Monitoring trabecular bone microdamage using a dynamic acousto-elastic testing method

Non destructive characterization of cortical bone micro-damage by nonlinear resonant ultrasound spectroscopy

The objective of the study was to evaluate the ability of a nonlinear ultrasound technique, the so-called nonlinear resonant ultrasound spectroscopy (NRUS) technique, for detecting early microdamage accumulation in cortical bone induced by four-point bending fatigue. Small parallelepiped beam-shaped human cortical bone specimens were subjected to cyclic four-point bending fatigue in several steps. The specimens were prepared to control damage localization during four-point bending fatigue cycling and to unambiguously identify resonant modes for NRUS measurements. NRUS measurements were achieved to follow the evolution of the nonlinear hysteretic elastic behavior during fatigue-induced damage. After each fatigue step, a small number of specimens was removed from the protocol and set apart to quantitatively assess the microcrack number density and length using synchrotron radiation micro-computed tomography (SR-µCT). The results showed a significant effect of damage steps on the nonlinear hysteretic elastic behavior. No significant change in the overall length of microcracks was observed in damaged regions compared to the load-free control regions. Only an increased number of shortest microcracks, those in the lowest quartile, was noticed. This was suggestive of newly formed microcracks during the early phases of damage accumulation. The variation of nonlinear hysteretic elastic behavior was significantly correlated to the variation of the density of short microcracks. Our results suggest that the nonlinear hysteretic elastic behavior is sensitive to early bone microdamage. Therefore NRUS technique can be used to monitor fatigue microdamage progression in in vitro experiments.

Correlations of linear and nonlinear ultrasound parameters with density and microarchitectural parameters in trabecular bone

In the present study, correlations of linear and nonlinear ultrasound parameters (speed of sound, normalized broadband ultrasound attenuation, and nonlinear parameter B/A) with bone mineral density and microarchitectural parameters were investigated in 28 bovine femoral trabecular bone samples in vitro. All three ultrasound parameters exhibited relatively high correlation coefficients with the indexes of bone quantity (bone mineral density and bone volume fraction) and lower correlation coefficients with the remaining microarchitectural parameters. These results suggest that B/A, in addition to speed of sound and attenuation, may have potential as an index for the assessment of bone status and osteoporosis.

Nonlinear elastodynamics in micro-inhomogeneous solids observed by head-wave based dynamic acoustoelastic testing

Dynamic acoustoelastic testing provides a more complete insight into the acoustic nonlinearity exhibited by micro-inhomogeneous media like granular and cracked materials. This method consists of measuring time of flight and energy modulations of pulsed ultrasonic waves induced by a low-frequency standing wave. Here pulsed ultrasonic head waves were employed to assess elastic and dissipative nonlinearities in a region near the surface of a solid. Synchronization of the ultrasound pulse sequence with the low-frequency excitation provided instantaneous variations in the elastic modulus and the attenuation as functions of the instantaneous low-frequency strain. Weak quadratic elastic nonlinearity and no dissipative nonlinearity were detected in duralumin. In limestone, distinction between tensile and compressive behaviors revealed an asymmetry in the acoustic nonlinearity and hysteresis in both the elastic modulus and the attenuation variations. Measured nonlinear acoustical parameters are in good agreement with values obtained by different techniques. Reversible acoustically induced conditioning modified the acoustic nonlinearity both quantitatively and qualitatively. It reduced tension-compression asymmetry, suggesting a nonequilibrium modification of the sources of acoustic nonlinearity. Additionally to the metrology of the acoustic nonlinearity, head wave based dynamic acoustoelastic testing may be a useful tool to monitor changes in the microstructure or the accumulation of damage in solids.