Electron Transfer in DNA at Electrified Interfaces

An electrochemical determination strategy for miRNA based on bimetallic nanozyme and toehold-mediated DNA replacement procedure

An electrochemical strategy based on bimetallic nanozyme in collaboration with toehold-mediated DNA replacement effect is proposed for the sensitive determination of miRNA-21. The AuPt nanoparticles (AuPt NPs) are prepared as a catalytic beacon; it shows favorable peroxidase properties with a Michaelis contant (K_m) of 0.072 mM for H₂O₂, which is capable of catalyzing H₂O₂ to induce an intense redox reaction, and causing a measurable electrochemical signal. To further enhance the strength of the signal response, a novel toehold-mediated DNA replacement strategy is employed. DNA strands with specific sequences are modified on electrodes and AuPt NPs, respectively. In the presence of miRNA-21, a cyclic substitution effect is subsequently activated via a specific toehold sequence and leads to a large accumulation of AuPt NPs on the electrodes. Subsequently, a strong signal depending on the amount of miRNA-21 is obtained after adding a small amount of H₂O₂. The analytical range of this determination method is from 0.1 pM to 1.0 nM, and the LOD is 84.1 fM. The spike recoveries for serum samples are 95.0 to 102.4% and the RSD values are 3.7 to 5.8%. The results suggests a promising application of the established method in clinical testing and disease diagnosis.

Redox-Controlled Energy Transfer Quenching of Fluorophore-Labeled DNA SAMs Enables In Situ Study of These Complex Electrochemical Interfaces

Interfaces modified by a molecular monolayer can be challenging to study, particularly in situ, requiring novel approaches. Coupling electrochemical and optical approaches can be useful when signals are correlated. Here we detail a methodology that uses redox electrochemistry to control surface-based fluorescence intensity for detecting DNA hybridization and studying the uniformity of the surface response. A mixed composition single-strand DNA SAM was prepared using potential-assisted thiol exchange with two alkylthiol-modified ssDNAs that were either labeled with a fluorophore (AlexaFluor488) or a methylene blue (MB) redox tag. A significant change in fluorescence was observed when reducing MB to colorless leuco-MB. In situ fluorescence microscopy on a single-crystal gold bead electrode showed that fluorescence intensity depended on (1) the potential controlling the oxidation state of MB, (2) the surface density of DNA, (3) the MB:AlexFluor488 ratio in the DNA SAM, and (4) the local environment around the DNA SAM. MB efficiently quenched AlexaFluor488 fluorescence. Reduction of MB showed a significant increase in fluorescence resulting from a decrease in quenching or energy transfer efficiency. Hybridization of DNA SAMs with its unlabeled complement showed a large increase in fluorescence due to MB reduction for surfaces with sufficient DNA coverage. Comparing electrochemical-fluorescence measurements to electrochemical (SWV) measurements showed an improvement in detection of a small fraction of hybridized DNA SAM for surfaces with optimal DNA SAM composition and coverage. Additionally, this coupled electrochemical redox-fluorescence microscopy method can measure the spatial heterogeneity of electron-transfer kinetics and the influence of the local interfacial environment.