Rapid Determination of Parabens in Water Samples by Ultra-high Performance Liquid Chromatography Coupled to Time of Flight Mass Spectrometry

Contaminants of emerging concern: Occurrence, analytical techniques, and removal with electrochemical advanced oxidation processes with special emphasis in Latin America

The occurrence of contaminants of emerging concern (CECs) in environmental systems is gradually more studied worldwide. However, in Latin America, the presence of contaminants of emerging concern, together with their environmental and toxicological impacts, has recently been gaining wide interest in the scientific community. This paper presents a critical review about the source, fate, and occurrence of distinct emerging contaminants reported during the last two decades in various countries of Latin America. In recent years, Brazil, Chile, and Colombia are the main countries that have conducted research on the presence of these pollutants in biological and aquatic compartments. Data gathered indicated that pharmaceuticals, pesticides, and personal care products are the most assessed CECs in Latin America, being the most common compounds the followings: atrazine, acenaphthene, caffeine, carbamazepine, ciprofloxacin, diclofenac, diuron, estrone, losartan, sulfamethoxazole, and trimethoprim. Most common analytical methodologies for identifying these compounds were HPLC and GC coupled with mass spectrometry with the potential to characterize and quantify complex substances in the environment at low concentrations. Most CECs' monitoring and detection were observed near to urban areas which confirm the out-of-date wastewater treatment plants and sanitization infrastructures limiting the removal of these pollutants. Therefore, the implementation of tertiary treatment should be required. In this tenor, this review also summarizes some studies of CECs removal using electrochemical advanced oxidation processes that showed satisfactory performance. Finally, challenges, recommendations, and future perspectives are discussed.

Hybrid porous material supported in a cellulose acetate polymeric membrane for the direct immersion thin-film microextraction of parabens in water

A simple and sensitive direct immersion thin-film microextraction (DI-TFME) method based on MIL-101(Cr) modified with carbon nanofibers supported in cellulose acetate (CA-MIL-101(Cr)@CNFs) polymeric membrane was developed for the extraction and preconcentration of parabens in environmental water samples. A high-performance liquid chromatography-diode array detector (HPLC-DAD) was used for the determination and quantification of methylparaben (MP) and propylparaben (PP). The factors affecting the DI-TFME performance were investigated using central composite design (CCD). The linearity of the DI-TFME/HPLC-DAD method obtained under optimal conditions was 0.04-0.04-500 µg/L with a correlation coefficient (R2) greater than 0.99, respectively. The limits of detection (LOD) and quantification (LOQ) for methylparaben were 11 ng/L and 37 ng/L; for propylparaben, they were 13 ng/L and 43 ng/L, respectively. The enrichment factors were 93.7 and 123 for methylparaben and propylparaben. The intraday (repeatability) and interday (reproducibility) precisions expressed as relative standard deviations (%RSD) were less than 5%. Furthermore, the DI-TFME/HPLC-DAD method was validated using real water samples spiked with known concentrations of the analytes. The recoveries ranged from 91.5 to 99.8%, and intraday and interday trueness values were less than ±15%. The DI-TFME/HPLC-DAD approach was effectively used for the preconcentration and quantification of parabens in river water and wastewater samples.

Pesticides and Parabens Contaminating Aquatic Environment: Acute and Sub-Chronic Toxicity towards Early-Life Stages of Freshwater Fish and Amphibians

Pesticides and personal care products are two very important groups of contaminants posing a threat to the aquatic environment and the organisms living in it.. Therefore, this study aimed to describe the effects of widely used pesticides and parabens on aquatic non-target biota such as fish (using model organisms Danio rerio and Cyprinus carpio) and amphibians (using model organism Xenopus laevis) using a wide range of endpoints. The first part of the experiment was focused on the embryonal toxicity of three widely used pesticides (metazachlor, prochloraz, and 4-chloro-2-methyl phenoxy acetic acid) and three parabens (methylparaben, propylparaben, and butylparaben) with D. rerio, C. carpio, and X. laevis embryos. An emphasis was placed on using mostly sub-lethal concentrations that are partially relevant to the environmental concentrations of the substances studied. In the second part of the study, an embryo-larval toxicity test with C. carpio was carried out with prochloraz using concentrations 0.1, 1, 10, 100, and 1000 µg/L. The results of both parts of the study show that even the low, environmentally relevant concentrations of the chemicals tested are often able to affect the expression of genes that play either a prominent role in detoxification and sex hormone production or indicate cell stress or, in case of prochloraz, to induce genotoxicity.

Mass trends of parabens, triclocarban and triclosan in Arizona wastewater collected after the 2017 FDA ban on antimicrobials and during the COVID-19 pandemic

Antimicrobials like parabens, triclosan (TCS), and triclocarban (TCC) are of public health concern worldwide due to their endocrine-disrupting properties and ability to promote antimicrobial drug resistance in human pathogens. The overall use of antimicrobials presumably has increased during the COVID-19 pandemic, whereas TCS and TCC may have experienced reductions in use due to their recent ban from thousands of over-the-counter (OTC) personal care products by the U.S. Food and Drug Administration (FDA). No quantitative data are available on the use of parabens or the impact the FDA ban had on TCC and TCS. Here, we use wastewater samples (n = 1514) from 10 different communities in Arizona to measure the presence of the six different antimicrobial products (TCS, TCC, and four alkylated parabens [methylparaben (MePb), ethylparaben (EtPb), propylparaben (PrPb), butylparaben (BuPb)]) collected before and during the COVID-19 pandemic using a combination of solid-phase extraction, liquid chromatography/tandem mass spectrometry (LC-MS/MS), and isotope dilution for absolute quantitation. The average mass loadings of all antimicrobials combined (1,431 ± 22 mg/day per 1,000 people) after the onset of the local epidemic (March 2020 - October 2020) were significantly higher (945 ± 62 mg/day per 1,000 people; p < 0.05) than before the pandemic (January 2019 - February 2020). Overall, parabens (∑Pbs = 999 ± 16 mg/day per 1,000 people) were the most used antimicrobials, followed by TCS (117 ± 14 mg/day per 1,000 people) and TCC (117 ± 14 mg/day per 1,000 people). After the 2017 U.S. FDA ban, we found a statistically significant (p < 0.05) reduction in the mass loadings of TCS (-89%) and TCC (-80%) but a rise in paraben use (+72%). Mass flows of 3 of a total of 4 parabens (MePb, EtPb, and PrPb) in wastewater were significantly higher upon the onset of the epidemic locally (p < 0.05). This is the first longitudinal study investigating the use of antimicrobials during the COVID-19 pandemic by employing wastewater-based epidemiology. Whereas an overall increase in the use of antimicrobials was evident from analyzing Arizona wastewater, a notable reduction in the use of TCS and TCC was evident during the pandemic, triggered by the U.S. FDA ban.

An overview of the literature on emerging pollutants: Chlorinated derivatives of Bisphenol A (ClxBPA)

CONTEXT

Bisphenol A (BPA) is a ubiquitous contaminant with endocrine-disrupting effects in mammals. During chlorination treatment of drinking water, aqueous BPA can react with chlorine to form chlorinated derivatives of BPA (mono, di, tri and tetra-chlorinated derivatives) or Cl_xBPA.

OBJECTIVE

The aim of this study is to summarize and present the state of knowledge on human toxicological risk assessment of Cl_xBPA.

MATERIALS AND METHODS

A search on Cl_xBPA in the PubMed database was performed based on studies published between 2002 and 2021. Forty-nine studies on chlorinated derivatives of BPA were found. Available information on their sources and levels of exposure, their effects, their possible mechanisms of action and their toxicokinetics data was extracted and presented.

RESULTS

Cl_xBPA have been essentially detected in environmental aqueous media. There is evidence in toxicological and epidemiological studies that Cl_xBPA also have endocrine-disrupting capabilities. These emerging pollutants have been found in human urine, serum, breast milk, adipose and placental tissue and can constitute a risk to human health. However, in vitro and in vivo toxicokinetic data on Cl_xBPA are scarce and do not allow characterization of the disposition kinetics of these compounds.

CONCLUSION

More research to assess their health risks, specifically in vulnerable populations, is needed. Some water chlorination processes are particularly hazardous, and it is important to evaluate their chlorination by-products from a public health perspective.

Experimental design approaches to optimize ultrasound-assisted simultaneous-silylation dispersive liquid-liquid microextraction for the rapid determination of parabens in water samples

This work describes a rapid solvent-minimized process to effectively determine four common paraben preservatives (methyl-, ethyl-, propyl- and butyl-paraben) in surface water samples. The method involved the use of a combination of a novel ultrasound-assisted simultaneous-silylation within dispersive liquid–liquid microextraction (UASS-DLLME) with detection by gas chromatography-tandem mass spectrometry (GC-MS/MS). To overcome the challenges related to the different experimental conditions, multivariate experimental design approaches conducted by means of a multilevel categorical design and a Box–Behnken design were utilized to screen and optimize parameters that have significant influences on the efficiency of silylation and extraction. The method was then validated and shown to provide low limits of quantitation (LOQs; 1–5 ng L⁻¹), high precision (3–11%), and satisfactory mean spiked recoveries (accuracy; 79–101%). Upon analyzing samples of surface water obtained from the field, we found that, in total, there was a relatively high concentration of the target parabens ranging from 200 to 1389 ng L⁻¹. The sources of the elevated levels of these parabens may be from the release of untreated municipal wastewater in this region, and also due to the widespread application of parabens in personal care and food products.

This work describes a rapid solvent-minimized process to effectively determine four common paraben preservatives (methyl-, ethyl-, propyl- and butyl-paraben) in surface water samples.