Use of dishwashers fails to inactivate foodborne pathogens in home-canned model foods

Risky home canning techniques are still performed for food preservation due to limited science-based recommendations. This study aimed to evaluate the inactivation of Shiga toxin-producing Escherichia coli O157:H7, Salmonella enterica (ser. Typhimurium, Enteritidis, and Infantis) and Listeria monocytogenes during home canning with a household dishwasher. The 450 mL of blended tomato (acidic liquid food) and potato puree (non-acidic solid food) were prepared with 1.5 % salt and 25 mL vinegar as model foods in glass jars (660 mL). The two model foods were sterilized, then inoculated with separate cocktails of each pathogen at 106-107 CFU/g. The prepared jars were placed in the bottom rack of a dishwasher and subjected to the following cycles: economic (50 °C, 122 min), express (60 °C, 54 min), and intensive (70 °C, 96 min). Temperature changes in jars were monitored by using thermocouples during heat treatment. Within the center of the jars, temperatures were measured as 45 to 53 °C in blended tomato and 44 to 52 °C in potato puree during all tested dishwasher cycles, respectively. The economic cycle treatment reduced S. enterica, E. coli O157:H7, and L. monocytogenes populations by 3.1, 4.6, and 4.2 log CFU/g in blended tomato (P ≤ 0.05), where a <1.0 log reduction was observed in potato puree (P > 0.05). All pathogens showed similar heat resistance during the express cycle treatment with a log reduction ranging from 4.2 to 5.0 log CFU/g in blended tomato and 0.6 to 0.7 log CFU/g in potato puree. Reduction in L. monocytogenes population was limited (0.6 log CFU/g) compared to E. coli O157:H7 (2.0 log CFU/g) and S. enterica (2.7 log CFU/g) in blended tomato during the intensive cycle treatment (P ≤ 0.05). Dishwasher cycles at manufacturer defined settings failed to adequately inactivate foodborne pathogens in model foods. This study indicates that home-canned vegetables may cause foodborne illnesses when dishwashers in home kitchens are used for heat processing.

Assessing the Removal Efficiency of Murine Norovirus 1, Hepatitis A Virus, and Human Coronavirus 229E on Dish Surfaces Through General Wash Program of Household Dishwasher

The performance of dishwashers in removing live viruses is an important informative value in practical applications. Since foodborne viruses are present in contaminated food surfaces and water environments. Insufficient washing of dishes typically makes a carrier of foodborne viruses. Dishwashers have shown excellent performance in removing bacterial pathogens, but very limited reports related to eliminate foodborne viruses on contaminated dish surfaces. Here, murine norovirus 1 (MNV-1), hepatitis A virus (HAV), and human coronavirus 229E (HCoV-229E) were experimentally inoculated on the dish surfaces (plate, rice bowl, and soup bowl). Plaque assay, 50% tissue culture infectious dose (TCID₅₀), and real-time quantitative polymerase chain reaction (RT-qPCR) were conducted to determine their removal efficiency of them through the general wash program of household dishwashers. Using titration assay, MNV-1 and HAV were reduced by 7.44 and 6.57 log10 PFU/dish, and HCoV-229E was reduced by 6.43 log10 TCID₅₀/dish through the general wash program, achieving a ≥ 99.999% reduction, respectively. Additionally, RT-qPCR results revealed that viral RNA of MNV-1 and HCoV-229E reduced 5.02 and 4.54 log10 genome copies/dish; in contrast, HAV was not detected on any dish surfaces. This study confirmed the performance of household dishwashers in removing pathogenic live viruses through the general wash program. However, residual viral RNA was not sufficiently removed. Further studies are needed to determine whether the viral RNA can be sufficiently removed using combination programs in household dishwashers.

Performance of Manufacturer Cleaning Recommendations Applied to 3D Food Ink Capsules for the Control of a Human Norovirus Surrogate

With the widespread availability of 3D food printing systems for purchase, users can customize their food in new ways. Manufacturer recommendations for cleaning these machines remain untested with regard to the prevention of foodborne pathogen transmission. This study aimed to determine if manufacturer cleaning recommendations for food ink capsules utilized in 3D food printers are adequate to control human norovirus (HuNoV). A HuNoV surrogate, Tulane virus (TuV; ~ 6 log₁₀ PFU/mL), was inoculated onto the interior surface of stainless steel food ink capsules. Capsules were either unsoiled or soiled with one of the following: butter, protein powder solution, powdered sugar solution, or a mixture containing all three food components. The capsules were allowed to dry and then one of three hygienic protocols was applied: manual washing (MW), a dishwasher speed cycle (DSC), or a dishwasher heavy cycle (DHC). The interaction effect between DSC and pure butter was a significant predictor of log reduction (P = 0.0067), with the pure butter and DSC combination achieving an estimated mean log reduction of 4.83 (95% CI 4.13, 5.59). The DSC was the least effective method of cleaning when compared with MW and the DHC. The 3-way interaction effects between wash type, soil, and capsule position were a significant predictor of log reduction (P = 0.00341). Capsules with butter in the DSC achieved an estimated mean log reduction of 2.81 (95% CI 2.80, 2.83) for the front-most position versus 6.35 (95% CI 6.33, 6.37) for the back-most position. Soil matrix, cleaning protocol, and capsule position all significantly impact capsule cleanability and potential food safety risk. The DHC is recommended for all capsules, and the corners should be avoided when placing capsules into the dishwasher. The current study seeks to provide recommendations for users of additive manufacturing and 3D food printing including consumers, restaurants, industry, and regulatory industries.

Coronaviruses are stable on glass, but are eliminated by manual dishwashing procedures

Severe acute respiratory syndrome coronavirus type 2 (SARS-CoV-2) is primarily transmitted from human to human via droplets and aerosols. While transmission via contaminated surfaces is also considered possible, the overall risk of this transmission route is assumed to be low. Nevertheless, transmission through contaminated drinking glasses may pose an increased risk as the glass is in direct contact with the mouth and oral cavity. Using human coronavirus 229E (HCoV-229E) as surrogate for SARS-CoV-2, this study examined coronavirus stability on glass, inactivation by dishwashing detergents, and virus elimination by a manual glass scrubbing device. Infectious HCoV-229E was recovered from glass for 7 and 21 days of storage under daylight and dark conditions, respectively. Near complete inactivation of HCoV-229E (>4 log10 reduction) was observed after incubation with two common dishwashing detergents at room temperature for 15 s, whereas incubation at 43 °C for 60 s was necessary for a third detergent to achieve a similar titer reduction. The virus was efficiently removed from contaminated drinking glasses using a manual glass scrubbing device in accordance with German standard DIN 6653-3. The results confirm that coronaviruses are relatively stable on glass, but indicate that common manual dishwashing procedures can efficiently eliminate coronaviruses from drinking glasses.

Risks and new challenges in the food chain: Viral contamination and decontamination from a global perspective, guidelines, and cleaning

Even during the continuing world pandemic of severe acute respiratory syndrome coronavirus 2 (SARS CoV-2), consumers remain exposed to the risk of getting infected by existing, emerging, or re-emerging foodborne and waterborne viruses. SARS-CoV-2 is different in that it is transmitted directly via the airborne route (droplets and aerosols) or indirect contact (surfaces contaminated with SARS-CoV-2). International food and health organizations and national regulatory bodies have provided guidance to protect individuals active in food premises from potential occupational exposure to SARS-CoV-2, and have recommended chemicals effective in controlling the virus. Additionally, to exclude transmission of foodborne and waterborne viruses, hygiene practices to remove viral contaminants from surfaces are applied in different stages of the food chain (e.g., food plants, food distribution, storage, retail sector, etc.), while new and enhanced measures effective in the control of all types of viruses are under development. This comprehensive review aims to analyze and compare efficacies of existing cleaning practices currently used in the food industry to remove pathogenic viruses from air, nonfood, and food contact surfaces, as well as from food surfaces. In addition, the classification, modes of transmission, and survival of food and waterborne viruses, as well as SARS-CoV-2 will be presented. The international guidelines and national regulations are summarized in terms of virucidal chemical agents and their applications.

Porous surfaces: stability and recovery of coronaviruses

The role of indirect contact in the transmission of SARS-CoV-2 is not clear. SARS-CoV-2 persists on dry surfaces for hours to days; published studies have largely focused on hard surfaces with less research being conducted on different porous surfaces, such as textiles. Understanding the potential risks of indirect transmission of COVID-19 is useful for settings where there is close contact with textiles, including healthcare, manufacturing and retail environments. This article aims to review current research on porous surfaces in relation to their potential as fomites of coronaviruses compared to non-porous surfaces. Current methodologies for assessing the stability and recovery of coronaviruses from surfaces are also explored. Coronaviruses are often less stable on porous surfaces than non-porous surfaces, for example, SARS-CoV-2 persists for 0.5 h-5 days on paper and 3-21 days on plastic; however, stability is dependent on the type of surface. In particular, the surface properties of textiles differ widely depending on their construction, leading to variation in the stability of coronaviruses, with longer persistence on more hydrophobic materials such as polyester (1-3 days) compared to highly absorbent cotton (2 h-4 days). These findings should be considered where there is close contact with potentially contaminated textiles.

High Intensity Violet Light (405 nm) Inactivates Coronaviruses in Phosphate Buffered Saline (PBS) and on Surfaces

It has been proven that visible light with a wavelength of about 405 nm exhibits an antimicrobial effect on bacteria and fungi if the irradiation doses are high enough. Hence, the question arises as to whether this violet light would also be suitable to inactivate SARS-CoV-2 coronaviruses. Therefore, a high-intensity light source was developed and applied to irradiate bovine coronaviruses (BCoV), which are employed as SARS-CoV-2 surrogates for safety reasons. Irradiation is performed in virus solutions diluted with phosphate buffered saline and on steel surfaces. Significant virus reduction by several log levels was observed both in the liquid and on the surface within half an hour with average log reduction doses of 57.5 and 96 J/cm2, respectively. Therefore, it can be concluded that 405 nm irradiation has an antiviral effect on coronaviruses, but special attention should be paid to the presence of photosensitizers in the virus environment in future experiments. Technically, visible violet radiation is therefore suitable for coronavirus reduction, but the required radiation doses are difficult to achieve rapidly.