Parallel multigrid solver of radiative transfer equation for photon transport via graphics processing unit

Quantitative photoacoustic tomography: modeling and inverse problems

Significance

Quantitative photoacoustic tomography (QPAT) exploits the photoacoustic effect with the aim of estimating images of clinically relevant quantities related to the tissue's optical absorption. The technique has two aspects: an acoustic part, where the initial acoustic pressure distribution is estimated from measured photoacoustic time-series, and an optical part, where the distributions of the optical parameters are estimated from the initial pressure.

Aim

Our study is focused on the optical part. In particular, computational modeling of light propagation (forward problem) and numerical solution methodologies of the image reconstruction (inverse problem) are discussed.

Approach

The commonly used mathematical models of how light and sound propagate in biological tissue are reviewed. A short overview of how the acoustic inverse problem is usually treated is given. The optical inverse problem and methods for its solution are reviewed. In addition, some limitations of real-life measurements and their effect on the inverse problems are discussed.

Results

An overview of QPAT with a focus on the optical part was given. Computational modeling and inverse problems of QPAT were addressed, and some key challenges were discussed. Furthermore, the developments for tackling these problems were reviewed. Although modeling of light transport is well-understood and there is a well-developed framework of inverse mathematics for approaching the inverse problem of QPAT, there are still challenges in taking these methodologies to practice.

Conclusions

Modeling and inverse problems of QPAT together were discussed. The scope was limited to the optical part, and the acoustic aspects were discussed only to the extent that they relate to the optical aspect.

Fast linear solver for radiative transport equation with multiple right hand sides in diffuse optical tomography

It is well known that radiative transfer equation (RTE) provides more accurate tomographic results than its diffusion approximation (DA). However, RTE-based tomographic reconstruction codes have limited applicability in practice due to their high computational cost. In this article, we propose a new efficient method for solving the RTE forward problem with multiple light sources in an all-at-once manner instead of solving it for each source separately. To this end, we introduce here a novel linear solver called block biconjugate gradient stabilized method (block BiCGStab) that makes full use of the shared information between different right hand sides to accelerate solution convergence. Two parallelized block BiCGStab methods are proposed for additional acceleration under limited threads situation. We evaluate the performance of this algorithm with numerical simulation studies involving the Delta-Eddington approximation to the scattering phase function. The results show that the single threading block RTE solver proposed here reduces computation time by a factor of 1.5~3 as compared to the traditional sequential solution method and the parallel block solver by a factor of 1.5 as compared to the traditional parallel sequential method. This block linear solver is, moreover, independent of discretization schemes and preconditioners used; thus further acceleration and higher accuracy can be expected when combined with other existing discretization schemes or preconditioners.

Experimental Comparison of Continuous-Wave and Frequency-Domain Fluorescence Tomography in a Commercial Multi-Modal Scanner

The performance evaluation of a variety of small animal tomography measurement approaches and algorithms for recovery of fluorescent absorption cross section has not been conducted. Herein, we employed an intensified CCD system installed in a commercial small animal CT (Computed Tomography) scanner to compare image reconstructions from time-independent, continuous wave (CW) measurements and from time-dependent, frequency domain (FD) measurements in a series of physical phantoms specifically designed for evaluation. Comparisons were performed as a function of (1) number of projections, (2) the level of preprocessing filters used to improve the signal-to-noise ratio (SNR), (3) endogenous heterogeneity of optical properties, as well as in the cases of (4) two fluorescent targets and (5) a mouse-shaped phantom. Assessment of quantitative recovery of fluorescence absorption cross section was performed using a fully parallel, regularization-free, linear reconstruction algorithm with diffusion approximation (DA) and high order simplified spherical harmonics ( SPN) approximation to the radiative transport equation (RTE). The results show that while FD measurements may result in superior image reconstructions over CW measurements, data acquisition times are significantly longer, necessitating further development of multiple detector/source configurations, improved data read-out rates, and detector technology. FD measurements with SP3 reconstructions enabled better quantitative recovery of fluorescent target strength, but required increased computational expense. Despite the developed parallel reconstruction framework being able to achieve more than 60 times speed increase over sequential implementation, further development in faster parallel acceleration strategies for near-real time and real-time image recovery and more precise forward solution is necessary.

Novel analytical solution for the radiance in an anisotropically scattering medium

We report on a novel analytical solution of the three-dimensional radiative transport equation for the case of an infinitely extended anisotropically scattering medium that is illuminated by an isotropic point light source. The resulting expression for the radiance can be evaluated efficiently and accurately and exhibits significant improvements with respect to the convergence and the numerical stability compared to the solutions found in the literature so far. The equations obtained were successfully verified by comparisons with the Monte Carlo method.