Initial Assessment of A Tissue Engineered Stomach Derived From Syngeneic Donors in a Rat Model

Biomechanical and microstructural characterisation of the porcine stomach wall: Location- and layer-dependent investigations

The mechanical properties of the stomach wall help to explain its function of storing, mixing, and emptying in health and disease. However, much remains unknown about its mechanical properties, especially regarding regional heterogeneities and wall microstructure. Consequently, the present study aimed to assess regional differences in the mechanical properties and microstructure of the stomach wall. In general, the stomach wall and the different tissue layers exhibited a nonlinear stress-stretch relationship. Regional differences were found in the mechanical response and the microstructure. The highest stresses of the entire stomach wall in longitudinal direction were found in the corpus (201.5 kPa), where food is ground followed by the antrum (73.1 kPa) and the fundus (26.6 kPa). In contrast, the maximum stresses in circumferential direction were 39.7 kPa, 26.2 kPa, and 15.7 kPa for the antrum, fundus, and corpus, respectively. Independent of the fibre orientation and with respect to the biaxial loading direction, partially clear anisotropic responses were detected in the intact wall and the muscular layer. In contrast, the innermost mucosal layer featured isotropic mechanical characteristics. Pronounced layers of circumferential and longitudinal muscle fibres were found in the fundus only, whereas corpus and antrum contained almost exclusively circumferential orientated muscle fibres. This specific stomach structure mirrors functional differences in the fundus as well as corpus and antrum. Within this study, the load transfer mechanisms, connected with these wavy layers but also in total with the stomach wall's microstructure, are discussed. STATEMENT OF SIGNIFICANCE: This article examines for the first time the layer-specific mechanical and histological properties of the stomach wall attending to the location of the sample. Moreover, both mechanical behaviour and microstructure were explicitly match identifying the heterogeneous characteristics of the stomach. On the one hand, the results of this study contribute to the understanding of stomach mechanics and thus to their functional understanding of stomach motility. On the other hand, they are relevant to the fields of constitutive formulation of stomach tissue, whole stomach mechanics, and stomach-derived scaffolds i.e., tissue-engineering grafts.

Delivery of Mesenchymal Stem Cells from Gelatin-Alginate Hydrogels to Stomach Lumen for Treatment of Gastroparesis

Gastroparesis (GP) is associated with depletion of interstitial cells of Cajal (ICCs) and enteric neurons, which leads to pyloric dysfunction followed by severe nausea, vomiting and delayed gastric emptying. Regenerating these fundamental structures with mesenchymal stem cell (MSC) therapy would be helpful to restore gastric function in GP. MSCs have been successfully used in animal models of other gastrointestinal (GI) diseases, including colitis. However, no study has been performed with these cells on GP animals. In this study, we explored whether mouse MSCs can be delivered from a hydrogel scaffold to the luminal surfaces of mice stomach explants. Mouse MSCs were seeded atop alginate-gelatin, coated with poly-l-lysine. These cell-gel constructs were placed atop stomach explants facing the luminal side. MSCs grew uniformly all across the gel surface within 48 h. When placed atop the lumen of the stomach, MSCs migrated from the gels to the tissues, as confirmed by positive staining with vimentin and N-cadherin. Thus, the feasibility of transplanting a cell-gel construct to deliver stem cells in the stomach wall was successfully shown in a mice stomach explant model, thereby making a significant advance towards envisioning the transplantation of an entire tissue-engineered 'gastric patch' or 'microgels' with cells and growth factors.

Gastrointestinal tissue engineering

Tissue engineering is an emerging discipline that combines engineering principles and the biological sciences toward the development of functional replacement tissue. Virtually every tissue in the body has been investigated and tremendous advances have been made in many areas. This article focuses on the gastrointestinal tract and reviews the current status of bioengineering gastrointestinal tissues, including the esophagus, stomach, small intestine and colon. Although progress has been achieved, there continues to be significant challenges that need to be addressed.

Tissue engineering of the stomach

Tissue engineering combines engineering principles with the biological sciences to create functional replacement tissues. The underlying principle of tissue engineering is that isolated cells combined with biomaterials can form new tissues and organs in vitro and in vivo. This review focuses on stomach tissue engineering, which is a promising approach to the treatment of gastric cancer, the fourth most common malignancy in the world and the second-leading cause of cancer mortality worldwide. Although gastrectomy is a reliable intervention to achieve complete removal of cancer lesions, the limited capacity for food intake after resection results in lower quality of life for patients. To address this issue, we have developed a tissue-engineered stomach to increase the capacity for food intake by creating a new food reservoir. We have transplanted this neo-stomach as a substitute for the original native stomach in a rat model and confirmed functional adaptation. Furthermore, we have demonstrated the feasibility of transplanting a tissue-engineered gastric wall patch in a rat model to alleviate the complications after resection of a large area of the gastric wall. Although progress has been achieved, significant challenges remain to bring this approach to clinical practice. Here, we summarize our work and present the state of the art in stomach tissue engineering.

Assessment of a tissue-engineered gastric wall patch in a rat model

Stenosis or deformity of the remaining stomach can occur after gastrectomy and result in stomach malfunction. The objective of this study is to demonstrate the feasibility of transplanting a tissue-engineered gastric wall patch in a rat model to alleviate the complications after resection of a large area of the gastric wall. Tissue-engineered gastric wall patches were created from gastric epithelial organoid units and biodegradable polymer scaffolds. In the first treatment group, gastric wall defects were created in recipient rats and covered with fresh tissue-engineered gastric wall patches (simultaneous transplantation). In the second treatment group, the tissue-engineered gastric wall patches were frozen for 12weeks, and then transplanted in recipient rats (metachronous transplantation). Tissue-engineered gastric wall patches were successfully used as a substitute of the resected native gastric wall in both simultaneous and metachronous transplantation groups. The defrosted wall patches showed almost the same cell viability as the fresh ones. Twenty-four weeks after transplantation, the defect in the gastric wall was well-covered with tissue-engineered gastric wall patch, and the repaired stomach showed no deformity macroscopically in both groups. Histology showed continuous mucosa and smooth muscle layers at the tissue-engineered stomach wall margin. The feasibility of transplanting a tissue-engineered patch to repair a defect in the native gastric wall has been successfully shown in a rat model, thereby taking one step closer toward the transplantation of an entire tissue-engineered stomach in the future.

Murine tissue-engineered stomach demonstrates epithelial differentiation

BACKGROUND

Gastric cancer remains the second largest cause of cancer-related mortality worldwide. Postgastrectomy morbidity is considerable and quality of life is poor. Tissue-engineered stomach is a potential replacement solution to restore adequate food reservoir and gastric physiology. In this study, we performed a detailed investigation of the development of tissue-engineered stomach in a mouse model, specifically evaluating epithelial differentiation, proliferation, and the presence of putative stem cell markers.

MATERIALS AND METHODS

Organoid units were isolated from <3 wk-old mouse glandular stomach and seeded onto biodegradable scaffolds. The constructs were implanted into the omentum of adult mice. Implants were harvested at designated time points and analyzed with histology and immunohistochemistry.

RESULTS

Tissue-engineered stomach grows as an expanding sphere with a simple columnar epithelium organized into gastric glands and an adjacent muscularis. The regenerated gastric epithelium demonstrates differentiation of all four cell types: mucous, enteroendocrine, chief, and parietal cells. Tissue-engineered stomach epithelium proliferates at a rate comparable to native glandular stomach and expresses two putative stem cell markers: DCAMKL-1 and Lgr5.

CONCLUSIONS

This study demonstrates the successful generation of tissue-engineered stomach in a mouse model for the first time. Regenerated gastric epithelium is able to appropriately proliferate and differentiate. The generation of murine tissue-engineered stomach is a necessary advance as it provides the transgenic tools required to investigate the molecular and cellular mechanisms of this regenerative process. Delineating the mechanism of how tissue-engineered stomach develops in vivo is an important precursor to its use as a human stomach replacement therapy.

Development of a new tissue-engineered sheet for reconstruction of the stomach

We have developed tissue-engineered digestive tracts composed of collagen scaffold and an inner silicon sheet and successfully used it to repair defects in parts of the esophagus, stomach, and small intestine. However, some improvements were demanded for clinical usage because the silicon sheet presented technical difficulties for suturing and endoscopic removal. New tissue-engineered sheet (New-sheet) was composed of a single-piece and reinforced collagen scaffold with biodegradable copolymer. One beagle dog was used to evaluate whether New-sheet could withstand suturing in comparison with native digestive tracts using a tensile tester. Seven beagle dogs had a 5-cm circular defect created in the stomach. New-sheet soaked with autologous peripheral blood or bone marrow aspirate was sutured to the gastric wall. Endoscopic, histological, and immunohistochemical assessment was performed to evaluate regeneration of the stomach up to 16 weeks. Tensile strength testing showed that the mucosal side of New-sheet had strength almost equivalent to the mucosa of the esophagus (P = 0.61). Endoscopically, regeneration of the mucosa started from the circumference after 4 weeks, but a small linear ulcer was still evident at 16 weeks. The regenerated stomach shrank by 60-80% of its original size and histologically showed villous mucosa and underlying dense connective tissue. Immunohistochemically, the regenerated area expressed alpha-smooth-muscle actin but was negative for basic calponin, irrespective of the source of soaked blood. New-sheet shows sufficient strength for suturing, no dehiscence, and better biocompatibility for clinical use, although further examination will be necessary to create a functional digestive tract.

Erste Ergebnisse zur Untersuchung der Stabilität und Gewebeintegration eines abbaubaren, elastischen Copolymers im Tiermodell / First results of the investigation of the stability and tissue integration of a degradable, elastomeric copolymer in an animal model

The stability and tight integration into adjacent tissue of a novel, degradable, elastic copolymer were examined in an animal model. The biomaterial was used for the reconstruction of a gastric wall defect in Sprague-Dawley rats (n=42) to test the polymeric material under the extreme chemical, enzymatical and mechanical conditions of the stomach. In the control group (n=21) the same defect of the gastric wall was primarily closed without biomaterial implantation. In the baseline group (n=21) the animals were kept under standard conditions without any surgical procedure. The implantation periods were 1 week, 4 weeks and 6 months. The animals' weight was determined preoperatively and before explantation. After explantation, air was pumped into the stomach and the pressure was measured by using a pressure-gauge in order to test whether the surgically produced union of the stomach wall and the polymer patch was gas-tight. After 1 week of implantation time a statistically significant increase of the body weight of the animals was found only in the baseline group. Four weeks and 6 months after the abdominal surgical procedure, a statistically significant increase of the animals' weight was found in the implantation group, the control and the baseline group. Gastrointestinal complications like fistula, perforation or peritonitis did not occur in any of the animals. The measurement of the stomach pressure after maximal gas insufflation did not show significant differences between the implantation group, the control and the baseline group in any of the time periods investigated. Despite very high strains of the gastric wall, no gas leakage was detected. There was a tight connection between the polymer and the adjacent stomach wall in all animals investigated. An adequate mechanical stability of the biomaterial was detectable under the extreme pathophysiological conditions of the stomach milieu. A fast and unfavourable degradation of the degradable polymer was not found in any of the animals. Further investigations are needed to analyse the mechanisms of the tissue integration of the biomaterial as well as the degradation kinetic of the polymer and the process of the tissue remodeling. The knowledge of these processes is necessary to adapt the novel biomaterial and thus prepare it for the use and implantation in different body locations and to develop novel therapeutical options in medicine.