Surface Functional Groups Affect Iron (Hydr)oxide Heterogeneous Nucleation: Implications for Membrane Scaling

Because of its favorable thermodynamics and fast kinetics, heterogeneous solid nucleation on membranes triggers early-stage mineral scaling. Iron (hydr)oxide, a typical membrane scale, initially forms as nanoparticles that interact with surface functional groups on membranes, but these nanoscale phenomena are difficult to observe in real time. In this study, we utilized in situ grazing incidence small angle X-ray scattering and ex situ atomic force microscopy to examine the heterogeneous nucleation of iron (hydr)oxide on surface functional groups commonly used in membranes, including hydroxyl (OH), carboxyl (COOH), and fluoro (F) groups. We found that, compared to nucleation on hydrophilic OH- and COOH-surfaces, the high hydrophobicity of an F-modified surface significantly reduced the extents of both heterogeneously and homogeneously formed iron (hydr)oxide nucleation. Moreover, on the OH-surface, the high functional group density of 0.76 nmol/cm² caused faster heterogeneous nucleation than that on a COOH-surface, with a density of 0.28 ± 0.04 nmol/cm². The F-surface also had the highest heterogeneous nucleation energy barrier (26 ± 0.6 kJ/mol), followed by COOH- (23 ± 0.8 kJ/mol) and OH- (20 ± 0.9 kJ/mol) surfaces. The kinetic and thermodynamic information provided here will help us better predict the rates and extents of early-stage scaling of iron (hydr)oxide nanoparticles in membrane processes.

Comparative effectiveness of membrane technologies and disinfection methods for virus elimination in water: A review

The pandemic of the 2019 novel coronavirus disease (COVID-19) has brought viruses into the public horizon. Since viruses can pose a threat to human health in a low concentration range, seeking efficient virus removal methods has been the research hotspots in the past few years. Herein, a total of 1060 research papers were collected from the Web of Science database to identify technological trends as well as the research status. Based on the analysis results, this review elaborates on the state-of-the-art of membrane filtration and disinfection technologies for the treatment of virus-containing wastewater and drinking water. The results evince that membrane and disinfection methods achieve a broad range of virus removal efficiency (0.5-7 log reduction values (LRVs) and 0.09-8 LRVs, respectively) that is attributable to the various interactions between membranes or disinfectants and viruses having different susceptibility in viral capsid protein and nucleic acid. Moreover, this review discusses the related challenges and potential of membrane and disinfection technologies for customized virus removal in order to prevent the dissemination of the waterborne diseases.

Understanding the fate of nano-plastics in wastewater treatment plants and their removal using membrane processes

Nanoplastics (NPs) have become a major environmental issue due to their adverse effect on the water environment. Wastewater treatment plant (WWTP) is considered as one of the main sources for breaking down of larger-sized plastic debris and microplastics (MPs) into NPs. This study aims to provide a comprehensive understanding of NPs generation in the WWTPs, their physiochemical characteristics and interaction with the WWTPs. It is found that cracking is the major mechanism of plastics fragmentation in the WWTPs. This review also discusses the current membrane process used for NPs removal. It is found that conventional membrane processes are ineffective as they are not designed for NPs removal and fouling is a major obstacle for its application. Therefore, this study concludes by providing an outlook of developing a bio-nanofiltration process that can be used as a tertiary treatment for removing NPs and other components present in water. Such a process can produce NPs-free water for non-potable use or safe discharge into open waterways.

Clinical Autopsy of a Reverse Osmosis Membrane Module

The desalination of seawater using reverse osmosis membranes is an attractive solution to global freshwater scarcity. However, membrane performance is reduced by (bio)fouling. Membrane autopsies are essential for identifying the type of fouling material, and applying corrective measures to minimize membrane fouling. Information from full-scale membrane autopsies guiding improved plant operations is scant in the formal literature. In this case-study, a reverse osmosis membrane from a full-scale seawater desalination plant with a feed channel pressure drop increase of about 218% over the pressure vessel was autopsied. The simultaneous determination of microbial cells, ATP, and total organic carbon (TOC) abundances per membrane area allowed estimating the contributions of biofouling and organic fouling. The abundance of microbial cells determined by flow cytometry (up to 7 × 108 cells/cm2), and ATP (up to 21,000 pg/cm2) as well as TOC (up to 98 μg/cm2) were homogeneously distributed on the membrane. Inorganic fouling was also measured, and followed a similar coverage distribution to that of biofouling. Iron (∼150 μg/cm2, estimated by ICP-MS) was the main inorganic foulant. ATR-FTIR spectra supported that membrane fouling was both organic/biological and inorganic. High-resolution SEM-EDS imaging of cross-sectioned membranes allowed assessing the thickness of the fouling layer (up to 20 μm) and its elemental composition. Imaging results further supported the results of homogeneous fouling coverage. Moreover, imaging revealed both zones with and without compression of the polysulfone membrane layer, suggesting that the stress due to operating pressure was heterogeneous. The procedure for this membrane autopsy provided a reasonable overview of the diverse contributors of fouling and might be a starting point to building a consensus autopsy protocol. Next, it would be valuable to build a RO membrane autopsy database, which can be used as a guidance and diagnostic tool to improve the management and operation of RO desalination plants.

Repeated pressurization as a potential cause of deterioration in virus removal by aged reverse osmosis membrane used in households

Reverse osmosis (RO) membrane is widely used for household water treatment in areas with limited access to safe drinking water; however, some studies documented deterioration in the quality of RO permeate. Repeated pressurization from intermittent operation in households is suspected to have an adverse effect on RO. This study aimed to evaluate virus removal by RO used in actual households as well as the water quality of permeate, and to elucidate the main cause of RO deterioration. We conducted a survey in households in Hanoi, Vietnam, to collect 27 membranes along with their usage history, where virus removal was investigated in laboratory. Of the used RO membranes, 22% did not show the protective level, >3 log₁₀ (99.9%) virus removal, recommended by World Health Organization. The differences in virus removal among Aichi virus, MS2 and φX-174 were <0.5 log₁₀. All membranes with estimated pressurization times of <4000 showed >3 log₁₀ virus removal, while 17% of membranes used for <3years, the manufacturers' warranty period, did not achieve the criterion. Therefore, virus removal performance may not be assured even if the users replace the membrane following the warranty period. Furthermore, more pressurized membranes exhibited significantly lower virus removal than less pressurized ones, suggesting a major role of repeated pressurization in the deterioration of RO. Coliforms were detected from 44% of the permeate of the point-of-use devices applying RO (RO-POU), raising concerns on the extrinsic contamination and regrowth of bacteria. Consequently, RO in households may deteriorate more rapidly than the manufactures' expectation due to repeated pressurization. RO in households should be replaced based on not only membrane age but also total pressurized times (i.e., 4000 times) to keep the protective level of virus removal. The deteriorated bacterial quality in RO permeate suggested the need for installing post-treatment, such as UV irradiation.

Nano/microplastics in water and wastewater treatment processes - Origin, impact and potential solutions

The presence of nano and microplastics in water has increasingly become a major environmental challenge. A key challenge in their detection resides in the relatively inadequate analytical techniques available preventing deep understanding of the fate of nano/microplastics in water. The occurrence of nano/microplastics in water and wastewater treatment plants poses a concern for the quality of the treated water. Due to their broad but small size and diverse chemical natures, nano/microplastics may travel easily along water and wastewater treatment processes infiltrating remediation processes at various levels, representing operational and process stability challenges. This review aims at presenting the current understanding of the fate and impact of nano/microplastics through water and wastewater treatment plants. The formation and fragmentation mechanisms, physical-chemical properties and occurrence of nano/microplastics in water are correlated to the interactions of nano/microplastics with water and wastewater treatment plant processes and potential solutions to limit these interactions are comprehensively reviewed. This critical analysis offers new strategies to limit the number of nano/microplastics in water and wastewater to keep water quality up to the required standards and reduce threats on our ecosystems.