Turning an invasive alien species into a valuable biomass: Anaerobic digestion of Rugulopteryx okamurae after thermal and new developed low-cost mechanical pretreatments

Evaluation of batch mesophilic anaerobic digestion of waste Euro banknotes for methane Production: Preliminary studies and kinetic approach

The European Central Bank is striving to find environmentally friendly alternative methods of waste disposal. In 2020, it decided to end the disposal of Waste Euro Banknotes (W€B) in landfills and planned to use them for recycling and/or energy recovery. Despite being recognized as an effective tool in a circular economy model, there are no reported studies on the use of W€B as a substrate in anaerobic digestion (AD). Thus, the aim of this research was to assess the viability of W€B to be converted into high-value-added energy products (mainly methane) through AD. W€B (€10 and €20 denominations) provided by the Bank of Spain were used. Biochemical methane potential (BMP) tests of pre-treated (grinded) and untreated W€B were assessed at mesophilic temperature. The ultimate methane yield was considerably higher for pre-treated W€B (334 ± 23 NmL CH4 g VS-1added) than for untreated W€B (297 ± 14 NmL CH4 g VS-1added). The Logistic or Sigmoidal kinetic model adequately fit the experimental data and allowed for obtaining the kinetic parameters of each case studied. In this sense, an increase of 22.4 % in the maximum methane production rate (Rmax) was observed for the pre-treated W€B (52.5 ± 0.9 mL CH4 (g VS·d)-1 compared to the untreated W€B (16.2 ± 1.8 mL CH4 (g VS·d)-1). According to the obtained results, AD may be a good alternative for the energetic valorization and recycling of W€B.

Impact of natural degradation of the invasive alga Rugulopteryx okamurae on anaerobic digestion: Heavy metal pollution and kinetic performance

This study shows, for the first time, how the natural biodegradation of the Phaeophyceae Rugulopteryx okamurae (R.o.) affects its methane yield, by biochemical methane potential assays, and the methane production kinetics. Additionally, a mechanical (zeolite-assisted milling) and a thermal (120 °C, 45 min) pretreatments were assessed. The highest methane yield was obtained from the mechanically pretreated fresh ashore biomass (219 (15) NLCH4 kgVS-1), which presents the use of zeolite during milling as an economical alternative for heavy metal toxicity reduction. Moreover, no significant differences were observed between the other tests (with the exception of the lowest value obtained for the mechanically pretreated fresh R.o.). Low methane yields were linked to the heavy metal content. However, an increase of 28.5 % and 20.0 % in the k value was found for the untreated fresh R.o. biomass and fresh ashore biomass, respectively, when subjected to thermal pretreatment. Finally, an enhancement of 80.5 % in the maximum methane production rate was obtained for the fresh ashore biomass milled with zeolite compared to the untreated fresh ashore biomass.

Microwave-Assisted Hydrothermal Processing of Rugulopteryx okamurae

One possible scheme of Rugulopteryx okamurae biomass valorization based on a green, rapid and efficient fractionation technique was proposed. Microwave-assisted pressurized hot water extraction was the technology selected as the initial stage for the solubilization of different seaweed components. Operation at 180 °C for 10 min with a 30 liquid-to-solid ratio solubilized more than 40% of the initial material. Both the alginate recovery yield (3.2%) and the phenolic content of the water-soluble extracts (2.3%) were slightly higher when distilled water was used as solvent. However, the carbohydrate content in the extract (60%) was similar for both solvents, but the sulfate content was higher for samples processed with salt water collected from the same coast as the seaweeds. The antiradical capacity of the extracts was related to the phenolic content in the extracts, but the cytotoxicity towards HeLa229 cancer cells was highest (EC50 = 48 µg/mL) for the extract obtained with distilled water at the lowest temperature evaluated. Operation time showed a relevant enhancement of the extraction performance and bioactive properties of the soluble extracts. The further fractionation and study of this extract would be recommended to extend its potential applications. However, due to the low extraction yield, emphasis was given to the solid residue, which showed a heating value in the range 16,102-18,413 kJ/kg and could be useful for the preparation of biomaterials according to its rheological properties.