Tensile Strength and Moisture Absorption of Sugar Palm-Polyvinyl Butyral Laminated Composites

Recent Developments in Eco-Friendly Wood-Based Composites II

Traditional wood-based composites are bonded with synthetic formaldehyde-based adhesives [...].

Effect on Compression Molding Parameters in Mechanical Properties of MWCNT/Glass Fiber/Epoxy Composites

Reinforcing fibers, nanofillers, matrix materials, and manufacturing techniques all have a role in the mechanical characteristics of hybrid composites. MWCNTs-reinforced E-glass/Kevlar/epoxy composites are appropriate fillers for structural applications. The impact of different concentrations of MWCNT fillers (0.4%, 0.8%, and 1.2% wt) on the mechanical characteristics of hybrid composites has been studied. Tensile and bending strength, as well as hardness, were measured in compression-molded composites. The effects of compression pressure, mold temperature, and applied pressure on hybrid (0.8% MWCNT) were investigated. When it came to composite tensile and bending strength, compression pressure was the most important factor, closely succeeded by mold temperature and pressure period. Compression molding were optimized, resulting in a tensile strength of 183 MPa, a bending strength of 158.3 MPa, and a hardness value of 23.8 HV.

Experimental Analysis of Kerf Taper Angle in Cutting Process of Sugar Palm Fiber Reinforced Unsaturated Polyester Composites with Laser Beam and Abrasive Water Jet Cutting Technologies

In this research, the effect of processing input parameters on the kerf taper angle response of three various material thicknesses of sugar palm fiber reinforced unsaturated polyester composite was investigated as an output parameter from abrasive waterjet and laser beam cutting techniques. The main purpose of the study is to obtain data that includes the optimum input parameters in cutting the composite utilizing these two unconventional techniques to avoid some defects that arise when using traditional cutting methods for cutting the composites, and then make a comparison to determine which is the most appropriate technique regarding the kerf taper angle response that is desired to be reduced. In the laser beam cutting process, traverse speed, laser power, and assist gas pressure were selected as the variable input parameters to optimize the kerf taper angle. While the water pressure, traverse speed, and stand-off-distance were the input variable parameters in the case of waterjet cutting process, with fixing of all the other input parameters in both cutting techniques. The levels of the input parameters that provide the optimal response of the kerf taper angle were determined using Taguchi's approach, and the significance of input parameters was determined by computing the max-min variance of the average of the signal to-noise ratio (S/N) for each parameter. The contribution of each input processing parameter to the effects on kerf taper angle was determined using analysis of variation (ANOVA). Compared with the results that were extrapolated in the previous studies, both processes achieved acceptable results in terms of the response of the kerf taper angle, noting that the average values produced from the laser cutting process are much lower than those resulting from the waterjet cutting process, which gives an advantage to the laser cutting technique.