A high pressure x-ray photoelectron spectroscopy study of CO oxidation over Rh(100)

Structure Matters: Asymmetric CO Oxidation at Rh Steps with Different Atomic Packing

Curved crystals are a simple but powerful approach to bridge the gap between single crystal surfaces and nanoparticle catalysts, by allowing a rational assessment of the role of active step sites in gas-surface reactions. Using a curved Rh(111) crystal, here, we investigate the effect of A-type (square geometry) and B-type (triangular geometry) atomic packing of steps on the catalytic CO oxidation on Rh at millibar pressures. Imaging the crystal during reaction ignition with laser-induced CO₂ fluorescence demonstrates a two-step process, where B-steps ignite at lower temperature than A-steps. Such fundamental dissimilarity is explained in ambient pressure X-ray photoemission (AP-XPS) experiments, which reveal partial CO desorption and oxygen buildup only at B-steps. AP-XPS also proves that A-B step asymmetries extend to the active stage: at A-steps, low-active O–Rh–O trilayers buildup immediately after ignition, while highly active chemisorbed O is the dominant species on B-type steps. We conclude that B-steps are more efficient than A-steps for the CO oxidation.

Present and new frontiers in materials research by ambient pressure x-ray photoelectron spectroscopy

In this topical review we catagorise all ambient pressure x-ray photoelectron spectroscopy publications that have appeared between the 1970s and the end of 2018 according to their scientific field. We find that catalysis, surface science and materials science are predominant, while, for example, electrocatalysis and thin film growth are emerging. All catalysis publications that we could identify are cited, and selected case stories with increasing complexity in terms of surface structure or chemical reaction are discussed. For thin film growth we discuss recent examples from chemical vapour deposition and atomic layer deposition. Finally, we also discuss current frontiers of ambient pressure x-ray photoelectron spectroscopy research, indicating some directions of future development of the field.

Identification of a Catalytically Highly Active Surface Phase for CO Oxidation over PtRh Nanoparticles under Operando Reaction Conditions

Pt-Rh alloy nanoparticles on oxide supports are widely employed in heterogeneous catalysis with applications ranging from automotive exhaust control to energy conversion. To improve catalyst performance, an atomic-scale correlation of the nanoparticle surface structure with its catalytic activity under industrially relevant operando conditions is essential. Here, we present x-ray diffraction data sensitive to the nanoparticle surface structure combined with in situ mass spectrometry during near ambient pressure CO oxidation. We identify the formation of ultrathin surface oxides by detecting x-ray diffraction signals from particular nanoparticle facets and correlate their evolution with the sample's enhanced catalytic activity. Our approach opens the door for an in-depth characterization of well-defined, oxide-supported nanoparticle based catalysts under operando conditions with unprecedented atomic-scale resolution.

Ambient pressure phase transitions over Ir(1 1 1): at the onset of CO oxidation

In this study we report on the adsorbate structures on an Ir(1 1 1) surface during the phase transition from the inactive to the active state during CO oxidation. The CO oxidation over Pt(1 1 1) is used as a reference case. Where Pt(1 1 1) either is inactive and CO covered or active and O covered, Ir(1 1 1) exhibits a transition state with co-existing chemisorbed O and CO. The observed structural differences are explained in terms of DFT-calculated adsorption energies. For Pt(1 1 1) the repulsive CO-O interaction makes co-existing chemisorbed CO and O unfavourable, while for Ir(1 1 1) the stronger O and CO adsorption allows for overcoming the repulsive interaction. At the onset of CO oxidation over Ir(1 1 1), a CO structure containing defects forms, which enables O₂ to dissociatively adsorb on the Ir(1 1 1) surface, thus enabling the CO oxidation reaction. At the mass transfer limit, the Ir(1 1 1) surface is covered by a chemisorbed O structure with defects; hence, the active surface is predominately chemisorbed O covered at a total pressure of 0.5 mbar and no oxide formation is observed.

Crystallographic structure and energetics of the Rh(1 0 0)-(3 × 1)-2O phase

In this study we investigate the crystallographic structure of the Rh(1 0 0)-([Formula: see text])-2O phase by quantitative low energy electron diffraction (LEED) and scanning tunnelling microscopy as well as the energetics of the system applying density functional theory calculations (DFT). The ([Formula: see text]) structure forms upon exposing the clean Rh(1 0 0) surface to 1200 L of oxygen at 520 K. A full-dynamical LEED intensity analysis (Pendry R-factor [Formula: see text]) reveals an oxygen-induced shifted row-reconstruction of the rhodium top layer where every third Rh-row is displaced by half a surface lattice parameter along the [0 1 1]-direction. There are two oxygen atoms within the unit cell which assume threefold coordinated sites on both sides of the shifted Rh-row with one bond to the shifted and two bonds to the unshifted rows. DFT calculations yield a total energy gain of 0.27 eV per oxygen atom compared to adsorption on the unreconstructed surface. This by far overcompensates the energetic penalty of 0.10 eV per oxygen atom for shifting the Rh-row and thus drives the substrate reconstruction. A coadsorption of oxygen at remaining regular sites of the substrate is not observed in experiment and is found to be energetically unfavorable.

In Situ Optical Reflectance Difference Observations of CO Oxidation over Pd(100)

Using a home-built reflectometer, we have investigated the changes in the optical reflectivity of a Pd(100) model catalyst during CO oxidation under high-pressure, high-temperature conditions. We observe changes in optical contrast when exposing the surface to CO oxidation conditions at 200 mbar from room temperature up to 400 °C. These changes in reflectivity are a result both of the formation of a surface oxide layer and of a change in surface roughness because of gas exposure. However, the reflectivity is more sensitive to the presence of a thin, flat oxide layer than to surface roughness. CO oxidation plays an important role in the decrease of the reflectivity. Since adding a reducing agent to the gas mixture renders it unlikely that the oxide thickness increases, we conclude that the observed decrease in reflectivity is dominated by increased surface roughness because of the catalytic reaction. We contribute this observed surface roughening to a Mars-van Krevelen-type reaction mechanism.

In-situ observations of catalytic surface reactions with soft x-rays under working conditions

Catalytic chemical reactions proceeding on solid surfaces are an important topic in fundamental science and industrial technologies such as energy conversion, pollution control and chemical synthesis. Complete understanding of the heterogeneous catalysis and improving its efficiency to an ultimate level are the eventual goals for many surface scientists. Soft x-ray is one of the prime probes to observe electronic and structural information of the target materials. Most studies in surface science using soft x-rays have been performed under ultra-high vacuum conditions due to the technical limitation, though the practical catalytic reactions proceed under ambient pressure conditions. However, recent developments of soft x-ray based techniques operating under ambient pressure conditions have opened a door to the in-situ observation of materials under realistic environments. The near-ambient-pressure x-ray photoelectron spectroscopy (NAP-XPS) using synchrotron radiation enables us to observe the chemical states of surfaces of condensed matters under the presence of gas(es) at elevated pressures, which has been hardly conducted with the conventional XPS technique. Furthermore, not only the NAP-XPS but also ambient-pressure compatible soft x-ray core-level spectroscopies, such as near-edge absorption fine structure (NEXAFS) and x-ray emission spectroscopy (XES), have been significantly contributing to the in-situ observations. In this review, first we introduce recent developments of in-situ observations using soft x-ray techniques and current status. Then we present recent new findings on catalytically active surfaces using soft x-ray techniques, particularly focusing on the NAP-XPS technique. Finally we give a perspective on the future direction of this emerging technique.