Relativistic electron generation in interactions of a 30 TW laser pulse with a thin foil target

Spatially resolved analysis of Kα x-ray emission from plasmas induced by a femtosecond weakly relativistic laser pulse at various polarizations

Spatially resolved K-shell spectroscopy is used here to investigate the interaction of an ultrashort laser pulse (λ=800 nm, τ=40 fs) with a Ti foil under intense irradiation (Iλ(2)=2×10(18)Wμm(2)cm(-2)) and the following fast electron generation and transport into the target. The effect of laser pulse polarization (p, s, and circular) on the Kα yield and line shape is probed. The radial structure of intensity and width of the lines, obtained by a discretized Abel deconvolution algorithm, suggests an annular distribution of both the hot electron propagation into the target and the target temperature. An accurate modeling of Kα line shapes was performed, revealing temperature gradients, going from a few eV up to 15-20 eV, depending on the pulse polarization. Results are discussed in terms of mechanisms of hot electron generation and of their transport through the preplasma in front of the target.

NATALIE: a 32 detector integrated acquisition system to characterize laser produced energetic particles with nuclear techniques

We present a stand-alone system to characterize the high-energy particles emitted in the interaction of ultrahigh intensity laser pulses with matter. According to the laser and target characteristics, electrons or protons are produced with energies higher than a few mega electron volts. Selected material samples can, therefore, be activated via nuclear reactions. A multidetector, named NATALIE, has been developed to count the β(+) activity of these irradiated samples. The coincidence technique used, designed in an integrated system, results in very low background in the data, which is required for low activity measurements. It, therefore, allows a good precision on the nuclear activation yields of the produced radionuclides. The system allows high counting rates and online correction of the dead time. It also provides, online, a quick control of the experiment. Geant4 simulations are used at different steps of the data analysis to deduce, from the measured activities, the energy and angular distributions of the laser-induced particle beams. Two applications are presented to illustrate the characterization of electrons and protons.

Direct, absolute, and in situ measurement of fast electron transport via Cherenkov emission

We present direct measurements of the absolute energy distribution of relativistic electrons generated in intense, femtosecond laser interaction with a solid. Cherenkov emission radiated by these electrons in a novel prism target is spectrally dispersed to obtain yield and energy distribution of electrons simultaneously. A crucial advance is the observation of high density electron current as predicted by particle simulations and its transport as it happens inside the target. In addition, the strong sheath potential present at the rear side of the target is inferred from a comparison of the electron spectra derived from Cherenkov light observation with that from a magnet spectrometer.

Fast electron transport and induced heating in solid targets from rear-side interferometry imaging

Fast adiabatic plasma heating of a thin solid target irradiated by a high intensity laser has been observed by an optical fast interferometry diagnostic. It is driven by the hot electron current induced by the laser plasma interaction at the front side of the target. Radial and longitudinal temperature profiles are calculated to reproduce the observed rear-side plasma expansion. The main parameters of the suprathermal electrons (number, temperature, and divergence) have been deduced from these observations.

High flux of relativistic electrons produced in femtosecond laser-thin foil target interactions: characterization with nuclear techniques

We present a protocol to characterize the high energy electron beam emitted in the interaction of an ultraintense laser with matter at intensities higher than 10(19) W cm(-2). The electron energies and angular distributions are determined as well as the total number of electrons produced above a 10 MeV threshold. This protocol is based on measurements with an electron spectrometer and nuclear activation techniques, combined with Monte Carlo simulations based on the GEANT3 code. The method is detailed and exemplified with data obtained with polypropylene and copper thin solid targets at a laser intensity of 2x10(19) W cm(-2). Special care is taken of the different sources of uncertainties. In particular, the reproducibility of the laser shots is considered.

Estimation of photon dose generated by a short pulse high power laser

The authors obtain a new equation to estimate the forward component of a photon dose generated through the interaction between a target and a short pulse high power laser. As the equation is quite simple, it is useful for calculating the photon dose. The equation shows that the photon dose is proportional to the electron temperature in the range>3 MeV and proportional to the square of the electron temperature in the range<3 MeV. The dose estimated with this method is roughly consistent with the result of Monte Carlo simulation. With some assumptions and corrections, it can reproduce experimental results obtained and the dose result calculated at other laboratories.

Towards a laser neutron driver

During the last few years, important experimental investigations have been made concerning the possibility of induced nuclear fission of high-Z elements by electromagnetic interaction (photofission, electron fission, neutron fission). Fast ions, neutrons and fission fragments from such interactions can be used to pump a laser medium, to produce energy from the (232)Th-(233)U nuclear fission cycle. The main aim of the present work is to study a three-step process, in a relatively new experimental scheme, in order to improve the number of both neutrons and fast ions. In the proposed scheme, high-energy particles and photons are produced by high-intensity laser beam interaction with a solid or gas target, which are utilized later on to trigger the nuclear reactions for the production of (photo) neutrons. These neutrons can give rise to fission of (232)Th that leads through a cascade of decays to (233)U --a highly fissionable material. Such a process will enhance, by an important factor, the final neutron flux and the energetic fission fragments. The use of a high intensity pulsed laser beam will control the turn-on and turn-off of the nuclear reactions and allow one to ensure the security of the whole operation. Finally, the produced neutrons are used to accomplish a major population inversion in an appropriate gas medium for the last stage of amplification of a high-contrast ultra-short laser seed pulse.

Kalpha yields from Ti foils irradiated with ultrashort laser pulses

We have studied the emission of Kalpha radiation from Ti foils irradiated with ultrashort (45 fs) laser pulses. We utilized the fundamental (800 nm) light from a Ti:sapphire laser on bare foils and foils coated with a thin layer of parylene E (CH). The focusing was varied widely to give a range of intensities from approximately 10(15) - 10(19) W cm(-2). Our results show a conversion efficiency of laser to Kalpha energy of approximately 10(-4) at tight focus for both types of targets. In addition, the coated targets exhibited strong secondary peaks of conversion at large defocus, which we believe are due to modification of the extent of preformed plasma due to the dielectric nature of the plastic layer. This in turn affects the level of resonance absorption. A simple model of Kalpha production predicts a much higher conversion than seen experimentally and possible reasons for this are discussed.

Resonance acceleration of electrons in combined strong magnetic fields and intense laser fields

The acceleration mechanism of electrons in combined strong axial magnetic fields and circularly polarized laser pulse fields is investigated by solving the dynamical equations for relativistic electrons both numerically and analytically. We find that the electron acceleration depends not only on the laser intensity, but also on the ratio between electron Larmor frequency and laser frequency. As the ratio approaches unity, a clear resonance peak is observed, corresponding to the laser-magnetic resonance acceleration. Away from the resonance regime, the strong magnetic fields still affect the electron acceleration dramatically. We derive an approximate analytical solution of the relativistic electron energy in adiabatic limit, which provides a full understanding of this phenomenon. Application of our theory to fast ignition of inertial confinement fusion is discussed.