Muscle activity and pedal force profile of triathletes during cycling to exhaustion

Effects of Photobiomodulation Therapy on Performance in Successive Time-to-Exhaustion Cycling Tests: A Randomized Double-Blinded Placebo-Controlled Trial

The goal of this study was to investigate the effects of photobiomodulation therapy (PBMT) on performance, oxygen uptake (VO2) kinetics, and lower limb muscle oxygenation during three successive time-to-exhaustions (TTEs) in cyclists. This was a double-blind, randomized, crossover, placebo-controlled trial study. Sixteen cyclists (~23 years) with a cycling training volume of ~460 km/week volunteered for this study. In the first session, cyclists performed a maximal incremental test to determine maximal oxygen uptake and maximal power output (POMAX). In the following sessions, cyclists performed three consecutive TTEs at POMAX. Before each test, PBMT (135 J/thigh) or a placebo (PLA) was applied to both thighs. VO2 amplitude, O2 deficit, time delay, oxyhemoglobin (O2Hb), deoxyhemoglobin (HHb), and total hemoglobin (tHb) were measured during tests on the right vastus lateralis. The PBMT applied before three successive TTE increased performance of the first and second TTE (~10-12%) tests, speed of VO2 and HHb kinetics during the first test, and increased peripheral muscle oxygenation (increase in HHb and tHb) in the first and second exhaustion tests. However, the PBMT effects were attenuated in the third TTE, as performance and all the other outcomes were similar to the ones from the PLA intervention. In summary, PBMT application increased the first and second successive TTEs, speed of VO2, and muscle oxygenation.

Acute effects of fatigue on internal and external load variables determining cyclists' power profile

The aim of the present study was to determine whether fatigue affects internal and external load variables determining power profile in cyclists. Ten cyclists performed outdoor power profile tests (lasting 1-, 5 and 20-min) on two consecutive days, subject either to a fatigued condition or not. Fatigue was induced by undertaking an effort (10-min at 95% of average power output obtained in a 20-min effort followed by 1-min maximum effort) until the power output decreased by 20% compared to the 1-min power output. Fatigued condition decreased power output (p < 0.05, 1-min: 9.0 ± 3.8%; 5-min: 5.9 ± 2.5%; 20-min: 4.1 ± 1.9%) and cadence in all test durations, without differences in torque. Lactate decreased in longer efforts when a fatigue protocol had previously been conducted (e.g., 20-min: 8.6 ± 3.0 vs. 10.9 ± 2.7, p < 0.05). Regression models (r² ≥ 0.95, p < 0.001) indicated that a lower variation in load variables of 20-min in fatigued condition compared with the non-fatigued state resulted in a lower decrease in critical power after the fatigue protocol. The results suggest that fatigued condition on power was more evident in shorter efforts and seemed to rely more on a decrease in cadence than on torque.

Bilateral asymmetries in professional cyclists during a Grand Tour

BACKGROUND: Pedalling asymmetries are a topic of interest to cycling coaches and athletes due to a potential link with performance and injury prevention. OBJECTIVES: The aim of this study is to describe the bilateral asymmetry of professional cyclists during two editions of a Grand Tour. METHODS: Here we set out to determine the power balance (power produced by each lower limb) between stronger and weaker leg (dominant vs. non-dominant) of 12 UCI professional cyclists competing at two Giro d’Italia editions. Power data were recorded during competition stages. Further analysis considered power data clustered into individual intensity zones (from Z1 to Z7). RESULTS: Higher intensity elicited better power balance (lower asymmetry) regardless of the stage profile. Intensity distribution analysed according to the role of the cyclist was lower for climbers in Z2 (p= 0.006) and Z7 (p= 0.002) and higher in Z5 (p= 0.023) compared to team helpers. Power balance ranged from 0 to 9 % across the different athletes. CONCLUSIONS: Increase in power output improves power balance, especially in team helpers, and the lower power balance at lower exercise intensities, which are most of the race time, may elicit significant cumulative loading on a given leg of the cyclists, which requires further attention regarding risks of overuse injury.

Influence of muscle fatigue on the pedaling kinetic and kinematics in different cycling protocols: a scoping review

ABSTRACT The aim of this study was to review the literature on the effects of muscle fatigue generated by different cycling protocols, on the kinetics and kinematics of the crank cycle. Twenty-two studies were included in the review. The establishment of the fatigue processes caused an increase in the resulting and effective forces (all tests), together with the pedaling efficiency (incremental and constant tests). In addition, fatigue caused joint changes in the lower limbs (increased range of motion in the ankle and reduced contribution to total torque) in different cycling tests. Therefore, these pedaling strategies may be related to the maintenance of muscle work to postpone the cyclists’ exhaustion.

The effect of saddle height and saddle position changes from pedal on muscles and joints behaviors in ergometer: A parametric study

The physical activities such as pedaling can affect the lower limb muscles strength and rehabilitation. Improper pedaling can cause injury. In this study, we would investigate the effects of saddle place (saddle position and saddle height) on the behavior of muscles and joints. Moreover, we would try to reveal the relationship between the muscles activity (Act) and the joints reaction forces ( F) and saddle position and saddle height. To this end, the pedaling conditions are obtained from the biomechanical model of the human movement system presented in AnyBody software. The variations in 12 muscles Act and total, normal and shear F of ankle, knee and hip joints are studied for the various saddle places in the pedaling feasible range. The relationships of those muscles Act and joints F are predicted by the response surface method. The results indicate that the muscles and the joints behavior changes for various saddle position and saddle height. The maximum and the minimum of the total response are acquired in the ankle and hip joints, respectively. In contrast to the ankle and hip joints, the knee shear response is greater than the normal response. The predictive models of the muscles Act and the joints F (the regression coefficients ( R2) are 0.60–0.95 and 0.76–0.97, respectively) indicate their nonlinear behavior with saddle position and saddle height variations. Studying the muscles and joints behavior in different pedaling condition can be helpful for the suitable saddle placement in order for rehabilitation, muscles soreness reduction, and joints disorder treatment.

Green Tea Extract Preserves Neuromuscular Activation and Muscle Damage Markers in Athletes Under Cumulative Fatigue

A main implication of cumulative fatigue is the muscle damage that impairs neuromuscular function and training adaptations. These negative effects may limit performance when athletes exercise in consecutive days. In this regard, antioxidant supplementation has gain popularity among athletes. Green tea supplementation has been advocated as a strategy to improve exercise recovery due to the activity of its catechins with high antioxidant and anti-inflammatory potential. Here we performed a triple blinded placebo control experiment to determine the effect of green tea extract (GTE) from Camellia sinensis on muscle damage, oxidative stress, and neuromuscular activity in athletes submitted to consecutive sessions of exercise and fatigue. Sixteen trained amateur male athletes were randomly assigned to a GTE supplemented (500 mg/day) or placebo group during 15 days. Effects of supplementation were tested during repeated trials of submaximal cycling at 60% of peak power output performed after a protocol for cumulative fatigue of knee extensors. Muscle damage and oxidative stress showed lower magnitudes in response to fatigue after GTE supplementation. Placebo group showed impaired neuromuscular activity and higher muscle damage and oxidative stress compared to the GTE group during the cycling trials under fatigue. In summary, GTE supplementation showed positive effects on neuromuscular function in response to a condition of cumulative fatigue. It suggests GTE supplementation may have potential to serve as a strategy to improve performance and recovery in conditions of cumulative exercise.

Effect of increasing workload on knee extensor and flexor muscular activity during cycling as measured with intramuscular electromyography

The purpose of this study was to describe the effect of increasing workload on individual thigh muscle activation during a 20 minute incremental cycling test. Intramuscular electromyographic signals were recorded from the knee extensors rectus femoris, vastus lateralis, vastus medialis and vastus intermedius and the knee flexors semimembranosus, semitendinosus, and the short and long heads of the biceps femoris during increasing workloads. Mean activation levels were compared over the whole pedaling cycle and the crank angles at which onset and offset of activation and peak activity occurred were identified for each muscle. These data were compared between three workloads. EMG activation level significantly increased (p<0.05) with increasing workload in the rectus femoris, vastus medialis, vastus lateralis, vastus intermedius, biceps femoris long head, semitendinosus and semimembranosus but not in the biceps femoris short head. A significant change in activation timing was found for the rectus femoris, vastus lateralis, vastus medialis and semitendinosus. Of the knee flexors only the short head of the biceps femoris had its peak activity during the upstroke phase at the two highest workloads indicating a unique contribution to knee flexion.

Saddle Height and Cadence Effects on the Physiological, Perceptual, and Affective Responses of Recreational Cyclists

Saddle height influences cycling performance and would be expected to influence cyclists physically, perceptually, and emotionally. We investigated how different saddle positions and cadences might affect cyclists’ torque, heart rate, rate of perceived exertion (RPE), and affective responses (Feeling scale). Nine male recreational cyclists underwent cycling sessions on different days under different conditions with a constant load. On Day 1, the saddle was at the reference position (109% of the distance from the pubic symphysis to the ground), and on Days 2 and 3, the saddle was in the “upward position” (reference + 2.5%) and “downward position” (reference − 2.5%) in random order. Each session lasted 30 minutes and was divided into three cadence-varied 10-minute stages without interruption: (a) freely chosen cadence (FCC), (b) FCC − 20%, and (c) FCC + 20%. We assessed all dependent measures at the end of each 10 minute stage. While there was no significant interaction (Saddle × Cadence) for any of the analyzed variables, torque values were higher at lower cadences in all saddle configurations, and the FCC + 20% cadence was associated with faster heart rate, higher RPE, and lower affect compared with FCC and FCC − 20% in all saddle positions. At all cadences, the saddle at “downward position” generated a higher RPE compared with “reference position” and “upward position.” The affective response was lower in the “downward position” compared with the “reference position.” Thus, while cyclists perceived the downward (versus reference) saddle position as greater exercise effort, they also associated it with unpleasant affect.

Reproducibility of upper leg EMG frequency content during cycling

Reproducibility of frequency content from surface electromyography (sEMG) signals has not been assessed and it is unknown if incremental load testing design could affect sEMG in cycling. The goals of this study were to assess the reproducibility of measures from sEMG frequency content between sessions and to compare these frequency components between a ramp and a step incremental cycling test. Eighteen cyclists performed four incremental load cycling tests to exhaustion. Two tests were performed using a step increment (load started at 100 W for 3 min followed by increments of 30 W every 3 min) and two were performed using a ramp increment (load started at 100 W for 1 min followed by increments of 30 W·min^-1). sEMG was monitored bilaterally for the rectus femoris and vastus lateralis throughout the tests and converted into overall activation (whole signal bandwidth), high- and low-frequency contents. The reproducibility of the frequency content ranged from none to strong (ICC = 0.07-0.90). Vastus lateralis activation was larger at the step compared to the ramp test (P < 0.01), without differences for rectus femoris (P = 0.22-0.91) and for the high-frequency (P = 0.28-0.95) and low-frequency contents (P = 0.13-0.94). sEMG from vastus lateralis and rectus femoris presented none to strong reproducibility. Vastus lateralis is more activated in step test design.