Efficacy of posterior capsular release for flexion contracture in posterior-stabilized total knee arthroplasty

Ligament Tension and Balance before and after Robotic-Assisted Total Knee Arthroplasty - Dynamic Changes with Increasing Applied Force

The optimal force applied during ligament balancing in total knee arthroplasty (TKA) is not well understood. We quantified the effect of increasing distraction force on medial and lateral gaps throughout the range of knee motion, both prior to and after femoral resections in tibial-first gap-balancing TKA. Twenty-five consecutive knees in 21 patients underwent robotic-assisted TKA. The posterior cruciate ligament was resected, and the tibia was cut neutral to the mechanical axis. A digital ligament tensioning tool recorded gaps and applied equal mediolateral loads of 70 N (baseline), 90 N, and 110 N from 90 degrees to full extension. A gap-balancing algorithm planned the femoral implant position to achieve a balanced knee throughout flexion. After femoral resections, gap measurements were repeated under the same conditions. Paired t-tests identified gap differences between load levels, medial/lateral compartments, and flexion angle. Gaps increased from 0 to 20 degrees in flexion, then remain consistent through 90 degrees of flexion. Baseline medial gap was significantly smaller than lateral gap throughout flexion (p <0.05). Increasing load had a larger effect on the lateral versus medial gaps (p <0.05) and on flexion versus extension gaps. Increasing distraction force resulted in non-linear and asymmetric gap changes mediolaterally and from flexion to extension. Digital ligament tensioning devices can give better understanding of the relationship between joint distraction, ligament tension, and knee stiffness throughout the range of flexion. This can aid in informed surgical decision making and optimal soft tissue tensioning during TKA.

Limited medial posterior capsular release increases the intraoperative medial component gap while maintaining the joint varus angle at extension in posterior-stabilized total knee arthroplasty

PURPOSE

There is a lack of robust evidence for the magnitude of the effects of posterior capsular release (PCR) on intraoperative component gaps during total knee arthroplasty (TKA). The purpose of the present study was to quantify and compare the effects of partial versus full PCR on the intraoperative component gaps at various degrees of flexion during posterior-stabilized TKA.

METHODS

Full PCR was performed on 39 consecutive cases (full PCR group), and partial PCR (the medial side up to and including the intercondylar notch) was performed on the subsequent 39 consecutive cases (partial PCR group) during posterior-stabilized TKA using the measured resection technique for varus knee osteoarthritis. Medial component gaps and varus angles at 0°, 10°, 45°, 90°, and a maximum of flexion were measured with a tensor device before and after the PCR. Differences between the two groups in post-release medial component gap increase and post-release joint varus angle increase were assessed using a t test. Pre- to post-release medial component gaps and joint varus angles in each group were compared using a paired samples t test.

RESULTS

In both groups at 0° and 10° of flexion, post-release medial compartment gaps were significantly greater than pre-release gaps (all P < 0.001). At 45°, 90° and maximum flexion, the medial compartment gap increase did not exceed the minimal detectable change in either group. At 0° and 10° of flexion, there was no significant difference in post-release medial compartment gap change between the two groups. In the full PCR group, post-release joint varus angles at 0° of flexion were significantly greater than pre-release angles (P < 0.001), while there was no significant pre- and post-release difference in the partial PCR group. The change in post-release joint varus angles at 0° of flexion was significantly greater in the full PCR group than in the partial PCR group.

CONCLUSION

Both full and partial PCR show similar clinical usefulness for increasing the medial component gap at extension and reducing component gap mismatch. A partial PCR can be used to avoid increasing joint varus angles at 0° of flexion.

LEVEL OF EVIDENCE

Level 2 (prospective comparative study).

Pleiotropic Long-Term Effects of Atorvastatin on Posttraumatic Joint Contracture in a Rat Model

The antifibrotic effect of atorvastatin has already been demonstrated in several organ systems. In the present study, a rat model was used to investigate the effect of atorvastatin on posttraumatic joint contracture. Forty-eight Sprague Dawley rats were equally randomized into an atorvastatin group and a control group. After initial joint trauma, knee joints were immobilized for intervals of 2 weeks (n = 16) or 4 weeks (n = 16) or immobilized for 4 weeks with subsequent remobilization for another 4 weeks (n = 16). Starting from the day of surgery, animals received either atorvastatin or placebo daily. After euthanasia at week 2, 4 or 8, joint contracture was determined, histological examinations were performed, and gene expression was assessed. The results suggest that the joint contracture was primarily arthrogenic. Atorvastatin failed to significantly affect contracture formation and showed a reduction in myofibroblast numbers to 98 ± 58 (control: 319 ± 113, p < 0.01) and a reduction in joint capsule collagen to 60 ± 8% (control: 73 ± 9%, p < 0.05) at week 2. Gene expression of α-smooth muscle actin (α-SMA), collagen type I, transforming growth factor β1 (TGF-β1) and interleukin-6 (IL-6) was not significantly affected by atorvastatin. Atorvastatin decreases myofibroblast number and collagen deposition but does not result in an improvement in joint mobility.