Flow of anisometric particles in a quasi-two-dimensional hopper

Elongated particles discharged with a conveyor belt in a two-dimensional silo

The flow of elliptical particles out of a two-dimensional silo when extracted with a conveyor belt is analyzed experimentally. The conveyor belt-placed directly below the silo outlet-reduces the flow rate, increases the size of the stagnant zone, and it has a very strong influence on the relative velocity fluctuations as they strongly increase everywhere in the silo with decreasing belt speed. In other words, instead of slower but smooth flow, flow reduction by belt leads to intermittent flow. Interestingly, we show that this intermittency correlates with a strong reduction of the orientational order of the particles at the orifice region. Moreover, we observe that the average orientation of the grains passing through the outlet is modified when they are extracted with the belt, a feature that becomes more evident for large orifices.

Discharge of elongated grains from silo with rotating bottom

We study the flow of elongated grains (wooden pegs of length L=20 mm with circular cross section of diameter d_{c}=6 and 8 mm) from a silo with a rotating bottom and a circular orifice of diameter D. In the small orifice range (D/d<5) clogs are mostly broken by the rotating base, and the flow is intermittent with avalanches and temporary clogs. Here d≡(3/2d_{c}^{2}L)^{1/3} is the effective grain diameter. Unlike for spherical grains, for rods the flow rate W clearly deviates from the power law dependence W∝(D-kd)^{2.5} at lower orifice sizes in the intermittent regime, where W is measured in between temporary clogs only. Instead, below about D/d<3 an exponential dependence W∝e^{κD} is detected. Here k and κ are constants of order unity. Even more importantly, rotating the silo base leads to a strong-more than 50%-decrease of the flow rate, which otherwise does not depend significantly on the value of ω in the continuous flow regime. In the intermittent regime, W(ω) appears to follow a nonmonotonic trend, although with considerable noise. A simple picture, in terms of the switching from funnel flow to mass flow and the alignment of the pegs due to rotation, is proposed to explain the observed difference between spherical and elongated grains. We also observe shear-induced orientational ordering of the pegs at the bottom such that their long axes in average are oriented at a small angle 〈θ〉≈15^{∘} to the motion of the bottom.

Mechanically driven active and passive grains as models for egress dynamics

Passages of people or cattle through narrow entrances or exits occur in manifold situations. They are difficult to study experimentally, because one has to carefully separate objective, physical parameters from subjective, individual motivations, manners and temperament. Mechanically excited physical model systems can help to discriminate some of these classes of parameters. We characterize active and passive particles of equal shape and mass on a vibrating plate and study their bottleneck passage dynamics. They show fundamentally different scaling behavior.

Intermittent flow and transient congestions of soft spheres passing narrow orifices

Soft, low-friction particles in silos show peculiar features during their discharge. The outflow velocity and the clogging probability both depend upon the momentary silo fill height, in sharp contrast to silos filled with hard particles. The reason is the fill-height dependence of the pressure at the orifice. We study the statistics of silo discharge of soft hydrogel spheres. The outflow is found to become increasingly fluctuating and even intermittent with decreasing orifice size, and with decreasing fill height. In orifices narrower than two particle diameters, outflow can stop completely, but in contrast to clogs formed by rigid particles, these congestions may dissolve spontaneously. We analyze such non-permanent congestions and attribute them to slow reorganization processes in the container, caused by viscoelasticity of the material.