Optimization of Adhesive Pastes for Dental Caries Prevention

Effect of combining aminomethacrylate and fluoride against erosive and abrasive challenges on enamel and dentin

This study evaluated the effect of solutions containing aminomethacrylate copolymer (AA) and sodium fluoride (F; 225 ppm F-) or fluoride plus stannous chloride (FSn; 225 ppm F-, 800 ppm Sn2+) against enamel and dentin erosion/abrasion. Solutions F, FSn, AA, F+AA, FSn+AA, and deionized water as negative control were tested. Bovine enamel and dentin specimens (n = 13/solution/substrate) underwent a set of erosion-abrasion cycles (0.3% citric acid [5 min, 4×/day], human saliva [1 h, 4×/day], brushing [15 s, 2×/day], and treatments [2 min, 2×/day]) for each of five days. Initial enamel erosion was evaluated using Knoop microhardness after the first and second acid challenge on day 1, and surface loss with profilometry after day 5. KOH-soluble fluoride was assessed. Data were analyzed with ANOVA/Tukey tests. The combination of fluoride and AA resulted in higher protection against enamel erosion, whereas this was not the case for the combination of AA and FSn. All treatments protected against enamel and dentin loss. The lowest surface loss values were observed with F+AA and FSn+AA. The polymer did not significantly influence the KOH-soluble fluoride formation on enamel/dentin specimens. The aminomethacrylate copolymer effectively enhanced the efficacy of sodium fluoride against initial erosion and improved the control of enamel and dentin wear of F and FSn solutions.

Remineralization potential of apacider mangosteen adhesive pastes on artificial carious lesions

Background/purpose

Attention to caries administration has altered toward an early finding of lesions and targeted to noninvasive management with a remineralizing agent. This study compared the remineralization potential of apacider mangosteen adhesive pastes (AMAP), 500-ppm fluoride toothpaste (FT500), and 1000-ppm fluoride toothpaste (FT1000) on artificial caries.

Materials and methods

Artificial caries were generated to enamel of eighty extracted human premolars. The specimens were allocated to four groups and subjected to pH-cycling with the application of testing agents (2 min each, for 10 days): (1) AMAP, dairy, (2) FT500, twice a day, (3) FT1000, twice a day, and (4) no treatment (NT). The surface microhardness was determined before demineralization, after demineralization, and after application of pH-cycling. The hardness, percent of hardness recovery (%HR), and percent of remineralization potential (%RP) were analyzed with ANOVA and Bonferroni's test (α = 0.05). Polarized light microscopy (PLM) was assessed for lesion depth.

Results

Significant differences in remineralization were observed upon various agents compared to NT (P < 0.05). A significant difference in remineralization was found among AMAP, FT1000, and FT500 (P < 0.05). No significant difference in %HR and %RP was observed between AMAP and FT1000 (P > 0.05). PLM signified greater decrease in depth for AMAP, compared to FT1000 and FT500, but no depth reduction for NT.

Conclusion

AMAP possesses comparable remineralization ability to FT1000. However, decreasing in depth of carious lesions was evinced with using AMAP more than FT1000 and FT500. AMAP was recommended as a potential remineralization material for handling initial caries.

α-Mangostin and lawsone methyl ether in tooth gel synergistically increase its antimicrobial and antibiofilm formation effects in vitro

OBJECTIVES

α-Mangostin (α-MG) and lawsone methyl ether (LME) show antimicrobial and anti-biofilm activities. The objectives of this study were to develop a herbal tooth gel containing α-MG and LME plus fluoride and determine its antimicrobial, anti-biofilm formation, anti-cancer, anti-inflammatory, wound healing, and enamel microhardness effects.

METHODS

Antimicrobial assays against Streptococcus mutans, Porphyromonas gingivalis, and Candida albicans were performed. The microbes' ultrastructural morphology was assessed using Transmission Electron Microscopy. The effect on microbial biofilm formation was tested by a broth microdilution. Cell viability was assessed with MTT assay. The anti-inflammatory effect was investigated by measuring inhibition of nitric oxide production. Enamel microhardness was measured via Vickers microhardness testing. The enamel chemical composition was investigated with Fourier Transform Spectrometer. The enamel surface morphology and fluoride content were examined by Scanning Electron Microscopy and Energy Dispersive X-ray Spectroscopy.

RESULTS

The results show synergistic effects of α-MG and LME on antimicrobial activity and antibiofilm formation without cytotoxicity at a therapeutic dose. At a higher dose, the tooth gel inhibited proliferation of cancer cell line. Enamel microhardness was increased after brushing with the tooth gel plus fluoride. A large amount of fluoride was detected on the enamel surface.

CONCLUSION

The tooth gel containing α-MG and LME synergized its antimicrobial activity and antibiofilm formation and inhibited oral cancer cell proliferation. Incorporating fluoride into the tooth gel increased enamel microhardness. Thus, the herbal tooth gel containing α-MG and LME plus fluoride may be useful for preventing dental caries and promoting oral health.

Engineered Biomaterials Trigger Remineralization and Antimicrobial Effects for Dental Caries Restoration

Dental caries is the most prevalent chronic disease globally, significantly impacting individuals' quality of life. A key reason behind the failure of implanted restorations is their biological inactivity, meaning they are unable to form crosslinks with the surrounding tooth structures, thus making patients susceptible to implant loss and recurrent tooth decay. For the treatment of caries, antibacterial medicine and remineralization are effective means of treating the recurrence of caries. Owing to the rapid progression in the biomaterials field, several biomaterials have been reported to display antimicrobial properties and aid in dentin remineralization. Bioactive materials hold considerable potential in diminishing biofilm accumulation, inhibiting the process of demineralization, enabling dentin remineralization, and combating bacteria related to caries. Bioactive materials, such as fluoride, amorphous calcium phosphate, bioactive glass, collagen, and resin-based materials, have demonstrated their effectiveness in promoting dentin remineralization and exerting antibacterial effects on dental caries. However, the concentration of fluoride needs to be strictly controlled. Although amorphous calcium phosphate can provide the necessary calcium and phosphorus ions for remineralization, it falls short in delivering the mechanical strength required for oral mastication. Resin-based materials also offer different advantages due to the complexity of their design. In this review, we delve into the application of advanced bioactive materials for enhancing dentin remineralization and antibacterial properties. We eagerly anticipate future developments in bioactive materials for the treatment of dental caries.

Film-Forming Polymers for Tooth Erosion Prevention

Different agents have been proposed to prevent the progression of acid induced dental substance losses, which are called erosive tooth wear (ETW), such as fluorides, calcium, and phosphate-based products; however, there is a need for a further increase in efficacy. Recently, the ability of polymers to interact with the tooth surface, forming acid resistant films, has come into the focus of research; nevertheless, there is still the need for a better understanding of their mode of action. Thus, this article provides an overview of the chemical structure of polymers, their mode of action, as well as the effect of their incorporation into oral care products, acid beverages, and antacid formulations, targeting the prevention of ETW. Recent evidence indicates that this may be a promising approach, however, additional studies are needed to confirm their efficacy under more relevant clinical conditions that consider salivary parameters such as flow rate, composition, and clearance. The standardization of methodological procedures such as acid challenge, treatment duration, and combination with fluorides is necessary to allow further comparisons between studies. In conclusion, film-forming polymers may be a promising cost-effective approach to prevent and control erosive demineralization of the dental hard tissue.

Important Roles and Potential Uses of Natural and Synthetic Antimicrobial Peptides (AMPs) in Oral Diseases: Cavity, Periodontal Disease, and Thrush

Numerous epithelial cells and sometimes leukocytes release AMPs as their first line of defense. AMPs encompass cationic histatins, defensins, and cathelicidin to encounter oral pathogens with minimal resistance. However, their concentrations are significantly below the effective levels and AMPs are unstable under physiological conditions due to proteolysis, acid hydrolysis, and salt effects. In parallel to a search for more effective AMPs from natural sources, considerable efforts have focused on synthetic stable and low-cytotoxicy AMPs with significant activities against microorganisms. Using natural AMP templates, various attempts have been used to synthesize sAMPs with different charges, hydrophobicity, chain length, amino acid sequence, and amphipathicity. Thus far, sAMPs have been designed to target Streptococcus mutans and other common oral pathogens. Apart from sAMPs with antifungal activities against Candida albicans, future endeavors should focus on sAMPs with capabilities to promote remineralization and antibacterial adhesion. Delivery systems using nanomaterials and biomolecules are promising to stabilize, reduce cytotoxicity, and improve the antimicrobial activities of AMPs against oral pathogens. Nanostructured AMPs will soon become a viable alternative to antibiotics due to their antimicrobial mechanisms, broad-spectrum antimicrobial activity, low drug residue, and ease of synthesis and modification.

The Potential of α-Mangostin from Garcinia mangostana as an Effective Antimicrobial Agent-A Systematic Review and Meta-Analysis

This systematic review aims to evaluate the antimicrobial activity of α-mangostin derived from Garcinia mangostana against different microbes. A literature search was performed using PubMed and Science Direct until March 2022. The research question was developed based on a PICO (Population, Intervention, Control and Outcomes) model. In this study, the population of interest was microbes, α-mangostin extracted from Garcinia mangostana was used as exposure while antibiotics were used as control, followed by the outcome which is determined by the antimicrobial activity of α-mangostin against studied microbes. Two reviewers independently performed the comprehensive literature search following the predetermined inclusion and exclusion criteria. A methodological quality assessment was carried out using a scoring protocol and the risk of bias in the studies was analyzed. Reward screening was performed among the selected articles to perform a meta-analysis based on the pre-determined criteria. Case groups where α-mangostin extracted from Garcinia mangostana was incorporated were compared to groups using different antibiotics or antiseptic agents (control) to evaluate their effectiveness. A total of 30 studies were included; they were heterogeneous in their study design and the risk of bias was moderate. The results showed a reduction in microbial counts after the incorporation of α-mangostin, which resulted in better disinfection and effectiveness against multiple microbes. Additionally, the meta-analysis result revealed no significant difference (p > 0.05) in their effectiveness when α-mangostin was compared to commercially available antibiotics. α-mangostin worked effectively against the tested microbes and was shown to have inhibitory effects on microbes with antibiotic resistance.

Protective Effect of Solutions Containing Polymers Associated with Fluoride and Stannous Chloride on Hydroxyapatite Dissolution

This study investigated the protective effect of experimental solutions containing 4 polymers (polyoxirane, hydroxypropylmethylcellulose [HPMC], pectin, and an amino methacrylate copolymer [AMC]) in 2 concentrations (low and high) associated or not with sodium fluoride (F; 225 ppm F-) or sodium fluoride plus stannous chloride (FS; 800 ppm Sn2+) on the dissolution of hydroxyapatite crystals (HA). Deionized water was the control. The pretreated HA was added to a 0.3% citric acid solution (pH 3.8). An automatic titrant machine added aliquots of 0.1 N HCl at a rate of 28 μL/min, in a total reaction time of 5 min. Groups were compared with 2-way ANOVA and Tukey's test, and concentrations with Student t test (5%). The zeta potential of the HA treated with the solutions was measured. Significant differences were found for both factors and interaction (p < 0.0001). The treatments with F and FS solutions resulted in a lower amount of dissolved HA than the control. Among the polymers' solutions, only AMC was able to reduce the amount of dissolved HA, changing the surface charge of HA to positive. AMC improved the protective effect of F, but it did not affect FS. Polyoxirane and HPMC reduced the protective potential of the FS solution. No differences were found between the concentrations of the polymers. It was concluded that F and FS reduced the amount of dissolved HA. The protective effect of the experimental solutions against HA dissolution was polymer dependent. The F effect was enhanced by its combination with AMC, but the protection of FS was impaired by polyoxirane and HPMC.

Application of Antibiotics/Antimicrobial Agents on Dental Caries

Dental caries is the most common oral disease. The bacteriological aetiology of dental caries promotes the use of antibiotics or antimicrobial agents to prevent this type of oral infectious disease. Antibiotics have been developed for more than 80 years since Fleming discovered penicillin in 1928, and systemic antibiotics have been used to treat dental caries for a long time. However, new types of antimicrobial agents have been developed to fight against dental caries. The purpose of this review is to focus on the application of systemic antibiotics and other antimicrobial agents with respect to their clinical use to date, including the history of their development, and their side effects, uses, structure types, and molecular mechanisms to promote a better understanding of the importance of microbial interactions in dental plaque and combinational treatments.

Recent updates on metabolite composition and medicinal benefits of mangosteen plant

BACKGROUND

Mangosteen (Garcinia mangostana L.) fruit has a unique sweet-sour taste and is rich in beneficial compounds such as xanthones. Mangosteen originally been used in various folk medicines to treat diarrhea, wounds, and fever. More recently, it had been used as a major component in health supplement products for weight loss and for promoting general health. This is perhaps due to its known medicinal benefits, including as anti-oxidant and anti-inflammation. Interestingly, publications related to mangosteen have surged in recent years, suggesting its popularity and usefulness in research laboratories. However, there are still no updated reviews (up to 2018) in this booming research area, particularly on its metabolite composition and medicinal benefits.

METHOD

In this review, we have covered recent articles within the years of 2016 to 2018 which focus on several aspects including the latest findings on the compound composition of mangosteen fruit as well as its medicinal usages.

RESULT

Mangosteen has been vastly used in medicinal areas including in anti-cancer, anti-microbial, and anti-diabetes treatments. Furthermore, we have also described the benefits of mangosteen extract in protecting various human organs such as liver, skin, joint, eye, neuron, bowel, and cardiovascular tissues against disorders and diseases.

CONCLUSION

All in all, this review describes the numerous manipulations of mangosteen extracted compounds in medicinal areas and highlights the current trend of its research. This will be important for future directed research and may allow researchers to tackle the next big challenge in mangosteen study: drug development and human applications.