Physical properties and chemical content of canine femoral cortical bone in nutritional osteopenia: its reversibility and the effect of fluoride

Mapping cortical bone stiffness and mineralization from endosteal to periosteal surfaces of bovine mid-diaphyseal femur

INTRODUCTION

While bone literature abounds with correlations of mechanical stiffness to mineralization, such correlations are reported without relating the findings to specific intracortical locations. This study reports on mapping of stiffness and mineralization distributions in ring-shaped cortical bone samples sliced from mid-diaphyseal bovine femur. Stiffness and mineralization measurements were conducted at points across the intracortical thickness along radial lines emanating from the inner (endosteal) surface to the outer (periosteal) surface. Measurements were taken along approximately 4 mm distance of cortical bone thickness.

MATERIALS AND METHODS

Three experimental techniques were employed: Vickers microhardness (HV), energy-dispersive X-ray (EDX) spectroscopy, and computed tomography (CT). Stiffness values were extracted from the Vickers microhardness tests. Elemental mineralization values (calcium %wt. and phosphorus %wt.) were determined from EDX data. All measurements were repeated on three different femur bones taken from different bovines (collected fresh from butcher).

RESULTS

The study plots stiffness values and elemental mineralization (calcium %wt. and phosphorus %wt.) versus cortical thickness. Both stiffness and Ca %wt. and P %wt. are found to track and to linearly increase when plotted along the radial distance. The stiffness and mineralization trends collected from Vickers and EDX measurements were verified by employing the CT number (Hounsfield units, HU) via CT scans of the same bone samples. Data fitting via statistical methods revealed that all correlations were statistically significant.

CONCLUSION

Starting from endosteal to periosteal surfaces of mid-diaphyseal bovine femur, it was found that stiffness, mineralization, and HU values all exhibit increasing and correlating trends.

Effects of intermittent administration of pamidronate on the mechanical properties of canine cortical and trabecular bone

The mechanical properties of cortical and trabecular bones from beagles treated with the bisphosphonate pamidronate (administered intermittently 1 week every month for 3 months, at a dosage of 0.45 mumol/kg/day) were assessed. The mechanical properties of cortical bone were measured by four-point bending tests on femoral quadrants, in order to measure their elastic modulus and ultimate stress. The structural properties of whole tibias were measured in torsion to determine the torsional stiffness and failure torque. The elastic modulus and maximum compressive stress of the trabecular bone samples were measured by compression tests of trabecular cores. Intermittent treatment with pamidronate did not change the pattern of mechanical properties that occurs naturally around the femur or the torsional stiffness and failure torque of the tibias. By contrast, pamidronate did significantly increase the modulus of elasticity (by 19%) and maximum compressive stress (by 33%) of vertically aligned cylindrical trabecular specimens taken from the vertebrae of the beagles.