Influences and Failure Analysis of the Interaction Between Melt and Gas on Double-Layer Gas-Assisted Extrusion Molding of Polymer Micro-Catheters

Although the extrudate swelling, melt fracture, and extrusion deformation of polymer micro-catheters in traditional extrusion molding can be eliminated via the double-layer gas-assisted extrusion (DL-GAE) method, some failure problems are generated under unreasonable process conditions. To ascertain the reasons for failure in DL-GAE molding of polymer micro-catheters, the influences of the interaction between the melt and double assisted gas on the DL-GAE molding of polymer micro-catheters were experimentally and numerically studied. Meanwhile, a DL-GAE die and experimental system were designed and constructed. We analyzed the influence laws of the melt and assisted gas on the DL-GAE molding of polymer micro-catheters, as well as reasons for the molding's failure. Our studies demonstrate that under the condition of stable DL-GAE, as the melt flow rate increases, the wall thickness and diameter of polypropylene (PP) micro-catheters increase. When the melt flow rate continuously increases, the stability of the assisted gas is destroyed, resulting in the failure of DL-GAE. In addition, under synchronized pressures of a double gas-assisted layer, the diameters of the micro-catheters increase, but their wall thickness decreases. Under an individual pressure increase of the outer gas-assisted layer, surface bump defects are generated. Under an individual pressure increase of the inner gas-assisted layer, the diameters of PP micro-catheters swell prominently until they break. Therefore, although DL-GAE can eliminate extrusion problems of polymer micro-catheters, it is suggested that reasonable process parameters for the melt and double assisted gas should be satisfied and matched. This work can provide significant technical support for the DL-GAE of polymer micro-catheters during manufacture.

Comparative analysis of gas-assisted extrusion of polypropylene sheet based on two types of gas intake

The formation of a stable gas layer is to have a significant effect on polymer gas-assisted extrusion (GAE). Previously, for vertical extrusion forming, the gap intake method was used, which tends to result in very short stabilization times for the gas layer. In this study, the effect of two gas intake modes was compared based on horizontal sheet extrusion. The results show that stabilization of the gas layer is easily achieved in the vertical gas-assisted die by introducing gas first. However, when using parallel die, the gas distributes the melt uniformly along the surrounding velocity and the gas layer can be stable for a long time. Moreover, disrupting the process sequence also makes it easy to achieve gas layer stability without affecting the tability of the gas layer in the subsequent extrusion. And, during low-speed extrusion, the flow inertia of the polymer melt is used to extend the flow channel of the gas-free–assisted section into the gas-assisted section to overcome the gravity of the polymer melt and smoothly extrude it in the parallel gas-assisted die. The parallel die can be considered for the production of GAE of daily profiles and can be used to improve quality.