Adsorptive Removal of Cationic Dye from Aqueous Solution by Graphene Oxide/Cellulose Acetate Composite

Surface Characteristics of Electrospun p-Sulphonated Calix[4]Arene Functionalized Cellulose Acetate Nanofiber and Its Behaviour towards Methylene Blue Adsorption

p-sulphonated calix[4]arene (p-SOCX) functionalized cellulose acetate/graphene oxide (CA/GO) nanofibers were successfully prepared via the electrospinning technique. The presence of p-SOCX within the fiber matrix was ascertained using Fourier Transform Infrared spectroscopy and Carbon-Hydrogen-Nitrogen-Sulphur elemental analyses. Apparent changes in morphology of the samples were observed under scanning electron microscope where fiber diameters increased with increasing p-SOCX content. Preliminary dye removal test at different pH, dosage, and temperature of functionalized CA/GO nanofiber demonstrates enhanced adsorption capacity of methylene blue in presence of p-SOCX compared to pristine CA nanofiber and CA/GO nanofiber at an optimum pH 8. The highest removal efficiency obtained was 88.84% with initial methylene blue dye concentration of 10 mg/L, adsorbent dosage of 20 mg/10 mL, contact time of 30 min at room temperature ca. 293 K.

Electrospinning of multifunctional cellulose acetate membrane and its adsorption properties for ionic dyes

Electrospinning of cellulose acetate with appropriated solvent system is the most straightforward method for fabricating micro- and nanofibers. To simultaneously and effectively remove both cationic and anionic dyes, a novel cost-effective multifunctional cellulose acetate (CA) fibers membrane was prepared by electrospinning followed by deacetylation, carboxymethylation and polydopamine (PDA) coating. The adsorption properties of PDA@DCA-COOH membrane were evaluated with methylene blue (MB) and Congo red (CR) as the ionic representatives for their removal. The results indicated that carboxyl, hydroxyl and amine multifunctional groups had been successfully grafted on the surface of the nanofibers with the maximum adsorption capacities of 69.89 and 67.31 mg g-1 for MB and CR, respectively, in the individual systems. The effect of co-existed dyes, inorganic salts and surfactants on the uptake of MB and CR in the simulated real complex system was strongly depended on the initial pH and ionic strength of the solution. The excellent adsorption capacities of the composite membrane were due to strong electrostatic attraction through the abundant functional groups on PDA@DCA-COOH surface. Based on its excellent recycling performance and adsorption property, PDA@DCA-COOH has a promising potential as an effective adsorbent in water treatment.

Preparation of transparent anti-pollution cellulose carbamate regenerated cellulose membrane with high separation ability

In this study, cellulose pulp and urea were used to synthesize cellulose carbamate (nitrogen content reaches 4.5%) by low-cost and environmentally friendly solid-liquid phase method. Cellulose carbamate fluid was prepared by using sodium hydroxide aqueous solution as solvent. The fluid was regenerated and formed in a coagulation bath, and finally a regenerated cellulose membrane with high transparency and separation ability was obtained. The simple chemical treatment of cellulose not only greatly increased the mass fraction of cellulose dissolution (It has reached 15%) and retains the original crystal form and thermal stability of cellulose. The surface of the membrane was relatively dense, and the inside has regular microchannel. The factors affect the transparency and water flux of regenerated cellulose membranes were discussed by orthogonal experimental range analysis. The ability of the regenerated cellulose membrane to reject dyes was tested. The results showed that the rejection of methyl blue and congo red reached 100%, and the rejection rate of methyl orange reached 60%. The oil/water separation ability and the anti-pollution ability of the regenerated cellulose membrane were tested. The oil/water separation effect reached 100%. This membrane may have application prospect in water treatment, biotechnology.