Preparation of seaweed polysaccharide based hydrophobic composite membranes for the separation of oil/water emulsion and protein

Characterization of a chlorine resistant and hydrophilic TiO2/calcium alginate hydrogel filtration membrane used for protein purification maintaining protein structure

The development of membranes for protein purification has stringent requirement of disinfection resistance, low protein adsorption and anti-fouling, without changing protein structure. In this study, hydrophilic titanium dioxide (TiO2)/calcium alginate (TiO2/CaAlg) hydrogel membranes were prepared by a simple ionic cross-linking method. The effects of the porogenic agent polyethylene glycol (PEG) concentration, the molecular weight of PEG, and the concentration of TiO2 on the filtration properties were systematically investigated. The TiO2/CaAlg membrane exhibited excellent bovine serum albumin (BSA) rejection and anti-fouling properties. The mechanical properties and surface energy of the TiO2/CaAlg membrane were significantly improved. The chemical bonding mechanism of TiO2 and NaAlg was investigated by molecular dynamic simulation. The TiO2/CaAlg membrane had good chlorine resistance and could be disinfected or cleaned with sodium hypochlorite. The TiO2/CaAlg hydrogel membrane loaded with polyhydroxybutyrate (PHB) nanofibers maintained high flux (136.7 L/m2h) and high BSA rejection (98.0 %) at 0.1 MPa. The results of circular dichroism and synchronous fluorescence indicated that the secondary structure of BSA was maintained after membrane separation. This study provides one method for the preparation of green and environmentally friendly membrane for protein purification.

Nanoparticle-Embedded Polymers and Their Applications: A Review

There has been increasing interest in the study and development of nanoparticle-embedded polymeric materials and their applications to special membranes. Nanoparticle-embedded polymeric materials have been observed to have a desirable compatibility with commonly used membrane matrices, a wide range of functionalities, and tunable physicochemical properties. The development of nanoparticle-embedded polymeric materials has shown great potential to overcome the longstanding challenges faced by the membrane separation industry. One major challenge that has been a bottleneck to the progress and use of membranes is the balance between the selectivity and the permeability of the membranes. Recent developments in the fabrication of nanoparticle-embedded polymeric materials have focused on how to further tune the properties of the nanoparticles and membranes to improve the performance of the membranes even further. Techniques for improving the performance of nanoparticle-embedded membranes by exploiting their surface characteristics and internal pore and channel structures to a significant degree have been incorporated into the fabrication processes. Several fabrication techniques are discussed in this paper and used to produce both mixed-matrix membranes and homogenous nanoparticle-embedded polymeric materials. The discussed fabrication techniques include interfacial polymerization, self-assembly, surface coating, and phase inversion. With the current interest shown in the field of nanoparticle-embedded polymeric materials, it is expected that better-performing membranes will be developed soon.

A Novel Approach for the Development of Low-Cost Polymeric Thin-Film Nanocomposite Membranes for the Biomacromolecule Separation

The separation of biomacromolecules, mainly proteins, plays a significant role in the pharmaceutical and food industries. Among the membranes' techniques, thin-film nanocomposite nanofiltration membranes are the best choice due to their high energy efficiency, excellent productivity, cost-effective and tuneable properties that have captured the attention of the efficient separation of biomacromolecules, especially from the industrial perspective. The present work directs the efficient separation study of proteins, namely, lysozyme, trypsin, pepsin, bovine serum albumin (BSA), and cephalexin, using a thin-film nanocomposite membrane integrated with Arg-MMT (arginine-montmorillonite) clay nanoparticles. The surface morphology and cross-section images of the TFN membranes were studied using a field emission scanning electron microscope (FE-SEM) and a high-resolution transmission electron microscope (HR-TEM). The thermal stability and hydrophilicity of the membranes were examined using thermogravimetric analysis (TGA) and contact angle, respectively. The surface chemistry of the selective layer has different functional groups that were analyzed using FTIR spectroscopy. The performance of the membranes was studied at different trans-membrane pressures and permeation times. The effect of monomer concentration on the separation performance of the membranes was also studied at different permeation times. The membranes' antibacterial activity was evaluated using the Muller-Hinton disk diffusion method using gram-negative Escherichia coli (E. coli) and gram-positive Staphylococcus aureus (S. aureus) bacteria. The highest rejection was achieved for BSA up to 98.92 ± 1%, and the highest permeation was obtained against lysozyme feed solution up to 26 L m^-2 h^-1 at 5 bar pressure. The membrane also illustrated excellent rejection of cephalexin antibiotics with a rejection of 98.17 ± 1.75% and a permeation flux of 26.14 L m^-2 h^-1. The antifouling study performed for the membranes exhibited a flux recovery ratio of 86.48%. The fabricated thin-film nanocomposite membrane demonstrated a good alternative for the separation of biomacromolecules and has the potential to be used in different sectors of industry, especially the pharmaceutical and food industry.

A bioinspired, strong, all-natural, superhydrophobic cellulose-based straw

The promotion of cellulose-based paper straws is one of the important ways to improve white pollution nowadays. However, developing composite straws that are simultaneously highly biocompatible, safe, and non-toxic and that overcome the low water stability and physical strength problems caused by the inherent hydrophilicity of the raw material cellulose has become an important challenge in the development process. In this study, a new all-natural superhydrophobic straw (CFS) made of a composite of cellulose nanofibers and stearic acid was introduced. Stearic acid is a saturated fatty acid derived from plant and animal oils. Inspired by the specific hydrophobicity of sugarcane cane peel, a green straw with both superhydrophobicity (water contact angle up to 153°) and remarkable mechanical strength (tensile strength up to 67.15 MPa) was developed by controlling the hydrophobic modification conditions of stearic acid through solvent vaporization. Furthermore, the composite straws under wet conditions had lower water absorption and exhibited excellent wet tensile strength compared to commercial paper straws. In addition, the composite straw without the addition of chemical binders avoids the defects of non-renewable products, fits into the global green development concept, and brings new strategies for the development of cellulose-based materials.