Electrocatalytic Behavior of an Amide Functionalized Mn(II) Coordination Polymer on ORR, OER and HER

Boosting Electrocatalytic Activity of Bimetallic CoNi-MOF for OER and HER Through a Synergistic Bimetallic Approach

Due to the decreasing availability, reduced stability, and high cost of noble metal-based catalysts, the search for stable, efficient, and inexpensive electrocatalysts is of significant importance. In this study, three new isostructural Co(II), Ni(II), and CoNi metal-organic frameworks (MOFs) based on bis-coordinating ligand 3-pyridyl acrylic acid are explored as efficient electrocatalysts. The structure of CoNi-MOF was further confirmed by various experimental techniques. The electrocatalytic activities toward the oxygen evolution reaction (OER) and hydrogen evolution reaction (HER) revealed that the bimetallic CoNi-MOF demonstrated significantly greater activity towards OER and HER compared to its monometallic counterparts, Co-MOF and Ni-MOF. CoNi-MOF requires 350 mV and 150 mV overpotential to achieve a current density of 10 mA cm-2 for OER and HER, respectively. Moreover, they exhibited excellent stability for 6 hours and 1000 OER cycles, demonstrating its superiority in these reactions. The significant enhancement in the performance of CoNi-MOF is attributed to the bimetallic synergistic effects between the redox-active metal centers Co2+ and Ni2+, which increase the activity of the catalyst's surface, resulting in enhanced current density and reduced overpotential. The hydrogen bond between coordinated water molecules and un-coordinated carboxylate is essential for the electrochemical stability of the materials.

Tin(IV)Porphyrin-Based Porous Coordination Polymers as Efficient Visible Light Photocatalyst for Wastewater Remediation

Two porphyrin-based polymeric frameworks, SnP-BTC and SnP-BTB, as visible light photocatalysts for wastewater remediation were prepared by the solvothermal reaction of trans-dihydroxo-[5,15,10,20-tetrakis(phenyl)porphyrinato]tin(IV) (SnP) with 1,3,5-benzenetricarboxylic acid (H3BTC) and 1,3,5-tris(4-carboxyphenyl)benzene (H3BTB), respectively. The strong bond between the carboxylic acid group of H3BTC and H3BTB with the axial hydroxyl moiety of SnP leads to the formation of highly stable polymeric architectures. Incorporating the carboxylic acid group onto the surface of SnP changes the conformational frameworks as well as produces rigid structural transformation that includes permanent porosity, good thermodynamic stability, interesting morphology, and excellent photocatalytic degradation activity against AM dye and TC antibiotic under visible light irradiation. The photocatalytic degradation activities of AM dye were found to be 95% by SnP-BTB and 87% by SnP-BTC within 80 min. Within 60 min of visible light exposure, the photocatalytic degradation activities of TC antibiotic were found to be 70% by SnP-BTB and 60% by SnP-BTC. The enhanced catalytic photodegradation performances of SnP-BTB and SnP-BTC were attributed to the synergistic effect between SnP and carboxylic acid groups. The carboxylic acid connectors strongly resist the separation of SnP from the surface of SnP-BTB and SnP-BTC during the photodegradation experiments. Therefore, the high degradation rate and low catalyst loading make SnP-BTB or SnP-BTC more efficient than other reported catalysts. Thus, the present investigations on the porphyrin-based photocatalysts hold great promise in tackling the treatment of dyeing wastewater.

Nickel(II) complexes with 14-membered bis-thiosemicarbazide and bis-isothiosemicarbazide ligands: synthesis, characterization and catalysis of oxygen evolution reaction

Design and development of novel, low-cost and efficient electrocatalysts for oxygen evolution reaction (OER) in alkaline media is crucial for lowering the reaction overpotential and thus decreasing the energy input during the water electrolysis process. Herein, we present the synthesis of new 14-membered bis-thiosemicarbazide and bis-isothiosemicarbazide macrocycles and their nickel(II) complexes characterized by spectroscopic techniques (1H and 13C NMR, IR, UV-vis), electrospray ionization mass spectrometry, single crystal X-ray diffraction, scanning electron microscopy-energy dispersive X-ray spectroscopy (SEM-EDX) and cyclic voltammetry. Finally, the activity of nickel(II) complexes towards OER is reported. NiIILSEt delivered a current density of 10 mA cm-2 at the lowest overpotential of 350 mV with the lowest Tafel slope of 93 mV dec-1. The high performance of NiIILSEt might be attributed to its high surface area and thus abundant active sites with the observed low charge-transfer resistance enabling the effective current flow through the electrocatalyst. Square-planar coordination geometry and increment in Ni oxidation state are believed to favor its OER performance. Beside high activity towards OER, NiIILSEt demonstrated excellent long-term stability with continuous operation, advocating its possible application in commercial systems.

Highly efficient Cu(II) coordination polymer catalyst for the conversion of hazardous volatile organic compounds

Three novel coordination polymers (CPs), namely [Cu(μ-1κO,2κN-L)2]n (1), [Zn (μ-1κO,2κN-L)2(H2O)2]n (2) and [Cd (μ-1κOO',2κN-L)2]n (3) [where HL = 4-(pyrimidin-5-ylcarbamoyl)benzoic acid], were synthesized and characterized by elemental analysis, ATR-IR, TGA, XPS and single-crystal X-ray diffraction. Despite having the same organic ligand, the various metal cations had an impact in the subsequent frameworks. Hirshfeld surface analysis was performed to investigate the intermolecular interactions and to examine the stability of the crystal structures of the three polymers. Their catalytic performances were screened for the peroxidative oxidation of Volatile Organic Compounds (VOCs), with toluene and p-xylene selected as model substrates. Tert-butyl hydroperoxide (t-BuOOH or TBHP) (aq. 70 %) was employed as the oxidant. The catalytic oxidation of toluene yielded benzyl alcohol, benzaldehyde and benzoic acid. The copper CP 1 exhibited the highest total yield for toluene oxidation, reaching approximately 36% in an aqueous medium. For p-xylene oxidation, tolualdehyde, methylbenzyl alcohol, and toluic acid were produced as the primary products, accompanied by minor ones. The experiments were conducted under diverse conditions, manipulating key parameters such as the choice of solvent (water or acetonitrile), type of oxidant (t-BuOOH or H2O2), the concentration of the oxidant and reaction temperature. In the presence of catalyst 1, a maximum total yield of ca. 80% was achieved for p-xylene oxidation.

WCx-Supported RuNi Single Atoms for Electrocatalytic Oxygen Evolution

Single-atom catalysts anchored to oxide or carbonaceous substances are typically tightly coordinated by oxygen or heteroatoms, which certainly impact their electronic structure and coordination environment, thereby affecting their catalytic activity. In this study, we prepared a stable oxygen evolution reaction (OER) catalyst on tungsten carbide using a simple pyrolysis method. The unique structure of tungsten carbide allows the atomic RuNi catalytic site to weakly bond to the surface W and C atoms. XRD patterns and HRTEM images of the WCx-RuNi showed the characteristics of phase-pure WC and W2C, and the absence of nanoparticles. Combined with XPS, the atomic dispersion of Ru/Ni in the catalyst was confirmed. The catalyst exhibits excellent catalytic ability, with a low overpotential of 330 mV at 50 mA/cm2 in 1 m KOH solutions, and demonstrates high long-term stability. This high OER activity is ascribed to the synergistic action of metal Ru/Ni atoms with double monomers. The addition of Ni increases the state density of WCx-RuNi near the Fermi level, promoting the adsorption of oxygen-containing intermediates and enhancing electron exchange. The larger proximity of the d band center to the Fermi level suggests a strong interaction between the d electrons and the valence or conduction band, facilitating charge transfer. Our research offers a promising avenue for reasonable utilization of inexpensive and durable WCx carrier-supported metal single-atom catalysts for electrochemical catalysis.