Evaluation of the optimal driving mode during left ventricular assist with pulsatile catheter pump in calves

PulseCath iVAC2L: next-generation pulsatile mechanical circulatory support

Contemporary state of the art percutaneous coronary intervention techniques offer treatment strategies and solutions to an increasing number of patients with heart failure and complex coronary artery disease. Percutaneous mechanical circulatory support is intended to alleviate the mechanical and energetic workload imposed to a failing ventricle by reducing left ventricle pressures and volumes and potentially also increasing coronary blood flow. The PulseCath iVAC2L is a transaortic left ventricular assist device that applies a pneumatic driving system to produce pulsatile forward flow. Herein, the essential aspects regarding iVAC2L are discussed with focus on its mechanisms of action and the available clinical experience.

In Vivo and in Vitro Experience with the PUCA-II, a Single-Valved Pulsatile Catheter-Pump

The Pulsatile Catheter (PUCA) pump is a trans-arterial pulsatile ventricular assist device that can be used for short-term left ventricular support. The separate inflow and outflow valves in the first version of the device (PUCA-I) were replaced by a single inflow/outflow valve in the latest PUCA pump version (PUCA-II). The new combined valve was tested during in vitro (mock circulation) and in vivo experiments for valve leakage, flow resistance, and thrombus formation. During the in vitro experiments a maximum valve leakage of 6% during ejection and 21% during aspiration was found. The maximum flow resistance coefficient (K) was 4. The animal experiments demonstrated that the PUCA-II could be positioned within a few minutes into the left ventricle without X-ray guidance and without using a vascular graft. Thrombi were not found in the combined valve after total pump time of 3 hours, which proved the good washout of the valve. Initial experiments to position the pump in the right ventricle through the pulmonary artery were successful and contributed to the development of a new application for the device.

Numerical Simulation of the Influence of a Left Ventricular Assist Device on the Cardiovascular System

The PUCA (pulsatile catheter) pump is a left ventricular assist device (LVAD) capable of unloading the left ventricle (LV) and improving coronary flow by providing a counterpulsation effect. It consists of an extracorporeal located membrane pump, coupled to a transarterial catheter that enters the body via a superficial artery and ends in the LV. Blood is aspirated from the LV and pumped in the ascending aorta through the same catheter guided by a valve system. Timing and frequency of the PUCA pump influence its efficacy. To study the influence of several pump parameters a numerical model of the device and the circulatory system has been developed. Results of animal experiments were used to validate the model.

Optimization studies resulted in a pump configuration with a stroke volume of 50 cc and pump:heart frequency mode of 1:2 that starts ejection at the beginning of diastole.

Development of Acute Ischemic Heart Failure in Sheep

The goal of the present study was to develop a large animal model of acute ischemic left ventricular heart failure (LVHF) that can be used to assess the influence of the PUCA pump on the heart and circulatory system under realistic conditions. We tested the hypothesis that mild stenosis of the coronary artery in combination with mild ventricular pacing induces an acute heart failure condition, whereas the separate phenomena themselves do not lead to impaired heart function. Mean aortic pressure (AoP), left ventricular end-diastolic pressure (LVEDP), stroke volume (SV) and myocardial systolic shortening (MSS) were compared 30 minutes after a pacemaker (PM) induced tachycardia in anaesthetized sheep (n=3) without and with ± 50% stenosis of the proximal LCx. All parameters measured restored to basic levels when stenosis was absent. When the LCx was partially occluded, mild PM-induced tachycardia resulted in decreased AoP (P=0.045) as well as in decreased SV (P=0.048); the LVEDP remained high (P=0.002). Also the recovery of MSS was impaired when stenosis was present (P=0.002). These values indicate that acute heart failure conditions were present. The technique used proved to be safe and allowd fine-tuning of the demand ischemia by adapting heart frequency to the required heart failure conditions. The model can be used to study the effect of LV mechanical support during acute heart failure conditions.

In Vitro Evaluation of the PUCA II Intra-Arterial LVAD

The “pulsatile catheter” (PUCA) pump is a minimally invasive intra-arterial left ventricular assist device intended for acute support of critically ill heart failure patients. To assess the hydrodynamic performance of the PUCA II, driven by an Arrow AutoCat IABP driver, we used a (static) mock circulatory system in which the PUCA II was tested at different loading conditions. The PUCA II was subsequently introduced in a (dynamic) cardiovascular simulator (CVS) to mimic actual in vivo operating conditions, with different heart rates and 2 levels of left ventricular (LV) contractility. Mock circulation data shows that PUCA II pump performance is sensitive to afterload, pump rate and preload. CVS data demonstrate that PUCA II provides effective LV unloading and augments diastolic aortic pressure. The contribution of PUCA II to total flow is inversely related to LV contractility and is higher at high heart rates. We conclude that, with the current IABP driver, the PUCA II is most effective in 1:1 mode in left ventricles with low contractility.

Mechanical ventilation and thoracic artificial lung assistance during mechanical circulatory support with PUCA pump: in silico study

Patients assisted with left ventricular assist device (LVAD) may require prolonged mechanical ventilatory assistance secondary to postoperative respiratory failure. The goal of this work is the study of the interdependent effects LVAD like pulsatile catheter (PUCA) pump and mechanical ventilatory support or thoracic artificial lung (TAL), by the hemodynamic point of view, using a numerical simulator of the human cardiovascular system. In the simulator, different circulatory sections are described using lumped parameter models. Lumped parameter models have been designed to describe the hydrodynamic behavior of both PUCA pump and thoracic artificial lung. Ventricular behavior atrial and septum functions were reproduced using variable elastance model. Starting from simulated pathological conditions we studied the effects produced on some hemodynamic variables by simultaneous PUCA pump, thoracic artificial lung or mechanical ventilation assistance. Thoracic artificial lung was applied in parallel or in hybrid mode. The effects of mechanical ventilation have been simulated by changing mean intrathoracic pressure value from -4 mmHg to +5 mmHg. The hemodynamic variables observed during the simulations, in different assisted conditions, were: left and right ventricular end systolic (diastolic) volume, systolic/diastolic aortic pressure, mean pulmonary arterial pressure, left and right mean atrial pressure, mean systemic venous pressure and the total blood flow. Results show that the application of PUCA (without mechanical ventilatory assistance) increases the total blood flow, reduces the left ventricular end systolic volume and increases the diastolic aortic pressure. Parallel TAL assistance increases the right ventricular end diastolic (systolic) volume reduction both when PUCA is switched "ON" and both when PUCA is switched "OFF". By switching "OFF" the PUCA pump, it seems that parallel thoracic artificial lung assistance produces a greater cardiac output (respect to hybrid TAL assistance). Results concerning PUCA and TAL interaction produced by simulations cannot be compared with "in vivo" results since they are not presented in literature. But results concerning the effects produced by LVAD and mechanical ventilation have a trend consistent with those presented in literature.

PUCA Pump and IABP Comparison: Analysis of Hemodynamic and Energetic Effects Using a Digital Computer Model of the Circulation

The pulsatile catheter pump (PUCA pump) is a left ventricular assist device that provides additional flow to the left ventricle. It is usually run in order to ensure a counterpulsation effect, as in the case of the intra-aortic balloon pump (IABP). Because of this similarity, a comparison between the PUCA pump and the IABP was conducted from both the hemodynamic and energetic points of view. Numerical models of the two devices were created and connected to the CARDIOSIM cardiovascular simulator. The PUCA and IABP models were then verified using in vivo experimental data and literature data, respectively. Numerical experiments were conducted for different values of left ventricular end systolic elastance (Els) and systemic arterial compliance (Csa). The energetic comparison was conducted taking into account the diastolic pressure time index and the endocardial viability ratio. Hemodynamic results expressed as cardiac output (CO) and mean coronary blood flow (CBF) show that both the IABP and the PUCA pump efficacy decrease with higher values of Els and Csa. The IABP especially shows higher sensitivity to these parameters, to the extent that in some cases CO actually drops and CBF does not increase. On the other hand, for lower values of Csa, IABP performance improves so much that the PUCA pump flow needs to be increased in order to ensure a hemodynamic effect comparable to that of the IABP. Energetic results show a trend similar to the hemodynamic ones. The study will be continued by investigating other energetic variables and the autonomic response of the cardiovascular system.

Off-Pump Coronary Artery Bypass Graft Surgery With a Pulsatile Catheter Pump for Left Ventricular Dysfunction

We describe the use of a novel device, the pulsatile catheter pump, in patients with left ventricular dysfunction undergoing off-pump coronary surgery. During a 1-year period, 14 patients (mean ejection fraction 28% +/- 8%) underwent off-pump coronary surgery using the pulsatile catheter pump. We recorded neither mortality nor major adverse cardiovascular and cerebral events. Mean support time was 55 +/- 13 minutes. The average flow generated by the pulsatile catheter pump, as calculated per patient, was 2.4 +/- 0.2 L/min (range, 2.2 to 2.8 L/min). Our results show that the pulsatile catheter pump is clinically safe and provides adequate mechanical circulatory support in patients with impaired left ventricular function undergoing off-pump coronary artery surgery.

Hemodynamic Modes of Ventricular Assist with a Rotary Blood Pump: Continuous, Pulsatile, and Failure

Pulsatile operation of rotary blood pumps (RBPs) has received interest due to potential concern with nonphysiological hemodynamics. This study aimed to gain insight to the effects of various RBP modes on the heart-device interaction. A Deltastream diagonal pump (Medos Medizintechnik GmbH) was inserted in a cardiovascular simulator with apical-to-ascending aorta cannulation. The pump was run in continuous mode with incrementally increasing rotating speed (0-5000 rpm). This was repeated for three heart rates (50-100-150 bpm) and three levels of left ventricular (LV) contractility. Subsequently, the Deltastream was run in pulsatile mode to elucidate the effect of (de)synchronization between heart and pump. LV volume and pressure, arterial pressure, flows, and energetic parameters were used to evaluate the interaction. Pump failure (0 rpm) resulted in aortic pressure drops (17-46 mm Hg) from baseline. In continuous mode, pump flow compensated by diminished aortic flow, thus yielding constant total flow. High continuous rotating speed resulted in acute hypertension (mean aortic pressure up to 178 mm Hg). In pulsatile mode, unmatched heart and pulsatile pump rates yielded unphysiologic pressure and flow patterns and LV unloading was found to be highly dependent on synchronization phase. Optimal unloading was achieved when the minimum rotating speed occurred at end-systole. We conclude that, in continuous mode, a perfusion benefit can only be achieved if the continuous pump flow exceeds the preimplant (baseline) cardiac output. Pulsatile mode of support results in complex pressure and volume variations and requires accurate triggering to achieve optimal unloading.

The Impact of Pump Speed and Inlet Cannulation Site on Left Ventricular Unloading with a Rotary Blood Pump

BACKGROUND

Ventricular assist devices are gaining ground in the therapeutic treatment of chronic heart failure. These devices are sometimes used as a bridge to recovery by unloading the left ventricle (LV) and restoring its function. It is therefore important to preserve the heart muscle and apply less invasive implantation methods.

METHODS

In this study ventricular unloading was achieved in 7 healthy sheep with a rotary blood pump at different pump flow levels. Ventricular cannulation via the left atrium (LA) and through the mitral valve was compared to atrial cannulation. The unloading of the heart was assessed with LV pressure-volume loops, derived energetic parameters, and an estimate of LV wall stress.

RESULTS

No significant difference between the cannulations was found for any flow or pressure. LA cannulation, however, resulted in significantly lower stroke volumes and stroke work for all pump flow levels. Irrespective of cannulation site, LV volumes and energetic parameters showed a significant decrease with increasing pump flow.

CONCLUSION

LV assist with a rotary blood pump can provide sufficient unloading with atrial cannulation.