitrile Flow Stream in a Teflon AF-2400 Tube-in-Tube Flow Device

A Teflon AF-2400 based tube-in-tube device was used to generate flow streams of CO₂ in acetonitrile and a computer-vision based 'bubble counting' technique was used to estimate the amount of CO₂ that had passed into solution whilst in the tube-in-tube device by quantifying the amount of CO₂ that left solution (forming separate gas-phase segments) downstream of the back-pressure regulator. For both CO₂ pressures used, there appeared to be a minimum residence time below which no CO₂ was observed to leave solution. This was assumed to be due to residual CO₂ below (or close to) the saturation concentration at atmospheric pressure and, by taking this into account, we were able to fit curves corresponding to simple gradient-driven diffusion and which closely matched previously obtained colorimetric titration data for the same system. The estimated value for the residual concentration of CO₂ (0.37 M) is higher than, but in reasonable general correspondence with, saturation concentrations previously reported for CO₂ in acetonitrile (0.27 M).