Mulberry-like porous-hollow AuPtAg nanorods for electrochemical immunosensing of biomarker myoglobin

Sandwich-type electrochemical aptasensor for sensitive detection of myoglobin based on Pt@CuCo-oxide nanoparticles as a signal marker

When an acute myocardial infarction (AMI) occurs, myoglobin (Mb) is the biomarker whose concentration firstly increases, and the high sensitive detection of Mb is critical for early diagnosis of AMI. Herein, a sandwich-type electrochemical aptasensor for the sensitive detection of Mb was constructed by using Pt@Cu1.33OCo0.83O as the signal marker. On one hand, nano-flower-like Cu1.33OCo0.83O was synthesized by hydrothermal method and Pt nanoparticles (Pt NPs) were loaded on its surface. Pt@Cu1.33OCo0.83O could immobilize aptamer 2 (Apt2) successfully by the Pt-S bond. And because of the synergistic effect between Pt and bimetallic oxide, Pt@Cu1.33OCo0.83O had an excellent catalytic effect on the signal source of hydrogen peroxide (H2O2) to amplify the current signal, which enhance the sensitivity of the aptasensor. On the other hand, the screen-printed gold electrode (SPGE) was used as the sensing base, which had good conductivity and ensured the immobilization of aptamer 1 (Apt1). The quantitative detection of Mb was achieved by specific recognition between Mb and Apt1, Apt2. As a result, the constructed electrochemical aptasensor had a good linear range (1-1500 ng/mL) with a low detection limit (LOD) of 0.128 ng/mL (S/N = 3), and a high sensitivity of 29.47 μA dec-1. The aptasensor also realized the detection of Mb in human serum samples with good accuracy, and the results were consistent with the hospital's biochemical indicators, which demonstrated the potential application of the prepared sensor in the clinical detection of Mb.

Effect of Aspect Ratio of a Gold-Nanorod-Modified Screen-Printed Carbon Electrode for Carbaryl Detection in Three Different Samples of Vegetables

In this study, three different sizes of gold nanorods (AuNRs) were synthesized using the seed-growth method by adding various volumes of AgNO3 as 400, 600, and 800 μL into the growth solution of gold nanoparticles. Three different sizes of AuNRs were then characterized using UV-vis spectroscopy, high-resolution transmission electron microscopy (HRTEM), selected area electron diffraction (SAED) patterns, and atomic force microscopy (AFM) to investigate the surface morphology, topography, and aspect ratios of each synthesized AuNR. The aspect ratios from the histogram of size distributions of three AuNRs as 2.21, 2.53, and 2.85 can be calculated corresponding to the addition of AgNO3 volumes of 400, 600, and 800 μL. Moreover, each AuNR in three different aspect ratios was drop-cast onto the surface of a commercial screen-printed carbon electrode (SPCE) to obtain three different SPCE-modified AuNRs (SPCE-A400, SPCE-A600, and SPCE-A800, respectively). All SPCE-modified AuNRs were then evaluated for their electrochemical behavior using cyclic voltammetry and electrochemical impedance spectroscopy (EIS) techniques and the highest electrochemical performance was shown as the order of magnitude of SPCE-A400 > SPCE-A600/SPCE-A800. The reason for the highest electrocatalytic activity of SPCE-A400 might be due to the smallest particle size and uniform distribution of AuNRs ∼ 2.2, which enhanced the charge transfer, thus providing the highest electroactive surface area (0.6685 cm2) compared to other electrodes. These results also confirm that the sensing mechanism for all SPCE-modified AuNRs is controlled by diffusion phenomena. In addition, the optimum pH was obtained as 4 for carbaryl detection for all SPCE-modified AuNRs with the highest current shown by SPCE-A400. Furthermore, SPCE-A400 has the highest fundamental parameters (surface coverage, catalytic rate constant, electron transfer rate constant, and adsorption capacity) for carbaryl detection, which were investigated using cyclic voltammetry and chronoamperometric techniques. The electroanalytical performances of all SPCE-modified AuNRs for carbaryl detection were also investigated with SPCE-A400 displaying the best performance among other electrodes in terms of its linearity (0.2-100 μM), limit of detection (LOD) ∼ 0.07 μM, and limit of quantification (LOQ) ∼ 0.2 μM. All SPCE-modified AuNRs were also subsequently evaluated for their stability, reproducibility, and selectivity in the presence of interfering species such as NaNO2, NH4NO3, Zn(CH3CO2)2, FeSO4, diazinon, and glucose and show reliable results as depicted from %RSD values less than 3%. At last, all SPCE-modified AuNRs have been employed for carbaryl detection using a standard addition technique in three different samples of vegetables (cabbage, cucumber, and Chinese cabbage) with its results (%recovery ≈ 100%) within the acceptable analytical range. In conclusion, this work demonstrates the great potential of a disposable device based on an AuNR-modified SPCE for rapid detection and high sensitivity in monitoring the concentration of carbaryl as a residual pesticide in vegetable samples.