Self-Driven Reactive Oxygen Species Generation via Interfacial Oxygen Vacancies on Carbon-Coated TiO2-x with Versatile Applications

Oxygen-deficient TiO2-x interlayer enabling Li-rich Mn-based layered oxide cathodes with enhanced reversible capacity and cyclability

The unique anion redox mechanism of Li-rich Mn-based layered oxide (LMLO) cathodes endows them with a higher specific capacity compared with conventional cathodes. However, the irreversible anion redox reactions can cause structural degradation and sluggish electrochemical kinetics in the cathode, resulting in a poor electrochemical performance in the batteries. Thus, to address these issues, a single-sided conductive oxygen-deficient TiO_2-x interlayer was applied on a commercial Celgard separator as a coating layer towards the LMLO cathode. After coating TiO_2-x, the initial coulombic efficiency (ICE) of the cathode increased from 92.1% to 95.8%, the capacity retention improved from 84.2% to 91.7% after 100 cycles, and the rate performance of the cathode was significantly enhanced from 91.3 mA h g^-1 to 203.9 mA h g^-1 at 5C. Operando differential electrochemical mass spectroscopy (DEMS) showed that the coating layer could restrain the release of oxygen in the battery, especially from the initial formation process. The X-ray photoelectron spectroscopy (XPS) results demonstrated that the favorable oxygen absorption by the TiO_2-x interlayer benefitted the suppression of side reactions and cathode structural evolution and favored the formation of a uniform cathode-electrolyte interphase on the LMLO cathode. This work provides an alternative path to address the issue of oxygen release in LMLO cathodes.

Interface catalytic regulation via electron rearrangement and hydroxyl radicals triggered by oxygen vacancies and heavy metal ions

Although the enhanced intrinsic activities of some nano-metal oxides are obtained by manufacturing oxygen vacancies (OVs), the effect of multiple roles of OVs is ambiguous. Herein, an interface catalytic regulation via electron rearrangement and hydroxyl radicals (˙OH) was proposed with the designed ZrO₂ hollow sphere rich in OVs (V_o-rich ZrO₂). Surprisingly, it was shown that the catalytic ability of V_o-rich ZrO₂ was 9.9 times higher than that of ZrO₂ with little OVs in electrochemical catalytic reduction of Pb(ii). It was found that the generation of Zr²⁺ and Zr³⁺ caused by OVs results in the rearrangement of abundant free electrons to facilitate the catalytic reaction rates. The longer bond length between V_o-rich ZrO₂ and reactants, and the lower adsorption energy are beneficial for reactants to desorb, improving the conversion rates. Besides, the produced ˙OH were captured which were induced by OVs and trace divalent heavy metal ions in in situ electron paramagnetic resonance (EPR) experiments, contributing to lowering the energy barriers. This study not only revealed the enhanced interface catalytic effect of electron rearrangement and generated ˙OH triggered by OVs, but also provided unique insights into interface catalytic regulation on nano-metal oxides simulated by OVs.

Incorporation of Cu into Goethite Stimulates Oxygen Activation by Surface-Bound Fe(II) for Enhanced As(III) Oxidative Transformation

The dark production of reactive oxygen species (ROS) coupled to biogeochemical cycling of iron (Fe) plays a pivotal role in controlling arsenic transformation and detoxification. However, the effect of secondary atom incorporation into Fe(III) oxyhydroxides on this process is poorly understood. Here, we show that the presence of oxygen vacancy (OV) as a result of Cu incorporation in goethite substantially enhances the As(III) oxidation by Fe(II) under oxic conditions. Electrochemical and density functional theory (DFT) evidence reveals that the electron transfer (ET) rate constant is enhanced from 0.023 to 0.197 s^-1, improving the electron efficiency of the surface-bound Fe(II) on OV defective surfaces. The cascade charge transfer from the surface-bound Fe(II) to O₂ mediated by Fe(III) oxyhydroxides leads to the O-O bond of O₂ stretching to 1.46-1.48 Å equivalent to that of superoxide (^•O₂^-), and ^•O₂^- is the predominant ROS responsible for As(III) oxidation. Our findings highlight the significant role of atom incorporation in changing the ET process on Fe(III) oxyhydroxides for ROS production. Thus, such an effect must be considered when evaluating Fe mineral reactivity toward changing their surface chemistry, such as those noted here for Cu incorporation, which likely determines the fates of arsenic and other redox sensitive pollutants in the environments with oscillating redox conditions.

Oxygen Vacancy-Mediated Activates Oxygen to Produce Reactive Oxygen Species (ROS) on Ce-Modified Activated Clay for Degradation of Organic Compounds without Hydrogen Peroxide in Strong Acid

The treatment of acid wastewater to remove organic matter in acid wastewater and recycle valuable resources has great significance. However, the classical advanced oxidation process (AOPs), such as the Fenton reaction, encountered a bottleneck under the conditions of strong acid. Herein, making use of the oxidation properties of CeAY (CeO₂@acid clay), we built an AOPs reaction system without H₂O₂ under a strong acid condition that can realize the transformation of organic matter in industrial wastewater. The X-ray photoelectron spectroscopy (XPS) proved that the CeAY based on Ce³⁺ as an active center has abundant oxygen vacancies, which can catalyze O₂ to produce reactive oxygen species (ROS). Based on the electron spin-resonance spectroscopy spectrum and radical trapping experiments, the production of •O₂^- and •OH can be determined, which are the essential factors of the degradation of organic compounds. In the system of pH = 1.0, when 1 mg CeAY is added to 10 mL of wastewater, the degradation efficiency of an aniline solution with a 5 mg/L effluent concentration is 100%, and that of a benzoic acid solution with a 100 mg/L effluent concentration is 50% after 10 min of reaction. This work may provide novel insights into the removal of organic pollutants in a strong acid water matrix.

Antiviral efficacy of cerium oxide nanoparticles

Nanomaterials are prospective candidates for the elimination of viruses due to their multimodal mechanisms of action. Here, we tested the antiviral potential of a largely unexplored nanoparticle of cerium dioxide (CeO₂). Two nano-CeO₂ with opposing surface charge, (+) and (-), were assessed for their capability to decrease the plaque forming units (PFU) of four enveloped and two non-enveloped viruses during 1-h exposure. Statistically significant antiviral activity towards enveloped coronavirus SARS-CoV-2 and influenza virus was registered already at 20 mg Ce/l. For other two enveloped viruses, transmissible gastroenteritis virus and bacteriophage φ6, antiviral activity was evidenced at 200 mg Ce/l. As expected, the sensitivity of non-enveloped viruses towards nano-CeO₂ was significantly lower. EMCV picornavirus showed no decrease in PFU until the highest tested concentration, 2000 mg Ce/l and MS2 bacteriophage showed slight non-monotonic response to high concentrations of nano-CeO₂(-). Parallel testing of antiviral activity of Ce³⁺ ions and SiO₂ nanoparticles allows to conclude that nano-CeO₂ activity was neither due to released Ce-ions nor nonspecific effects of nanoparticulates. Moreover, we evidenced higher antiviral efficacy of nano-CeO₂ compared with Ag nanoparticles. This result along with low antibacterial activity and non-existent cytotoxicity of nano-CeO₂ allow us to propose CeO₂ nanoparticles for specific antiviral applications.

A Graphene Acid - TiO2 Nanohybrid as Multifunctional Heterogeneous Photocatalyst for the Synthesis of 1,3,4-Oxadiazoles

The immobilization of TiO₂ nanoparticles on graphene acid (GA), a conductive graphene derivative densely functionalized with COOH groups, is presented. The interaction between the carboxyl groups of the surface and the titanium precursor leads to a controlled TiO₂ heterogenization on the nanosheet according to microscopic and spectroscopic characterizations. Electronic communication shared among graphene and semiconductor nanoparticles shifts the hybrid material optical features toward less energetic radiation but maintaining the conductivity. Therefore, GA-TiO₂ is employed as heterogeneous photocatalyst for the synthesis of 2,5-disubstituted 1,3,4-oxadiazoles using ketoacids and hydrazides as substrates. The material presented enhanced photoactivity compared to bare TiO₂, being able to yield a large structural variety of oxadiazoles in reaction times as fast as 1 h with full recyclability and stability. The carbocatalytic character of GA is the responsible for the substrates condensation and the GA-TiO₂ light interaction ability is able to photocatalyze the cyclization to the final 1,3,4-oxadiazoles, demonstrating the optimal performance of this multifunctional photocatalytic material.

Catalytic Oxygen Activation over the Defective CuO Nanoparticles for Ultrafast Dehalogenation

The nucleophilic superoxide radical (O₂^•-)-based dehalogenation reaction shows great potential to degrade the toxic halogenated organic compounds (HOCs). But such an O₂^•--mediated reductive reaction often suffers from the competition of the secondary oxidative species (e.g., •OH), leading to inferior electron efficiency and possible disinfection byproduct formation. Here, an O₂^•--dominant ultrafast dehalogenation system is developed via molecular O₂ activation by the oxygen vacancy (OV)-rich CuO nanoparticles (nCuO). The nCuO delivers a remarkable dechlorination rate constant of 3.92 × 10^-2 L min^-1 m^-2 for 2,4-dichlorophenol, much higher than that of the conventional zerovalent (bi)metals. The absorbed O₂ on the nCuO surface is exclusively responsible for O₂^•- generation, and its reactivity increases with the elevated OV content because of the enhanced orbital hybridization between the O p- and Cu d-orbitals. More importantly, the ubiquitous carbonate species firmly bound to the surface OVs block the formation of the secondary oxidative species via H₂O₂ activation, assuring the dominant role of the in situ generated O₂^•- for the selective HOC dehalogenation. The carbonate-deactivated OVs of the nCuO can be feasibly recovered via air annealing for sustainable dehalogenation. This work provides a new opportunity for selective O₂^•- generation via interfacial defect engineering for dehalogenation and other environmental applications.

Nanostructured Surfaces with Multimodal Antimicrobial Action

Self-disinfecting surfaces are a current pressing need for public health and safety in view of the current COVID-19 pandemic, where the keenly felt worldwide repercussions have highlighted the importance of infection control, frequent disinfection, and proper hygiene. Because of its potential impact upon real-world translation into downstream applications, there has been much research interest in multiple disciplines such as materials science, chemistry, biology, and engineering. Various antimicrobial technologies have been developed and currently applied on surfaces in public spaces, such as elevator buttons and escalator handrails. These technologies are mainly based on conventional methods of grafting quaternary ammonium salts (QACs) such as benzalkonium chloride or the immobilization of metal species of silver or copper. However, neither the long-term efficacy nor the fast-killing properties have been proven, and the future repercussions from extended use, such as environmental hazards and the induction of MDR development, is unknown. Nanostructured surfaces with excellent antimicrobial activities have been claimed to be the next generation of self-disinfecting surfaces with various promising applications and passive antimicrobial mechanisms, without the potential repercussions of active ingredient overuse. In this Account, we briefly introduce the concept of mechanobactericidal action realized by these nanostructured surfaces first discovered on cicada wings. The elimination of microbes on the surface was actualized by the physical rupture of the microbe cell wall by nanoprotusions, without any involvement of chemical species. By mimicking the physical features of naturally occurring biocidal surfaces, the fabrication of nanostructures on various substrates such as titania, silicon, and polymers has been well described. Observations of the dependence of their antimicrobial efficacy on physical characteristics such as height, density, and rigidity have also been documented. However, the complex fabrication of such nanostructures remains the main drawback preventing its widespread application. We outline our efforts in fabricating a series of zinc-based nanostructured materials with facile and generally applicable wet chemistry methods, including nanodaggered zeolitic imidazolate frameworks (ZIF-L) and ZnO nanoneedles. In our investigations, we discovered that there were additional modes of action that contributed to the excellent biocidal activities of our materials. The impact of surface chemistry and charge was partially responsible for the selectivity and efficacy of ZIF-L-coated surfaces, where the positively charged surfaces were able to attract and adhere negatively charged bacteria to the surface. The combination of semiconductor ZnO nanoneedles on electron-donating substrates allowed for the generation of reactive oxygen species (ROS), realizing the remote killing of bacteria unadhered to the nanostructured surface. Additionally, we demonstrate several real-life applications of the synthesized materials, underscoring the importance of materials development suited for scale-up and eventual translation to potential applications and commercial end products.

Introducing Oxygen Vacancies in Li4Ti5O12 via Hydrogen Reduction for High-Power Lithium-Ion Batteries

Li4Ti5O12 (LTO), known as a zero-strain material, is widely studied as the anode material for lithium-ion batteries owing to its high safety and long cycling stability. However, its low electronic conductivity and Li diffusion coefficient significantly deteriorate its high-rate performance. In this work, we proposed a facile approach to introduce oxygen vacancies into the commercialized LTO via thermal treatment under Ar/H2 (5%). The oxygen vacancy-containing LTO demonstrates much better performance than the sample before H2 treatment, especially at high current rates. Density functional theory calculation results suggest that increasing oxygen vacancy concentration could enhance the electronic conductivity and lower the diffusion barrier of Li+, giving rise to a fast electrochemical kinetic process and thus improved high-rate performance.

Efficiently selective oxidation of glycerol by BiQDs/BiOBr–Ov: promotion of molecular oxygen activation by Bi quantum dots and oxygen vacancies

Bi_QDs and O_v can promote the activation of O₂ to make Bi_QDs/BiOBr–O_v catalyze the selective oxidation of glycerol efficiently.