Micellar Aggregation Behavior and Electrochemically Reversible Solubilization of a Redox-Active Nonionic Surfactant

Synthesis and Surface Properties of Photoresponsive Gemini Surfactants: Implication for Remediating PAHs-Contaminated Groundwater

The efficient utility of surfactants remains a daunting task for groundwater remediation. In this study, we have synthesized a conventional photoresponsive surfactant 4-[4-[(4-butylphenyl)azo]phenoxy]butyldimethylethylammonium bromide (AzoPB) and a gemini photoresponsive surfactant N¹,N²-bis[4-[4-[(4-butylphenyl)azo]phenoxy]butyl]-N¹,N²-tetramethylethane-1,2-diammonium bromide (AzoPBT) for solubilizing PAHs in groundwater. The two surfactants' photosensitivity, surface properties, and solubilization/release ability for phenanthrene (Phe) and acenaphthylene (Ace) were studied in detail. Under UV-light irradiation for 15-20 s, the two surfactants can be converted from trans to cis, while cis-to-trans isomerization can be achieved under visible-light irradiation for 1 min. Compared to AzoPB, AzoPBT exhibited strong surface properties such as lower critical micelle concentration (0.52 mM), surface tension (γ, 28.94 mN·m^-1), minimum area (A_min, 1.72 × 10^-8 nm²), and higher maximum adsorption (Γ_max, 96.55 mol·m^-2). The solubility of Phe and Ace in the AzoPBT aqueous solution (12.84 and 14.27 mg/L) was much higher than that in the AzoPB aqueous solution (7.51 and 8.77 mg/L) and gradually increased as the surfactant concentration increased in both aqueous solutions. Compared to AzoPB, gemini surfactant AzoPBT exhibited stronger solubilization ability. After four cycles of cis-trans isomerization conversion, AzoPBT could still reduce the hydrophobicity of Phe in natural groundwater, although the solubility of Phe decreased slightly. Additionally, the release capacity of AzoPBT was significantly higher than that of AzoPB during the cyclic solubilization-release process. The results indicated that gemini photoresponsive surfactants should be preferable to conventional photoresponsive surfactants for groundwater remediation due to their higher solubilization and release efficiency for Phe in the cyclic solubilization and release process, which can improve repair efficiency, minimize secondary pollution, and reduce remediation costs.

Electrochemically reversible foam enhanced flushing for PAHs-contaminated soil: Stability of surfactant foam, effects of soil factors, and surfactant reversible recovery

Although surfactant foams enhanced-remediation for PAHs-contaminated soil has been proved to be an effective method, lack of simple/economic surfactant recovery methods from the eluent solutions limit its further remediation application for organic contaminated soil. Here, we prepared a electrochemically reversible ferrocene surfactant FcCH₂N⁺(CH₃)C₁₂H₂₅ (Fc12), then investigated the foaming ability and foam stability of Fc12 under its reduced (active state) and oxidation (inactive state) states and explored the flushing efficiency of reduced Fc12 foam for PAHs-contaminated soil and the recovery efficiency of collected eluent solution. The results showed that the foaming ability and foam stability of reduced Fc12 are greatly higher than those of oxidized Fc12, which is indicative of a well reversibly switchable characteristic of Fc12. The contaminated soil flushing efficiencies of reduced Fc12 for phenanthrene and pyrene were 65.28% and 46.45%. The respective desorption efficiency of phenanthrene and pyrene from collected eluent solutions were calculated to be 74.94% and 72.75% by electrochemical oxidation control, which indicates that Fc12 can be well recovered by simple electrochemical control. This study provides a feasible method for the recovery of surfactants from surfactant-enhanced remediation processes by simply electrochemical control.

Effective and Reversible Switching of Emulsions by an Acid/Base-Mediated Redox Reaction

To develop a fast, effective, and reversible strategy for phase separation and re-emulsification of the surfactant-based emulsions, a strategy for using acid/base-mediated redox reactions was established to switch the emulsions formed from a redox-responsive anionic surfactant of potassium dodecyl seleninate (C₁₂SeO₂K). Upon acidification, C₁₂SeO₂K was reduced by KI to give didodecyl diselenide (C₁₂Se)₂, a state of almost no surface or interfacial activity; upon basification, (C₁₂Se)₂ was oxidized by I₂ to give C₁₂SeO₂K again. The fractional conversion of C₁₂SeO₂K in the reversible switching processes was close to 100%. Consequently, an unusually large change in interfacial tension (ΔIFT) as high as ∼27.1 mN m^-1 was obtained at a wider concentration range starting from the critical micelle concentration of C₁₂SeO₂K; the highest IFT at the oil-water interface was obtained after an almost complete switch-off, giving an oil-aqueous solution interface very similar to that without any emulsifiers, which leads to the effective and fast phase separation of the C₁₂SeO₂K-based switchable emulsions.