Corn Silage Management: Effects of Hybrid, Maturity, Chop Length, and Mechanical Processing on Rate and Extent of Digestion

Feeding whole-plant ensiled corn stover affects growth performance, blood parameters, and Cecal microbiota of Holdobagy goose

Introduction

The aim of this study was to investigate the effects of adding whole-plant ensiled corn stalks (WECS) to the diet of Holdorbagy geese on their growth performance, serum parameters, and cecal microbiota. Geese farming is an important agricultural practice, and optimizing their diet can contribute to better growth and health outcomes. However, there is limited research on the utilization of WECS as a feed source for geese. Understanding the potential effects of WECS on growth, blood parameters, and cecal microbiota can provide valuable insights into its feasibility and impact on geese farming practices.

Methods

A total of 144 six-week-old Holdorbagy geese were randomly assigned to one of three groups: a control group (0% WECS), a group fed 15% WECS and 85% concentrated feed (15% WECS), and a group fed 30% WECS and 70% concentrated feed (30% WECS). The trial period lasted for three weeks, during which the growth performance, serum parameters, and cecal microbiota were assessed.

Results

The results revealed significant findings in different aspects. Firstly, the feed-to-gain ratio (F/G ratio) of the 15% WECS group was significantly higher than that of the control group (p<0.05), indicating potential challenges in feed efficiency. Additionally, the average daily feed intake (ADFI) of both the 15% and 30% WECS groups was significantly higher than that of the control group (p<0.05), suggesting increased appetite or palatability of the diet containing WECS. In terms of serum parameters, the level of lactate dehydrogenase (LDH) in the 30% WECS group was significantly lower than that in the control group (p<0.05). Moreover, there was a tendency for increasing Fe levels and decreasing Zn levels with higher levels of WECS supplementation, although the differences were not statistically significant (p<0.05). Furthermore, the principal coordinate analysis showed significant differences in the composition of cecal microbiota among the three groups (p < 0.01). The observed_species, Shannon, and Pielou_e indices of the 30% WECS group were significantly higher than those of the 0% and 15% WECS groups (p<0.05), while the Simpson index of the 15% WECS group was significantly lower than that of the control group (p<0.05).

Discussion

The results indicate that the addition of WECS to the geese diet has both positive and negative effects. The study suggests that WECS can be a long-term stable feed source for geese, which can contribute to reducing feeding costs. However, it is important to monitor the amount of WECS added as it can affect the absorption of Zn by geese. Supplementation of Zn in the diet might be necessary to meet the needs of geese. Notably, adding 30% WECS to the diet can increase the richness, evenness, and diversity of the cecal microbiota, indicating potential benefits to gut health. In conclusion, this study highlights the potential of WECS as a feed source for geese. It provides valuable insights into the effects of WECS on growth performance, serum parameters, and cecal microbiota. These findings contribute to optimizing geese farming practices, improving feed utilization, and enhancing overall productivity and well-being of geese. Further research is needed to determine the optimal inclusion level of WECS and to explore strategies for mitigating any negative effects.

Response of common silage corn hybrids to inoculant application: fermentation profile, carbohydrate fractions, and digestibility during ensiling

Corn silage digestibility studies have focussed on genetically distant corn types. Conversely, silage additive studies monitored fermentation differences without discussing the subject of hybrid digestibility. How ensiling phases and additives affect silage quality in commercial corn hybrids has not been properly examined yet. As corn silage quality is a result of combined silage fermentation and digestibility characteristics, the aim of the study was to examine fermentation and digestibility responses to inoculant application in whole-plant corn silage of commercial hybrids intended for silage production in several time points during ensiling. Three corn hybrids grown under identical conditions in a split-plot field test were ensiled without inoculant application and with inoculant containing lactic acid bacteria and carbohydrate-degrading enzymes. Silages were sampled before ensiling, at the peak of the fermentation phase and during the stable phase. The fermentation profile, carbohydrate fraction, ruminal in vitro true dry matter digestibility, ruminal in vitro starch digestibility, and ruminal in vitro neutral detergent fibre digestibility were monitored. Although adding inoculant to silage improved its lactic acid production and decrease in pH, it did not affect its starch and fibre contents or their digestibility. Digestibility improved as ensiling continued, with the highest in vitro neutral detergent fibre digestibility and in vitro true dry matter digestibility values observed in the stable phase. Corn hybrids in this study differed in main fermentation characteristics, carbohydrate contents, and digestibility. These results suggest that even for commercial corn hybrids, the hybrid type is more important than inoculant for optimising silage characteristics and digestibility.

Effects of an exogenous protease on the fermentation and nutritive value of corn silage harvested at different dry matter contents and ensiled for various lengths of time

The objective of this experiment was to evaluate the effects of adding an experimental protease to corn plants harvested at different maturities on silage fermentation and in vitro ruminal starch digestibility (IVSD). Corn plants were harvested at maturities resulting in plants with 31 or 40% dry matter (DM). Plants were chopped, kernel processed, and treated with (1) only a 0.1 M phosphate buffer (pH 5.5, 5% vol/wt of fresh forage), (2) buffer with protease to obtain a final concentration of 20mg of protease/kg of wet forage, and (3) buffer with protease to obtain a final concentration of 2,000 mg of protease/kg of wet forage. Treated forages (about 500 g) were ensiled in nylon-polyethylene pouches and stored between 21 and 23°C for 0, 45, 90, and 150 d. Data were analyzed as a 2 × 3 × 4 factorial arrangement of treatments, with the main effects of harvest DM, dose of protease, days of ensiling, and their interactions. The treatment with the highest dose of protease resulted in more robust fermentations across harvest DM with higher concentrations of lactic and acetic acids compared with untreated silage. Concentrations of soluble protein (% of crude protein) increased with time of ensiling, regardless of DM content at harvest. However, averaged over both harvest DM contents, it increased by 37% for silages treated with the high dose of protease compared with an average 11% increase for untreated silages and silage treated with the low dose of protease, between d 0 and 45. Averaged over both harvest DM contents, the concentration of soluble protein peaked in silages treated with the high dose of protease after 45 d of ensiling, whereas it peaked at d 90 in untreated silages and silage treated with the low dose of protease. Similar changes occurred in the concentration of NH3-N due to length of ensiling and treatment with protease. In fresh forages, the concentration of starch for early- and late-harvested forages was similar, but IVSD was lower in the latter. After 45 d of ensiling, IVSD was highest in both early- and late-harvested silages that were treated with the high level of protease. After 150 d of ensiling, IVSD was similar among silages treated with protease, regardless of DM at harvest. Treating corn plants with a high dose of an experimental protease at harvest accelerated proteolysis during ensiling, resulting in corn silages with levels of IVSD after 45 d of ensiling that were only obtained in untreated corn silages after 150 d of ensiling.

Effects of mechanical processing on the nutritive value of barley silage for lactating dairy cows

Mechanical processing of whole crop barley before ensiling may be useful for improving nutrient use by dairy cattle. The objective of this study was to assess the effects of feeding mechanically processed barley silage as the main forage source on lactational performance. Twenty-four Holstein cows, 16 primiparous (187 +/- 52 days in milk) and 8 multiparous (87 +/- 69 days in milk) cows, were used in a completely randomized design with a 2-wk covariate period and a 6-wk treatment period. The 2 treatments were: 1) total mixed ration (TMR) containing regular barley silage (RBS-TMR), and 2) TMR containing mechanically processed barley silage (MPBS-TMR). Barley silage and alfalfa hay supplied 41 and 5% of the dietary dry matter (DM), respectively. Intake, body weight, and milk production were measured during the covariate and treatment periods. In addition, 2 multiparous cows were used for in situ measurements of the ruminal DM and fiber degradation kinetics of the barley silages and TMR. Data were analyzed with repeated measurements using a mixed model that included the covariate adjustment. Feeding MPBS-TMR had no significant effects on DM intake (DMI; 21.7 kg/d), milk yield (33.9 kg/d), or milk composition, with only 4% FCM (fat-corrected milk) yield (29.7 vs. 31.7 kg/d) and milk fat concentration (3.30 vs. 3.57%) showing a numerical improvement. Apparent digestibilities of DM and nutrients were not affected by feeding MPBS-TMR, with the exception of starch digestibility, which tended to increase. Dairy efficiencies calculated as milk yield/DMI or FCM/DMI were not different between treatments. Body weight and body condition score were not affected by treatments. Effective ruminal degradability of DM was similar for both barley silages, indicating that when the silages were ground to remove the effects of mechanical processing, the potential digestion was similar. Mechanical processing of barley silage harvested at a mid-dough stage of maturity resulted in small improvements in its nutritive value for lactating dairy cows and had minor impact on digestibility and milk production.

Effect of Length of Cut and Kernel Processing on Use of Corn Silage by Lactating Dairy Cows

Forty Holstein cows were used in an 8-wk randomized block design trial to determine the effects of theoretical length of cut (TLC) and kernel processing (KP) of whole plant corn silage on nutrient intake and digestibility, milk yield, and milk composition. Corn was harvested at three-quarters milk line stage of maturity at TLC of 1.90 or 2.54 cm. At each TLC, corn was KP at either 2 or 8 mm roll clearance. The control was harvested at 1.90 cm without KP. Corn silage provided 38% of the dietary dry matter (DM) in the experimental diets. Intake of DM and nutrients was similar among treatments. Apparent digestibility of DM and acid detergent fiber (ADF) increased with increasing TLC. Fiber digestibility was improved by KP compared with unprocessed corn silage. Starch digestibility was greater for corn silage KP at 2 vs. 8 mm. Apparent digestibility of DM, crude protein, and ADF was lowest for the diet containing silage harvested at 2.54 cm TLC and KP at 8 mm, resulting in an interaction of TLC and KP. No differences were observed in DM intake (DMI) among treatments. An interaction of TLC and KP was observed, however, for yield of milk protein and energy-corrected milk (ECM) and efficiency of converting DMI to ECM because of lower yield for diets containing silage harvested at 2.54 cm TLC and KP at 8 mm. Results of this trial indicate that as TLC increases, aggressive KP is necessary to maintain nutrient digestibility and performance of lactating dairy cows.

A Comparison of Processed Conventional Corn Silage to Unprocessed and Processed Brown Midrib Corn Silage on Intake, Digestion, and Milk Production by Dairy Cows

We studied the effects of mechanical processing and type of hybrid on the nutritive value of corn silage for lactating cows. Treatments were brown midrib (BMR) corn silage that was unprocessed (U-BMR), BMR corn silage that was processed (P-BMR), and a conventional corn silage that was processed (P-7511). All silages were harvested at a theoretical chop length of 19 mm. The chemical compositions of the silages were similar among treatments except that BMR silages were lower in lignin and higher in protein than P-7511. Brown midrib silages had greater 30-h in situ and in vitro NDF digestion than did P-7511, and processing had no effect on 30-h in situ and in vitro fiber digestion, but it increased in situ starch digestion after 3 and 12 h of incubation. Both processed silages had a smaller proportion of particles >1.91 cm and fewer whole corn kernels compared with unprocessed silage. Lactating cows were fed a total mixed ration (TMR) consisting of 42% of each silage type, 40% concentrate, 10% alfalfa silage, and 8% alfalfa hay (DM basis). Cows fed TMR containing P-BMR ate more DM and produced more milk than cows fed P-7511. At feeding, the TMR containing U-BMR had a larger proportion of particles >1.91 cm when compared with the TMR of cows fed processed silages, and after 24 h the difference was even greater, indicating that cows fed unprocessed corn silage sorted more. Cows fed TMR with P-7511 and P-BMR had greater total tract digestibility of organic matter, crude protein, and starch compared with cows fed U-BMR. In vivo digestibility of neutral detergent fiber was greatest for cows fed P-BMR when compared with the other treatments.