Impacts of dust events on chemical characterization and associated source contributions of atmospheric particulate matter in northern China

Atmospheric environment characteristic of severe dust storms and its impact on sulfate formation in downstream city

This study comprehensively investigated the impact of dust storms (DSs) on downstream cities, by selecting representative DS events. In this paper, we discussed the characteristics of meteorological conditions, air pollutants, PM2.5 components, and their influence on sulfate formation mechanisms. During DSs, strong winds, reaching speeds of up to 10 m/s, led to significant increases in PM10 and PM2.5, with maximum concentrations of 2684.5 and 429 μg/m3, respectively. Primary gaseous pollutants experienced substantial reductions, with decline rates of 48.1, 34.9, 36.8, and 9.0 % for SO2, NO2, NH3, and CO, respectively. Despite a notable increase in PM2.5 concentrations, only 7.6 % of the total mass of PM2.5 was attributed to ionic and carbonaceous components, a much lower value than observed before the DSs (77.3 %). Concentrations of Fe, Ti, and Mn exhibited increases by factors of 6.5-14.1, 10.4-17.0, and 1.6-4.7, respectively. In contrast to the significant decrease of >76.2 % in nitrogen oxidation ratio (NOR), sulfur oxidation ratio (SOR) remained at a relatively high level, displaying a strong positive correlation with high concentrations of Fe, Mn, and Ti. Quantitative analysis revealed an average increase of 0.187 and 0.045 μg/m3 in sulfate from natural sources and heterogeneous generation, respectively. The heterogeneous reaction on mineral dust was closely linked to atmospheric humidity, radiation intensity, the form of metal existence, and concentrations of it. High concentrations of titanium dioxide and iron‑manganese oxides in mineral dust promoted heterogeneous oxidation of SO2 through photocatalysis during the daytime and metal ion catalysis during the nighttime. This study establishes that the metal components in mineral dust promote heterogeneous sulfate formation, quantifies the yield of sulfate generated as a result, and provides possible mechanisms for heterogeneous sulfate formation.

Multi-timescale variation characteristics of PM2.5 in different regions of China during 2014-2022

Over the past decade, China has achieved a significant reduction in PM2.5 concentrations. Due to the diversity of natural and artificial factors, regional differences are remarkable in the variation characteristics and have not been well addressed in previous studies. Based on hourly observed PM2.5 concentrations from 2014 to 2022, this study conducted a comprehensive analysis of variation characteristics on annual, seasonal, and diurnal scales, with a special focus on differences across major regions. Driving factors of the variations, the effectiveness of air pollution control efforts as well as future priorities were discussed. The annual PM2.5 concentrations in all regions showed an overall downward trend from 2014 to 2022, but the decline rates differed notably across the regions, with the maximum value nearly two times higher than the minimum value. The seasonal decline rates also differ from region to region, which could be partially attributed to the burning of crop residues and dust events. Northeast China was significantly affected by the burning of crop residues and experienced a big drop in the number of fire points in autumn, but a remarkable increase in spring. The spring dust events may greatly contribute to PM2.5 concentrations in northern and western China. For diurnal variation, nighttime concentrations were generally greater than daytime concentrations, and the nighttime concentrations were likely to increase in eastern regions and decrease in western regions. Furthermore, the daytime and nighttime ratios (calculated by daytime/nighttime concentration divided by the daily-mean concentration) exhibited different interannual trends, with the daytime ratios decreasing and nighttime ratios increasing, especially in the northeastern and western regions. The findings indicate that the air pollution control efforts have been generally successful, but with large regional disparities, and highlight the importance of controlling crop residue burning, dust events, and nighttime emissions for specific seasons and regions.

Key toxic components and sources affecting oxidative potential of atmospheric particulate matter using interpretable machine learning: Insights from fog episodes

Fog significantly affects the air quality and human health. To investigate the health effects and mechanisms of atmospheric fine particulate matter (PM2.5) during fog episodes, PM2.5 samples were collected from the coastal suburb of Qingdao during different seasons from 2021 to 2022, with the major chemical composition in PM2.5 analyzed. The oxidative potential (OP) of PM2.5 was determined using the dithiothreitol (DTT) method. A positive matrix factorization model was adopted for PM2.5. Interpretable machine learning (IML) was used to reveal and quantify the key components and sources affecting OP. PM2.5 exhibited higher oxidative toxicity during fog episodes. Water-soluble organic carbon (WSOC), NH4+, K+, and water-soluble Fe positively affected the enhancement of DTTV (volume-based DTT activity) during fog episodes. The IML analysis demonstrated that WSOC and K+ contributed significantly to DTTV, with values of 0.31 ± 0.34 and 0.27 ± 0.22 nmol min-1 m-3, respectively. Regarding the sources, coal combustion and biomass burning contributed significantly to DTTV (0.40 ± 0.38 and 0.39 ± 0.36 nmol min-1 m-3, respectively), indicating the significant influence of combustion-related sources on OP. This study provides new insights into the effects of PM2.5 compositions and sources on OP by applying IML models.

Characteristics and health risk assessment of indoor and outdoor PM2.5 in a rural village, in Northeast of China: impact of coal and biomass burning

Fine particulate matter (PM2.5) has health effects that may depend on its sources and chemical composition. In this study, characteristics of PM2.5 chemical composition and health risk assessment from Songyuan, China, were investigated during day and night in indoor and outdoor from February 4 to 19, 2021. Relative high concentrations of PM2.5 were obtained in indoor environment than outdoor, with 503.95 ± 209.62 μg/m3 during the day and 357.52 ± 232.81 μg/m3 at night for the indoor environment. Relatively high total carbon, organic carbons, elemental carbons, polycyclic aromatic hydrocarbons (PAHs), and oxygenated polycyclic aromatic hydrocarbons (OPAHs) were obtained in indoor environment. However, the average concentrations of PAHs were higher during night (73.57 ± 43.09 ng/m3) in indoor and OPAHs during day (6.027 ± 2.960 ng/m3) in outdoor. They had different I/O distributions of these compounds during day and night. Indeno(1,2,3-cd) pyrene was the dominant PAHs, and benzanthrone was the dominant OPAHs; this is different with the previous studies. The high indoor/outdoor ratios showed the indoor coal and biomass burning greatly affect the indoor pollutants. Average ILCR health risk assessment for PAHs was all higher than 10-6 for different age gender, suggesting there has potential cancer risk existed for populations living in the rural coal and biomass burning area Songyuan, China.

Characteristics and sources of carbonaceous aerosols in a semi-arid city: Quantifying anthropogenic and meteorological impacts

Carbonaceous aerosols have great adverse impacts on air quality, human health, and climate. However, there is a limited understanding of carbonaceous aerosols in semi-arid areas. The correlation between carbonaceous aerosols and control measures is still unclear owing to the insufficient information regarding meteorological contribution. To reveal the complex relationship between control measures and carbonaceous aerosols, offline and online observations of carbonaceous aerosols were conducted from October 8, 2019 to October 7, 2020 in Hohhot, a semi-arid city. The characteristics and sources of carbonaceous aerosols and impacts of anthropogenic emissions and meteorological conditions were studied. The annual mean concentrations (± standard deviation) of fine particulate matter (PM_2.5), organic carbon (OC), and elemental carbon (EC) were 42.81 (±40.13), 7.57 (±6.43), and 2.25 (±1.39) μg m^-3, respectively. The highest PM_2.5 and carbonaceous aerosol concentrations were observed in winter, whereas the lowest was observed in summer. The result indicated that coal combustion for heating had a critical role in air quality degradation in Hohhot. A boost regression tree model was applied to quantify the impacts of anthropogenic emissions and meteorological conditions on carbonaceous aerosols. The results suggested that the anthropogenic contributions of PM_2.5, OC, and EC during the COVID-19 lockdown period were 53.0, 15.0, and 2.36 μg m^-3, respectively, while the meteorological contributions were 5.38, 2.49, and -0.62 μg m^-3, respectively. Secondary formation caused by unfavorable meteorological conditions offset the emission reduction during the COVID-19 lockdown period. Coal combustion (46.4% for OC and 35.4% for EC) and vehicular emissions (32.0% for OC and 50.4% for EC) were the predominant contributors of carbonaceous aerosols. The result indicated that Hohhot must regulate coal use and vehicle emissions to reduce carbonaceous aerosol pollution. This study provides new insights and a comprehensive understanding of the complex relationships between control strategies, meteorological conditions, and air quality.