Fast and Accurate Approach to RF-DC Conversion Efficiency Estimation for Multi-Tone Signals

The paper presents a computationally efficient and accurate numerical approach to evaluating RF-DC power conversion efficiency (PCE) for energy harvesting circuits in the case of multi-tone power-carrying signal with periodic envelopes. This type of signal has recently received considerable attention in the literature. It has been shown that their use may result in a higher PCE than the conventional sine wave signal for low to medium input power levels. This reason motivated the authors to develop a fast and accurate two-frequency harmonic balance method (2F-HB), as fast PCE calculation might appreciably expedite the converter circuit optimization process. In order to demonstrate the computational efficiency of the 2F-HB, a comparative study is performed. The results of this study show that the 2F-HB significantly outperforms such extensively used methods as the transient analysis (TA), the harmonic balance method (HB), and the multidimensional harmonic balance method (MHB). The method also outperforms the commercially available non-linear circuit simulator Keysight ADS employing both HB and MHB. Furthermore, the proposed method can be readily integrated into commonly used commercially available non-linear circuit simulation software, including the Keysight ADS, Ansys HFSS, just to name a few-minor modifications are required. In addition, to increase the correctness and reliability of the proposed method, the influence of PCB is considered by calculating Y parameters of its 3D model. The widely employed voltage doubler-based RF-DC converter for energy harvesting and wireless power transfer (WPT) in sub-GHz diapason is chosen to validate the proposed method experimentally. This RF-DC converter is chosen for its simplicity and capability to provide sufficiently high PCE. The measurements of the PCE for a voltage doubler prototype employing different multi-tone waveform signals were performed in laboratory conditions. Various combinations of the matching circuit element values were considered to find the optimal one in both-theoretical model and experimental prototype. The measured PCE is in very good agreement with the PCE calculated numerically, which attests to the validity of the proposed approach. The proposed PCE estimation method is not limited to one selected RF-DC conversion circuit and can also be applied to other circuits and frequency bands. The comparison of the PCE obtained by means of the proposed approach and the measured one shows very good agreement between them. The PCE estimation error reaches as low as 0.37%, and the maximal estimation error is 32.65%.

TranSIESTA: A Spice for Molecular Electronics

Our recently developed method, TranSIESTA, enables modelling of molecular electronic devices under operation conditions. The method is based on density functional theory, and calculates the self-consistent electronic structure of a nanostructure coupled to three-dimensional electrodes with different electrochemical potentials. It uses a full atomistic ab initio description of both the electrodes and the nanoscale device. The calculations reveal information about the scattering states, transmission coefficients, electron current, and non-equilibrium forces in the systems. In this paper we use the method to investigate the electrical properties of three ring phenyl-ethynylene oligomers (OPE). We present results for the electrical effect of side groups and molecular conformations of the molecules. The calculations indicate that molecular switching and negative differential conductance (NDC) are related to rotations of the middle phenyl ring.