Activating Surface Lattice Oxygen of a Cu/Zn1-xCuxO Catalyst through Interface Interactions for CO Oxidation

Insights into the underpinning effect of graphene in Cu1Mn10 on enhancing the low-temperature catalytic activity for CO oxidation

CO emission is a critical issue of industrial processes such as steel-smelting, cement manufacturing, and waste incineration. Catalytic oxidation based on Cu-Mn binary catalysts shows great potential for efficient removal of CO, whereas their practical applicability is limited by the inferior low-temperature catalytic activity and the high catalyst cost owing to a substantial quantity of Cu. In this study, doping graphene is designed to adjust the electron transfer capability to improve the low-temperature catalytic activity as well as reduce the amount of Cu, and thereby Cu1Mn10 catalysts doped with slight amounts of graphene (x%G-Cu1Mn10, x is 1∼5) were fabricated. It was found that the introduction of graphene could form effective electron transport channels to enhance the intermetallic interaction and oxygen vacancy generation, thus improving the low-temperature catalytic performance of the Cu1Mn10 catalyst. Among all the catalysts, 4%G-Cu1Mn10 exhibited the highest activity, achieving CO conversion of 92% at 110 °C at a weight hourly space velocity of 120,000 mL/(g∙h). The introduction of graphene also enabled the catalyst with excellent catalytic activity and stability at a relative humidity of 70%. Attractively, 4%G-Cu1Mn10 can be further loaded into the polyester fabric, presenting great application potentials in the effective elimination of CO during the dust removal process since the flue gas temperature in the dust collector is just around the T90% and the catalyst that is inside of fabric fiber rather than on the fabric surface can be rarely influenced by the dust. In general, doping graphene provides a facile method to enhance the low-temperature activities of the Cu-Mn binary catalysts and cut down the use of valuable Cu, showing great application potential.

The interplay between selective etching induced cation defects and active oxygen species for volatile organic compounds degradation

Surface electronic structure of transition metal oxides plays a vital role in determining the catalytic performance. Herein, we present a selective etching strategy to tune the surface cation defect of the CuWO₄ (CW) catalyst for improving the catalytic activity of volatile organic compounds (VOCs). HRTEM, SEM-EDS, EPR, and XPS show that the chelation of metal ions in acetic acid and ammonium hydroxide can help to remove a small number of surface cations in CW to form suitable W defects. Cu L-edge and O K-edge XAS, Raman, and O 1s XPS spectrum illustrate that cation defects can improve the hybrid orbits of metal-oxygen bonds, which increases the activity of surface lattice oxygen and metal sites. In-situ DRIFTS spectra reveal that CW with cation defects can easily adsorb toluene, cleave and oxidize benzene ring, and desorb CO₂ because of more surface dangling bonds and active oxygen species. Therefore, the toluene conversion rates of CW-Aci and CW-Alk are much higher than CW in VOCs degradation and the catalytic performance improved 33 times and 22 times at 200 °C, respectively. This study offers a new pathway in engineering surface electronic structure and highlights the interplay between cation defects and active oxygen species.