Robust Fluorine-Decorated {Yb4}-Organic Framework for C2H6 Capture and Efficient Catalytic Performance on CO2-Epoxide Cycloaddition

Fluorine-functionalized MOFs have excellent unusual properties such as gas adsorption and separation and catalysis, but the functionalization of existing ligands and the self-assembly of functionalized MOFs remain a challenge. Herein, we report a robust fluorine-functionalized nanochannel-based ytterbium(III)-organic framework of {(Me2NH2)[Yb4(CFPDA)2(μ2-HCO2)(μ3-OH)2(H2O)2]·4DMF·5H2O}n (NUC-122, H5CFPDA = 4,4'-(4-(4-carboxy-2-fluorophenyl)pyridine-2,6-diyl)diisophthalic acid) with [Yb4(μ3-OH)2(μ2-HCO2)(H2O)2] clusters as secondary building units (SBUs). Compared to reported anionic skeleton of [Yb4(BDCP)2(μ2-HCO2)(μ3-OH)2(H2O)2]n (NUC-38Yb), the void volume of NUC-122 (54.1%) is slightly lower than that of NUC-38Yb (56.7%), which is caused by functionalized fluorine atoms on the ligand of H5BDCP. Because of the introduction of fluorine groups, activated NUC-122a displays a higher adsorption capacity for CO2 along with the value of 117.5 cm3/g (273 K) and 63.1 cm3/g (298 K). Further, activated NUC-122a has a high ethane (C2H6) separation performance over the mixture of C2H6/C2H4 with the selectivity of 1.6, enabling the purity of recycled C2H4 to reach 99.99%. Moreover, the CO2-epoxide cycloaddition could be efficiently catalyzed by NUC-122a under comparatively mild conditions. Under optimal catalytic conditions of 0.13 mol % MOFs, 1.69 mol % n-Bu4NBr, 0.7 MPa CO2, 70 °C, and 3 h, the conversion yield of SO to SC catalyzed by NUC-122a is 26% higher than that catalyzed by NUC-38Yb. The excellent separation and catalytic performance should be attributed to the combined diverse functional groups such as Lewis acidic sites of Yb3+, Lewis basic sites of -F and Npyridine atoms, and electrophilic H-bond donors (HBD) of μ3-OH and μ2-HCO2 moieties. Hence, this work not only reports a fluorine-functionalized multifunctional material but also provides an in-depth insight into the synthetic strategy of functionalized metal-organic host frameworks.

In-situ preparation of highly dispersed Fe doping C3N5 induced by inorganic iron salts with effective activation of PMS for photocatalytic degradation of chlortetracycline

A highly dispersed Fe in situ doped C3N5 (Fe-C3N5) photocatalyst utilizing inorganic iron salt was successfully prepared, which was applied in photocatalytic synergistic advanced oxidative degradation of chlortetracycline (CTC) under the activation with persulfate. BET measurements revealed that uniform Fe doping increases the specific surface area, thus enhancing the reactive active sites. Photoelectric tests indicate that Fe doping optimizes the energy band structure of C3N5, thereby enhancing electron transfer, and the photogenerated electrons facilitate the Fe2+/Fe3+ redox cycle, which is beneficial for the sustained and efficient activation of persulfates. The Fe-C3N5(50 %)/PMS/Vis system achieved over 95 % degradation of CTC within 2 h, after four cycles, the Fe-C3N5(50 %) still exhibits good reusability and stability. Free radical quenching experiments coupled with EPR spectroscopy identified 1O2, h+, and ·O2- as the dominant reactive species driving the degradation of CTC, elucidating the potential degradation mechanisms. Based on LC-MS measurements and utilizing the TEST toxicity assessment software, it has been determined that CTC ultimately decomposes into non-toxic small molecules, such as CO2 and H2O. Furthermore, a hydroponic germination experiment using mung beans was conducted to demonstrate that Fe-C3N5(50 %) does not exhibit toxic effects on plant growth. Importantly, this study offers novel insights into the green synthesis of highly dispersed Fe doping C3N5 photocatalytic for the efficient degradation of CTC.

A Precise Preparation Strategy for 2D Nanoporous Thulium-Organic Framework: High Catalytic Performance in CO2-Epoxide Cycloaddition and Knoevenagel Condensation

Efficient conversion of carbon dioxide (CO2) into high-value chemicals is viewed as one of the most promising approaches for solving the problem of an energy shortage and serious environment pollution. However, design and synthesis of confined multifunctional catalysts with in situ engineered task-specific sites and nanoporous environments remain a complex and challenging task due to a lack of in-depth understanding of their structure and reaction mechanism. Herein, we report a highly robust 2D nanoporous framework of {[Tm(HFPDC)(DMF)2]·DMF·H2O}n (NUC-120) (H4FPDC = 4,4'-(4-(4-fluorophenyl)pyridine-2,6-diyl)diisophthalic acid). The thermally activated host framework of [Tm(HFPDC)]n (NUC-120a) has the following two merits: (i) nanoporous structure, (ii) massive quantity of functional sites. Moreover, NUC-120 and activated NUC-120a display high thermal and chemical stability, which have been proved by TGA and the soaking experiments in acid-base water and most organic solvents. Catalytic experiments proved that NUC-120a, in the presence of the n-Bu4NBr cocatalyst could efficiently catalyze the coupling reaction of CO2 and epoxides under comparatively mild conditions. Furthermore, NUC-120a also displays high catalytic performance in the Knoevenagel condensation reactions of aldehydes and malononitrile, which should be because the coexisting Lewis acidic and basic sites can separately activate aldehyde and malononitrile molecules. Thereby, this work further provides insight that desired functional materials can be generated by using the existing suitable secondary building units (SBUs) and meticulously regulating the growth environments.

Elimination of Trace Tetracycline with Alkyl Modified MIL-101 in Water

The overuse of antibiotics poses a serious threat to human health and ecosystems. Therefore, the development of high-performance antibiotic removal materials has attracted increasing attention. However, the adsorption and removal of trace amounts of antibiotics in aqueous systems still face significant challenges. Taking tetracycline (TC) as a representative antibiotic and based on its structural characteristics, a series of TC adsorbents are prepared by grafting alkyl groups to the framework of MIL-101(Cr). The adsorptive capacity of the modified materials for tetracycline markedly surpasses that of MIL-101(Cr), with MIL-101-dod achieving the best adsorption performance. MIL-101-dod demonstrated an outstanding ability to adsorb tetracycline at low concentrations, where a 5.0 mg sample of MIL-101-dod can reduce the concentration of a 90 mL 5 ppm tetracycline solution to below 1 ppb, significantly superior to other sorbents. XPS and IR tests indicate that MIL-101-dod has multiple weak interactions with tetracycline molecules, including C─H…O and C─H…π. This work provides theoretical and experimental support for the development of adsorbents for low-concentration antibiotics.

A metal-free cascaded process for efficient H2O2 photoproduction using conjugated carbonyl sites

Carbon-based metal-free catalysts are promising green catalysts for photocatalysis and electrocatalysis due to their low cost and environmental friendliness. A key challenge in utilizing these catalysts is identifying their active sites, given their poor crystallinity and complex structures. Here we demonstrate the key structure of the double-bonded conjugated carbon group as a metal-free active site, enabling efficient O2 photoreduction to H2O2 through a cascaded water oxidation - O2 reduction process. Using ethylenediaminetetraacetic acid as a precursor, we synthesized various carbon-based photocatalysts and analyzed their structural evolution. Under the polymerization conditions of 260 °C to 400 °C, an N-ethyl-2-piperazinone-like structure was formed on the surface of the catalyst, resulting in high photocatalytic H2O2 photoproduction (2884.7 μmol g-1h-1) under visible light. A series of control experiments and theoretical calculations further confirm that the double-bond conjugated carbonyl structure is the key and universal feature of the active site of metal-free photocatalysts.

Optimizing Electronic Density at Active W Sites for Boosting Photocatalytic H2 Evolution

It is highly desirable but challenging to optimize the electronic structure of an active site to realize moderate active site-Hads bond energies for boosting photocatalytic H2 evolution. Herein, an interfacial engineering strategy is developed to simultaneously concentrate hydrogen species and accelerate the combination of an Hads intermediate to generate free H2 by constructing W-WC-W2C (WCC) cocatalysts. Systematic investigations reveal that hybridizing with W2C creates electron-rich W active sites and effectively induces the downshift of the d-band center of W in WC. Consequently, the strong W-Hads bonds on the surface of WC are weakened, thus promoting the desorption of Hads to rapidly produce free H2. The optimized 40-WCC/CdS photocatalyst exhibits a high hydrogen evolution rate of 63.6 mmol g-1 h-1 under visible light (≥420 nm) with an apparent quantum efficiency of 39.5% at 425 nm monochromatic light, which is about 40-fold of the pristine CdS. This work offers insights into the design of cocatalyst for high-efficiency photocatalytic H2 production.

Synthesis of a Co/Ni-MOF-74@PDI Z-scheme photocatalyst as a highly efficient photo-assisted Fenton-like catalyst for the removal of chlortetracycline hydrochloride

In this paper, ultra-thin nanofiber PDI was obtained by self-assembly dispersion of commercial PDINH. A novel Co/Ni-MOF-74@PDI Z-scheme heterojunction photocatalyst material was constructed by a simple solvothermal method. XRD, SEM, TEM, FT-IR and other characterization techniques proved the successful preparation of the Co/Ni-MOF-74@PDI Z-scheme heterojunction photocatalyst material. By degrading chlortetracycline hydrochloride, it was found that the photocatalytic activity of Co/Ni-MOF-74@PDI was much higher than that of pure Co/Ni-MOF-74 and PDI. Subsequently, Co/Ni-MOF-74@PDI was used to activate H2O2 to further improve the degradation efficiency of chlortetracycline hydrochloride. It was found that the photocatalytic performance was greatly improved after the addition of 19.6 mM H2O2 to the system, and the degradation rate of chlortetracycline hydrochloride was 87% within 90 min. The electron transfer pathway and H2O2 activation mechanism of the Co/Ni-MOF-74@PDI composite photocatalyst were proved by free radical quenching experiments, electron paramagnetic resonance analysis and X-ray electron spectroscopy. Finally, the easy exfoliation point and degradation pathway of chlortetracycline hydrochloride were studied using density functional theory, UPLC-MS and toxicity evaluation software. It was found that the main active substances were h+, ˙O2, 1O2 and ˙OH, and the toxicity of chlortetracycline hydrochloride and its intermediates was evaluated.

Nanocage-based {In2Tm2}-organic framework for efficiently catalyzing the cycloaddition reaction of CO2 with epoxides and Knoevenagel condensation

The combination of [In2Tm2(μ2-OH)2(CO2)10(H2O)2] clusters and H5BDCP ligand generated a highly robust nanoporous MOF with high catalytic performance in the cycloaddition reaction of epoxides with CO2 and Knoevenagel condensation.