An Integrated Biosensor System With a High-Density Microelectrode Array for Real-Time Electrochemical Imaging

A vertical/horizontal graphene-based microneedle plant sensor for on-site detection of indole-3-acetic acid in vegetables

Plant hormones are important regulators of crop growth and production. In this study, an in situ electrochemical sensor was successfully built using flat microelectrodes with horizontally and vertically grown graphene to detect the plant regulator indole-3-acetic acid (IAA) in plants. Vertical and horizontal graphene layers were prepared by electron-assisted hot-filament chemical vapor deposition. Vertical graphene nanosheets were grown on a horizontal graphene layer as sensing electrodes, and a microneedle sensor was assembled by combining Pt and Ti microelectrodes. The vertical/horizontal graphene (VHG) microneedle sensor can rapidly detect IAA levels in various plants in situ over a wide pH range of 4.0-9.0 and concentration range of 1-100 μM, with a minimum detection limit of 0.21 μM (3σ/S). Subsequently, this microneedle sensor was used to determine the IAA content in different tissues of cucumber and cauliflower stems with satisfactory results. The combination of VHG microelectrode arrays and small electrochemical workstations is useful for constructing portable, low-cost, on-site, and fast electrochemical sensing platforms for plant growth monitoring.

A Multi-Functional CMOS Biosensor Array With On-Chip DEP-Assisted Sensing for Rapid Low-Concentration Analyte Detection and Close-Loop Particle Manipulation With No External Electrodes

This article presents a fully-integrated dielectrophoresis (DEP)-assisted multi-functional CMOS biosensor array chip with 4096 working electrodes (WEs), 12288 photodiodes (PDs), reference electrodes (REs), and counter electrodes (CEs), while each WE and photodiode can be reconfigured to support on-chip DEP actuation, electrochemical potentiostat, optical shadow imaging, and complex impedance sensing. The proposed CMOS biosensor is an example of an actuation-assisted label-free biosensor for the rapid sensing of low-concentration analytes. The DEP actuator of the proposed CMOS biosensor does not require any external electrode. Instead, on-chip WE pairs can be re-used for DEP actuation to simplify the sensor array design. The CMOS biosensor is implemented in a standard 130-nm BiCMOS process. Theoretical analyses and finite element method (FEM) simulations of the on-chip DEP operations are conducted as proof of concept. Biological assay measurements (DEP actuation/electrochemical potentiostat/impedance sensing) with E.coli bacteria and microbeads (optical shadow imaging) demonstrate rapid detection of low-concentration analytes and simultaneous manipulation and detection of large particles. The on-chip DEP operations draw the analytes closer to the sensor electrode surface, which overcomes the diffusion limit and accelerates low-concentration analyte sensing. Moreover, the DEP-based movement of large particles can be readily detected by on-chip photodiode arrays to achieve close-loop manipulation and sensing of particles and droplets. These show the unique advantages of the DEP-assisted multi-functional biosensor.

Advances in In Vitro Models of Neuromuscular Junction: Focusing on Organ-on-a-Chip, Organoids, and Biohybrid Robotics

The neuromuscular junction (NMJ) is a peripheral synaptic connection between presynaptic motor neurons and postsynaptic skeletal muscle fibers that enables muscle contraction and voluntary motor movement. Many traumatic, neurodegenerative, and neuroimmunological diseases are classically believed to mainly affect either the neuronal or the muscle side of the NMJ, and treatment options are lacking. Recent advances in novel techniques have helped develop in vitro physiological and pathophysiological models of the NMJ as well as enable precise control and evaluation of its functions. This paper reviews the recent developments in in vitro NMJ models with 2D or 3D cultures, from organ-on-a-chip and organoids to biohybrid robotics. Related derivative techniques are introduced for functional analysis of the NMJ, such as the patch-clamp technique, microelectrode arrays, calcium imaging, and stimulus methods, particularly optogenetic-mediated light stimulation, microelectrode-mediated electrical stimulation, and biochemical stimulation. Finally, the applications of the in vitro NMJ models as disease models or for drug screening related to suitable neuromuscular diseases are summarized and their future development trends and challenges are discussed.

An Updated Review on Electrochemical Nanobiosensors for Neurotransmitter Detection

Neurotransmitters are chemical compounds released by nerve cells, including neurons, astrocytes, and oligodendrocytes, that play an essential role in the transmission of signals in living organisms, particularly in the central nervous system, and they also perform roles in realizing the function and maintaining the state of each organ in the body. The dysregulation of neurotransmitters can cause neurological disorders. This highlights the significance of precise neurotransmitter monitoring to allow early diagnosis and treatment. This review provides a complete multidisciplinary examination of electrochemical biosensors integrating nanomaterials and nanotechnologies in order to achieve the accurate detection and monitoring of neurotransmitters. We introduce extensively researched neurotransmitters and their respective functions in biological beings. Subsequently, electrochemical biosensors are classified based on methodologies employed for direct detection, encompassing the recently documented cell-based electrochemical monitoring systems. These methods involve the detection of neurotransmitters in neuronal cells in vitro, the identification of neurotransmitters emitted by stem cells, and the in vivo monitoring of neurotransmitters. The incorporation of nanomaterials and nanotechnologies into electrochemical biosensors has the potential to assist in the timely detection and management of neurological disorders. This study provides significant insights for researchers and clinicians regarding precise neurotransmitter monitoring and its implications regarding numerous biological applications.

Programmable Electrochemical Stimulation on a Large-Scale CMOS Microelectrode Array

In this paper we present spatio-temporally controlled electrochemical stimulation of aqueous samples using an integrated CMOS microelectrode array with 131,072 pixels. We demonstrate programmable gold electrodeposition in arbitrary spatial patterns, controllable electrolysis to produce microscale hydrogen bubbles, and spatially targeted electrochemical pH modulation. Dense spatially-addressable electrochemical stimulation is important for a wide range of bioelectronics applications.

Microscope-FTIR Spectrometry Based Sensor for Neurotransmitters Detection

In this work, we present a new sensing approach for aqueous samples based on the microscope-FTIR spectrometer and applied for neurotransmitters. Our contribution in this work consists of a new sample handling system for the microscope-FTIR spectrometer based on a total reflective mirror, a heated hydrophobic layer for solvent removal/evaporation and sample confinement and a microfluidic system that handles sample injection unlike standard sample handling system which was based only on a total reflective mirror. In addition, another part of our contribution consists of proposing a new algorithm to extract molecular composition of the solution with high estimation ratios and based on the analysis of detected peaks on IR spectra. The data acquired from the microscope-FTIR spectrometer was analyzed by a newly developed algorithm to identify each neurotransmitter in homogeneous and non-homogeneous solutions with high selectivity. We used six neurotransmitter molecules (Dopamine hydrochloride, L-Ascorbic acid, Acetylcholine chloride, y-Aminobutyric, Glycine and L-Glutamic acid). The results obtained based on the algorithm developed showed that, using the new system, the six neurotransmitters can be identified in homogeneous and mixture solutions with an estimation ratio range of 88.8%-100% for Dopamine hydrochloride, 80%-100% for L-Ascorbic acid, 75%-100% for Acetylcholine chloride, 75%-100% for L-Glutamic, 77.7%-100% for y-Aminobutyric and 75%-100% for Glycine.

Real-Time Analysis of Oxygen Gradient in Oocyte Respiration Using a High-Density Microelectrode Array

Physiological events related to oxygen concentration gradients provide valuable information to determine the state of metabolizing biological cells. The existing oxygen sensing methods (i.e., optical photoluminescence, magnetic resonance, and scanning electrochemical) are well-established and optimized for existing in vitro analyses. However, such methods also present various limitations in resolution, real-time sensing performance, complexity, and costs. An electrochemical imaging system with an integrated microelectrode array (MEA) would offer attractive means of measuring oxygen consumption rate (OCR) based on the cell’s two-dimensional (2D) oxygen concentration gradient. This paper presents an application of an electrochemical sensor platform with a custom-designed complementary-metal-oxide-semiconductor (CMOS)-based microchip and its Pt-coated surface MEA. The high-density MEA provides 16,064 individual electrochemical pixels that cover a 3.6 mm × 3.6 mm area. Utilizing the three-electrode configuration, the system is capable of imaging low oxygen concentration (18.3 µM, 0.58 mg/L, or 13.8 mmHg) at 27.5 µm spatial resolution and up to 4 Hz temporal resolution. In vitro oxygen imaging experiments were performed to analyze bovine cumulus-oocytes-complexes cells OCR and oxygen flux density. The integration of a microfluidic system allows proper bio-sample handling and delivery to the MEA surface for imaging. Finally, the imaging results are processed and presented as 2D heatmaps, representing the dissolved oxygen concentration in the immediate proximity of the MEA. This paper provides the results of real-time 2D imaging of OCR of live cells/tissues to gain spatial and temporal dynamics of target cell metabolism.

Digital Electrochemistry for On-Chip Heterogeneous Material Integration

Many modern electronic applications rely on functional units arranged in an active-matrix integrated on a single chip. The active-matrix allows numerous identical device pixels to be addressed within a single system. However, next-generation electronics requires heterogeneous integration of dissimilar devices, where sensors, actuators, and display pixels sense and interact with the local environment. Heterogeneous material integration allows the reduction of size, increase of functionality, and enhancement of performance; however, it is challenging since front-end fabrication technologies in microelectronics put extremely high demands on materials, fabrication protocols, and processing environments. To overcome the obstacle in heterogeneous material integration, digital electrochemistry is explored here, which site-selectively carries out electrochemical processes to deposit and address electroactive materials within the pixel array. More specifically, an amorphous indium-gallium-zinc oxide (a-IGZO) thin-film-transistor (TFT) active-matrix is used to address pixels within the matrix and locally control electrochemical reactions for material growth and actuation. The digital electrochemistry procedure is studied in-depth by using polypyrrole (PPy) as a model material. Active-matrix-driven multicolored electrochromic patterns and actuator arrays are fabricated to demonstrate the capabilities of this approach for material integration. The approach can be extended to a broad range of materials and structures, opening up a new path for advanced heterogeneous microsystem integration.

Wide Input Dynamic Range Fully Integrated Capacitive Sensor for Life Science Applications

This paper presents a new fully integrated CMOS capacitance sensor chip with a wider input dynamic range (IDR) compared to the state-of-the-art, suitable for a variety of life science applications. With the novel differential capacitance to current conversion topology, it achieves an IDR of about seven times higher compared to the previous charge based capacitive measurement (CBCM) circuits and about three times higher compared to the CBCM with cascode current mirrors. It also features a calibration circuitry consisting of an array of switched capacitors, interdigitated electrodes (IDEs) realized on the topmost metal layer, a current-controlled 300 MHz oscillator, and a counter-serializer to create digital output. The proposed sensor, fabricated in AMS 0.35 μm CMOS technology, enables a high-resolution measurement, equal to 416 aF, of physiochemical changes in the IDE with up to 1.27 pF input offset adjustment range (IOAR). With a measurement speed of 15 μs, this sensor is among the fast CMOS capacitive sensors in the literature. In this paper, we demonstrate its functionality and applicability and present the experimental results for monitoring 2 μL evaporating droplets of chemical solvents. By using samples of solvents with different conductivity and relative permittivity, a wide range of capacitance and resistance variations in the sample-IDE interface electric equivalent model can be created. In addition, the evaporating droplet test has inherently fast dynamic changes. Based on the results, our proposed device addresses the challenge of detecting small capacitance changes despite large parasitic elements caused by the ions in the solution or by remnants deposited on the electrode.

Quantifying neurotransmitter secretion at single-vesicle resolution using high-density complementary metal-oxide-semiconductor electrode array

Neuronal exocytosis facilitates the propagation of information through the nervous system pertaining to bodily function, memory, and emotions. Using amperometry, the sub-millisecond dynamics of exocytosis can be monitored and the modulation of exocytosis due to drug treatment or neurodegenerative diseases can be studied. Traditional single-cell amperometry is a powerful technique for studying the molecular mechanisms of exocytosis, but it is both costly and labor-intensive to accumulate statistically significant data. To surmount these limitations, we have developed a silicon-based electrode array with 1024 on-chip electrodes that measures oxidative signal in 0.1 millisecond intervals. Using the developed device, we are able to capture the modulation of exocytosis due to Parkinson's disease treatment (L-Dopa), with statistical significance, within 30 total minutes of recording. The validation study proves our device's capability to accelerate the study of many pharmaceutical treatments for various neurodegenerative disorders that affect neurotransmitter secretion to a matter of minutes.