Tuning the type of nitrogen on N-RGO supported on N-TiO2 under ultrasonication/hydrothermal treatment for efficient hydrogen evolution - A mechanistic overview

Atomic Insights into the Relationship between Molecular Structure and Dispersion Performance of Phenyl Polymer on Graphene Oxide

The adsorption of organic polymers onto the surface of graphene oxide is known to improve its dispersibility in cement-based materials. However, the mechanism of this improvement at the atomic level is not yet fully understood. In this study, we employ a combination of DFT static calculation and umbrella sampling to explore the reactivity of polymers and investigate the effects of varying amounts of phenyl groups on their adsorption capacity on the surface of graphene oxide. Quantitative analysis is utilized to study the structural reconstruction and charge transfer caused by polymers from multiple perspectives. The interfacial reaction between the polymer and graphene oxide surface is further clarified, indicating that the adsorption process is promoted by hydrogen bond interactions and π-π stacking effects. This study sheds light on the adsorption mechanism of polymer-graphene oxide systems and has important implications for the design of more effective graphene oxide dispersants at the atomic level.

Photocatalytic Reduction of CO2 with N-Doped TiO2-Based Photocatalysts Obtained in One-Pot Supercritical Synthesis

The objective of this work was to analyze the effect of carbon support on the activity and selectivity of N-doped TiO₂ nanoparticles. Thus, N-doped TiO₂ and two types of composites, N-doped TiO₂/CNT and N-doped TiO₂/rGO, were prepared by a new environmentally friendly one-pot method. CNT and rGO were used as supports, triethylamine and urea as N doping agents, and titanium (IV) tetraisopropoxide and ethanol as Ti precursor and hydrolysis agent, respectively. The as-prepared photocatalysts exhibited enhanced photocatalytic performance compared to TiO₂ P25 commercial catalyst during the photoreduction of CO₂ with water vapor. It was imputed to the synergistic effect of N doping (reduction of semiconductor band gap energy) and carbon support (enlarging e⁻-h⁺ recombination time). The activity and selectivity of catalysts varied depending on the investigated material. Thus, whereas N-doped TiO₂ nanoparticles led to a gaseous mixture, where CH₄ formed the majority compared to CO, N-doped TiO₂/CNT and N-doped TiO₂/rGO composites almost exclusively generated CO. Regarding the activity of the catalysts, the highest production rates of CO (8 µmol/gTiO₂/h) and CH₄ (4 µmol/gTiO₂/h) were achieved with composite N¹/TiO₂/rGO and N¹/TiO₂ nanoparticles, respectively, where superscript represents the ratio mg N/g TiO₂. These rates are four times and almost forty times higher than the CO and CH₄ production rates observed with commercial TiO₂ P25.

Ultrasonic-assisted hydrothermal synthesis of cobalt oxide/nitrogen-doped graphene oxide hybrid as oxygen reduction reaction catalyst for Al-air battery

A persistent ultrasound-assisted hydrothermal method has been developed to prepare cobalt oxide incorporated nitrogen-doped graphene (Co₃O₄/N-GO) hybrids. The electrochemical behaviors and catalytic activity of the prepared hybrids have been systematically investigated as cathode materials for Al-air battery. The results show that ultrasonication can promote the yield ratio of Co₃O₄ from 63.1% to 70.6%. The prepared Co₃O₄/N-GO hybrid with ultrasonication exhibits better ORR activity over that without ultrasonication. The assembled Al-air battery using the ultrasonicated Co₃O₄/N-GO hybrid exhibited an average working voltage of 1.02 V in 4 M KOH electrolyte at 60 mA∙cm^-2, approximately 60 mV higher than that using hybrid without ultrasonication. This should be attributed to large number density of fine Co₃O₄ particles growing on the dispersed GO sheets under the persistent ultrasonication. The related ultrasonic mechanism has been discussed in details.