Piezoelectric tube as resonant transducer for gas-phase photoacoustics

Determination of Binary Gas Mixtures by Measuring the Resonance Frequency in a Piezoelectric Tube

The composition of gas mixtures may be determined via changes of the speed of sound. As this affects the resonance frequency of the gas inside a tube, indirect measurements through a frequency analysis are also possible. It is demonstrated that this may be carried out with unprecedented simplicity by the novel employment of a piezoelectric tube which serves at the same time as a resonance tube and as transducer into the electronic domain. Experiments were run using a simple diecast aluminum box as the measuring cell, inside which the piezoelectric tube made from lead zirconium titanate with 30-mm length and 5.35-mm inner diameter was suspended. A small loudspeaker placed into the cell served for excitation of the resonance. Peak frequencies between 3910 and 14,590 Hz (for pure CO₂ and He, respectively) were obtained. Two component mixtures of O₂/N₂, CO₂/N₂, and He/N₂ at various composition were tested. A linear frequency change from 4790 to 5100 Hz was observed when going from pure O₂ to pure N₂.

Experimental Research on Measuring the Concentration of CO2 in Gas-Liquid Solution Based on PZT Piezoelectric-Photoacoustic Spectroscopy

The feasibility of a scheme in which the concentration of CO2 in gas-liquid solution is directly measured based on PZT piezoelectric-photoacoustic spectroscopy was evaluated. The existing device used for the measurement of gas concentration in gas-liquid solution has several limitations, including prolonged duration, loss of gas, and high cost due to the degassing component. In this study, we developed a measuring device in order to solve the problems mentioned above. Using this device, how the intensity of the photoacoustic signal changes with the concentration of CO2 was demonstrated through experiment. The impact that variation of the laser modulation frequency has on the photoacoustic signal was also studied. Furthermore, the experimental data generated from measuring the concentration of CO2 in gas-liquid solution was verified for a wide range of concentrations. It was found that, not only can the error rate of the device be less than 7%, but the time of measurement can be within 60 s. To sum up, the scheme is highly feasible according to the experimental results, which makes measurement of the concentration of a gas in gas-liquid solution in the future more straightforward.